Question about Dodge Ram Pickup 1500

1 Answer

I have a 2004 dodge 1500 4x4, laramie, i had it painted, the box taken off etc. After picking up the truck i have no tail lites or marker lights in front and no power to either fuse . Now what?

Posted by on

  • hobbes_2008 Sep 16, 2010

    i have cleaned and sanded the areas for the ground to the box, and have checked every conectiopn that i can find. Geuss i'll have to pay to take it to a shop.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 834 Answers

That sounds like either they left a wire connector loose and forgot to re-connect it, or they painted a ground surface and now that circuit has no ground to it. I would take the vehicle back to them if the vehicle did not have that problem before it went to them.

Posted on Sep 16, 2010

  • 2 more comments 
  • Zaraki Sep 16, 2010

    If the vehicle did not have that problem before you took the vehicle in to be painted, then they are the ones who did something to the vehicle, and they should have an idea of what it was that they did or forgot to do, and if the vehicle did have that problem before it was painted then that is a completely different matter, and I can give you further diagnostic procedures in that case. Have you also checked all of the maxi-fuses and all of the fusible links?

  • Zaraki Sep 16, 2010

    You will know any bad fusible link wires when you find one, because they will stretch like a rubber band, and one of the wires might have been pulled loose from its connector inside of the fuse/relay box. also check for any pal fusible links.











  • hobbes_2008 Sep 17, 2010

    I will look for fusible links in the am, and have pretty much been blown off by the bodyman, so am not wanting to pay again, hoping i can sort it out , so far thanks, fusible links should be not so hard to find,,,i have a book

  • Zaraki Sep 17, 2010

    Be sure that there are no wires pulled loose from the inside of the fuse/relay box, (the wires do attach under the fuses) and also check the bulkhead wire connector at the fire-wall on the driver side, and any other wire connectors in that area for any loose or dis-connected wire connectors.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 Dodge Ram 1500 slt Laramie tail lights and dash light aren't working. What can be the problem


Sounds simple as a fuse. Fuse panel may be under the dash, usually drivers side. Might also be under the hood.

Nov 10, 2015 | Dodge Cars & Trucks

1 Answer

My tail lights wont shut off


usually when the headlights goes off so does the tail lights thats mean the brake light switch but the side markers are staying on too. it can't be the fuse since they still light. the only thing that breaks the currant is the switch. it sounds like there,s a problem with the headlight switch. the headlight switch operates the side markers and the tail lights along with the head lights. Hope this can helper .

Sep 18, 2012 | 2001 Dodge Ram 2500 Truck

1 Answer

2008 dodge 1500 4wd tail light wire harness color code with trailer hitch


If you adding a trailer light harness, you can buy a seperate harness from most auto parts stores that will plug right in. There should be a connector near the rear of the truck that you can unplug, and add the trailer harness. It's simple and fast and you don't end up making a mess of your wiring. I suggest puting some "dielectric grease" on the connections to prevent corrosion.
Flat 4 connector.
Brown is tail lights and marker lights.
Yellow and Green are turn and stop. I think yellow is left.
White is ground.

Mar 19, 2010 | 2004 Dodge Ram 1500

2 Answers

Need a diagram of the fuse box for a 1994 volk


Heres a picture of fusebox,and listed is the fuse locations,1) 10amp left low beam light
2)10amp rt low beam light
3)10 amp instrument& license plate light
4)15 amp, rear wiper
5)15amp frt washers and wipers
6)20amp A/C fresh air fan.
7)10amp rt tail & side marker lights
8)10amp left tail & side marker lights
9)20amp rear defroster &heated mirrors
10)15amp fog lamps.
11)10amp left high beam
12)10amp rt high beam
13)10amp horn, rad fan run on
14)15amp backup lights (m/t),power mirrors,heated seats,heated washer jets,cruise control (m/t)
15)10amp engine electronics,coolant pump run on(v6)
16)hazard signals,glove box lite,shift lite
17)10amp turn signals
18)20amp fuel pump, oxygen sensor
19)30amp a/c, rad cooling fan.
20)10amp brake lights,cruise control.
21)15amp dome light,cigar lighter,locking system,multifuntion indicator,clock,vanity mirror.a94b062.gif

Mar 10, 2010 | 2003 Volkswagen Passat

2 Answers

Where is tail light fuse in 1996 chevrolet silverado pickup


Left of the steering wheel & under the dash is the fuse panel for this. No.9 is for the tail lights, but also for many other lights such as licence lamp/parking lamp/side marker/tail gate/etc...
There is also an under the hood fuse/relay panel, but it does not have the tail light fuse in it.

Jan 29, 2010 | 1996 Chevrolet K1500

1 Answer

Dodge 2500 ram diesel no tail lights and my abs


replaced the IPM (the fuse box) it was shorted

Oct 25, 2009 | 2001 Dodge Ram 2500 Truck

2 Answers

How do I replace a tail light lens on a 2004 dodge caravan


have to replace tail light asm, open hatch remove 2 clips or screws they might have either,and gentle pull out and remove connector.good luck.

Oct 10, 2009 | 2004 Dodge Caravan

3 Answers

2001 Chevy Silverado. When I plug in the trailer


its in the engine compartment in the fuse box on the drivers side next to battery

Oct 07, 2009 | 2001 Chevrolet Silverado

2 Answers

Trailer wiring harness diagrams W/o internet goose chase


Try this Link www.dodgeram.org/tech/mods/electric/trailer_wire.htm

Jun 30, 2009 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...