Question about Mercury Cougar

2 Answers

Hiiii mr. saailer I SENT YOU AN EMAIL YESTERDAY I GUESS YOU DIDN'T GET IT; BUT HERE' IT IS AGAIN.CK YOUR NOTES ON YOUR LAST EMAIL TO ME., YOU ASKED ME TO CK VOLTAGES ON ....TPS WHT TO BRN I HAVE (.85) VOLTS THEN YELL TO BRN = (5) VOLTS .,ON THE FUEL PRESSURE REGULATOR SENSOR =WHT GN TO BRN GN =(.50) VOLTS THEN YEL GN TO BRN GN=(5)VOLTS.,,,,I DO HAVE GROUND ON THE BLK BL WIRE GOING TO THE PUMP BUT IHAVE INTERMITENT(UP /DOWN) VOLTAGE ON THE GN BLK WIRE AT THE FUEL PUMP CONTROL MODULE, I CK THIS TWO WIRES GOING DIRECTLY TO THE BAT. THE GN BLK. WIRE'S VOLTAGE IS FLUCTUATING FROM 6 TO 8 VOLTS.. I ALSO CK VOLTAGES AT THE PUMP CINNECTOR ON THE BRN YEL TO WHT BLK. WIRES I HAVE (12)V BUT THE PUMP WON'T PUMP STILL. ANDY

Posted by on

  • ANDRES MELERO Sep 16, 2010

    I ALLREADY HAD ELIMINATED THE CUT OFF SW.AS A FAULT BEFORE BY GIVING A POS.+ TO THIS SW. ON THE WIRE GOING OUT TO THE FUEL MODULE. AND LIKE I SAID BEFORE THERE'S 12 V AT THE WHT BLK--TO BRN. YELL. WIRES AT THE PUMP CONNECTOR BEFORE IT GOES INTO THE FUEL TANK BUT I DON'T HEAR A FAMILIAR CLICK FROM THE PUMP,,,ANDY

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,796 Answers

I don't know what kind of vehicle you have, but for what you are saying, I think you are concentrated in finding a 12v + problem and it could be a ground problem. Apply 12v (+ and -) to the pump and see if it works, if not, replace it.

Posted on Sep 17, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mercury Master
  • 75,822 Answers

Is the fuel pump cutoff switch reset? check to make sure u have 12 volts at the switch for 1 second when key is turned to run, check for 12 volts in and 12 volts out.

Posted on Sep 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I ask a question yesterday where can I check for the answer and when?


It goes to your Email when someone answered. Could be, no one knew, question on wrong site. You seem to know English and spell, so that's ruled out.

Nov 28, 2016 | Cars & Trucks

1 Answer

Has suzuki marine improved there paint


you are in cars and trucks with boat question, failure....
what paint we cant guess the object you are alluding to.
but Ill answer.
all paint does that, now and forever.
the sun always wins. always.
no paint on earth lasts forever,
why not go to any paint shop for RV and ask them.
or any pro vehicle paint shop.
hopefully they will not giggle most will put their SALES hat
and go, gee ours dont fade?(lies)
then sell you a paint job.

marine what, jet ski, must we guess, or outboard motor casings
or hulls?? what?

keep the vehicle garaged, paint last near forerver
or buy a tarp.
but outside, under MR. SOL, its doomed.

Nov 01, 2016 | Suzuki Cars & Trucks

1 Answer

Don't know if my question got through last time so


Couldnt tell you without a play under the bonnet ,this is a common rail injection system thats all electronicly controlled so i have no chance ,now if you ask me about a ford D series or a two stroke diesel commer ,even a gardner london bus engine i can help but this fancy encrypted software as used by this age merc? no chance sorry its a merc or a bosch agent only .

Aug 26, 2013 | Mercedes-Benz Sprinter Cars & Trucks

1 Answer

Could you please tell me why every tme i turn m computer on i am asked for my email address @ password


guess what !! there is malware inside scan the entire computer with malware bytes ,and scan it again with you're Internet security system

Jun 02, 2013 | Cars & Trucks

1 Answer

Altima sputtering in drive, ck engine light came on, car is running hot


Too many problems there to guess at

I assume it isn't your first check light
on any vehicle,so that is a place to start

The overheating is not good at all

Timing Belt Issue,Head Gasket

Has to be diagnosed

That didn't start all at once did it?

Sep 04, 2012 | 2003 Nissan Altima

2 Answers

How to remove the battery on a 2007 dodge durango


Careful, Mr. Zapp. The last time somebody said something like that to one of my customers, the vehicle got towed into the shop with a fried PCM. (PCM mounted on TOP of the battery - 1997 Chevrolet Equinox)
Give Robert some credit for asking first! Maybe this is his first vehicle and he has never changed a battery before....I didn't know how to do a LOT of stuff when I had my first car.

Robert,
The main thing that you want to be VERY RELIGIOUS about when REMOVING and replacing your battery, is to always REMOVE the NEGATIVE battery cable (-) FIRST. When INSTALLING the battery, ALWAYS install the NEGATIVE cable LAST.

There is noting peculiar about the battery in your Durango (not like the 1997 Equinox mentioned above).

All you have to do is remove the negative battery cable from the battery. (The battery posts are marked with a (+) for Positive and a (-) for Negative on the battery top if you are not sure which one is which.)

Isolate the cable so it cannot come into contact with the battery.

Remove the Positive battery cable.

Remove the bolt that secures the battery hold-down block at the base of the battery.

Remove the battery from the vehicle.

Reverse procedure to install.

May 16, 2012 | 2007 Chrysler Aspen 4x2

1 Answer

2001 chevy malibu. I filled up with gas this morning and didn't get very far and it died. Won't start back up. What could it be?


Hello! I'm not so certain that the filling of the tank and the fact that the engine died and won't start are related...Lets get a little background...Has the car been running poorly; Or was everything in tip top shape, and after filling the tank it quit? Is the Check Engine Light on now? Any idea how many gallons you pumped in; And the octane you used? And lastly, was it an often used gas station?

Guru..............Saailer

Sep 27, 2011 | Cars & Trucks

1 Answer

Brake lights do not extinguish when engine is stopped


Removing the dash was way overkill for that problem. its a 5 minute or less job to fix that. Ck the stopper for the brake switch or adjustment.

Sep 16, 2009 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...