Question about 1997 Chevrolet Cavalier

Open Question

How do you check the fuel pressure on a 1997 chev cavalier 2.2....?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
psds4
  • 293 Answers

SOURCE: 1997 Chev Cavalier hard starting

it sounds like the check valve in the fuel pump is letting the fuel bleed back into the tank

Posted on Sep 23, 2008

Ad
  • 1 Answer

SOURCE: 1997 chev. cavalier z24 Tranmission

I HAD THE SAME PROBLEM. I LOOKED IT UP IN THE HAYNES MANUAL IT SAID YOU HAVE TO JACK THE CAR UP LEVEL, AND THERE IS A PLUG ON THE SIDE OF THE TRANSMITION, YOU TAKE IT OUT IF FLUID COMES OUT THEN YOU ARE GOOD.

Posted on Mar 19, 2009

LEFTY64
  • 69 Answers

SOURCE: Reinstall of Starter 1998 2.4L Chev Cavalier

moz-screenshot-4.jpg

  1. Disconnect the negative battery cable at the battery.
  2. Raise and safely support the vehicle.
  3. Remove the electrical connections from the back of the starter.
  4. Remove the bell-housing cover.
  5. Remove the starter support bracket bolt from the engine block.
  6. Unfasten the starter motor-to-engine bolts, then carefully lower the starter.
  7. Remove the nuts/bolts that hold the starter support bracket to the starter.

To install:
  1. Transfer the starter support bracket to the new starter if the starter is being replaced.
  2. Raise the starter into position and secure the starter using the starter motor-to-engine bolts. Tighten the bolts to 32 ft. lbs. (43 Nm).
  3. Install the starter support bracket-to-engine bolt to 24 ft. lbs. (32 Nm).
  4. Install the bell-housing cover.
  5. Install the starter electrical connections on the back of the starter. Tighten the S terminal to 22 inch lbs. (2.5 Nm) and the battery terminal to 106 inch lbs. (12 Nm).
  6. Carefully lower the vehicle, then connect the negative battery cable.

2.3L (VIN D) and 2.4L (VIN T) Engines
See Figure 10


0900c1528003cb99.jpg

Posted on Apr 08, 2009

  • 11 Answers

SOURCE: need 2 know how to replace a clutch in a 1997 chev

in front wheel drive cars it can be a real pain to do. you pretty much have to pull the whole motor out to get enough room to get the old clutch out and get the new one in. the hard part is getting the room, when you have it, all you need to do is disconnect the slave cylinder, and unbolt the clutch from the flywheel. when the new clutch is on and you are putting the motor and transmission back together you want to be careful not to ruin the new throw-out bearing.

Posted on Aug 02, 2009

  • 70 Answers

SOURCE: how do you check the transmission fluid level on a

there is a plug in the trans. under the car that must be removed with the engine running to check the fluid level. take it to your local mechanic, have him check it for you, that would be the safest way to go

Posted on Nov 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

91 chev cavalier with 3.31 liters runs but wont stay running


Have you changed the fuel filter lately? If not, do so. This sounds like fuel restriction & is a common problem on old cars. If it doesn't remedy the problem, have the fuel pressure checked to eliminate the fuel pump as a problem. Try this first, I'm sure it will solve your problem. Good luck!

Feb 15, 2011 | 1991 Chevrolet Cavalier

1 Answer

1997 Chev Cavalier,4 cyl., new plugs & wires, still no power, misfires


Have a compression test run to see if you have a burnt valve or blown head gasket. If you are seeing white smoke out the exhaust, and are loosing coolant with no apparent leak, you have a blown head gasket. You may also have a defective fuel injector.

Dec 17, 2010 | 1997 Chevrolet Cavalier

1 Answer

1997 chev cavalier 2.2 ohv. hesitates when accelerator pedal applied. Completely tuned up 6 k ago,(except fuel filter), new o2 and coolant sensor. What is my next move.,


The TPS which is the throttle positioning sensor has an open in its circuit. Most auto parts stores will have this common part for you cars engine

May 23, 2010 | 1997 Chevrolet Cavalier

1 Answer

I have a 1997 Chev cavalier that will not start. it is getting to much gass


if its getting too much gas hook up a scan tool and look at the engine coolant temperature if it's reading way too cold then it's telling the computer to dump more fuel in if the temperature looks normal it's probably going to be the fuel pressure regulator

Nov 11, 2009 | 1997 Chevrolet Cavalier

1 Answer

Car idles high and smell gas and cuts out when in gear


SCAN IT TO LOOK FOR MAP SENSOR PROBLEMS.AND CHECK TO MAKE SURE MAP SENSOR VACUUM HOSE IS RECEIVING VACUUM.IF ALL IS GOOD CHECK FOR OR LOOK FOR LOOSE VACUUM HOSE OR PVC STUCK OPEN.CHECK FUEL LINES GOING TO THE FUEL PRESSURE REGULATOR AND FUEL INJECTORS. FOR LEAKS.ALSO CHECK FUEL PRESSURE O RING IT WILL LEAK CAUSES FUEL ODOR.HAVE YOUR EVAPORATIVE CANISTER FILTER CLOGGED.YOU WILL HAVE FUEL ODOR.

Sep 21, 2009 | 1997 Chevrolet Cavalier

1 Answer

What causes gears to change from reverse to drive in 1997 chev. cavaliers?


hydraulic pressure diverted by electronically/computer controlled solenoid valves inside the trans on the hydraulic heart of the trans the valve body.

Jul 19, 2009 | 1997 Chevrolet Cavalier

2 Answers

My 96 chev cavalier was running and when i went outside i guess


if u have no pressure from pump but pump is making noise,its a badly blocked fuel filter,leaking fuel line or pump is defect!

May 25, 2009 | 1996 Chevrolet Cavalier

2 Answers

1997 Chev Cavalier hard starting


it sounds like the check valve in the fuel pump is letting the fuel bleed back into the tank

Sep 23, 2008 | 1997 Chevrolet Cavalier

Not finding what you are looking for?
1997 Chevrolet Cavalier Logo

Related Topics:

263 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...