Question about 1999 Plymouth Breeze

1 Answer

Blower fan works on high only - 1999 Plymouth Breeze

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Plymouth Master
  • 726 Answers

Sounds like your blower motor resistor has failed. its built into the blower motor housing. its a component that reduces voltage to your blower motor resulting in different speed settings.

Posted on Sep 16, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 Isuzu Rodeo 2.6 Blower Fan not working


need to replace the resistor should sit by the blower or close by

Feb 20, 2013 | Cars & Trucks

2 Answers

01 grand.prix ac fan switch only works on high. has a duel temp controller when you turn fan off the only way fan comes back on is to move the temp controller levers


Hi!!
When the Blower Motor Resistor (controls blower speeds) goes bad, the blower motor works only on HIGH SPEED. REPLACE IT.
BLOWER MOTOR RESISTOR Removal & Installation
  • Disconnect negative battery cable.
  • Remove right lower instrument panel insulator panel.
  • Disconnect blower resistor connector located behind right side of dash.
  • Remove blower resistor screws and blower resistor.
To install, reverse removal procedure
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Feb 18, 2011 | 2001 Pontiac Grand Prix

2 Answers

Heater blower stopped working?


Hello,
You may want to try your fan on all speeds. If it will work on high, you have a bad resistor for the fan motor. ( high speed doesn't go through the resistor ).
If it doesn't work on any speed, I would check the following;
1. Make sure the fuse isn't blown for the fan blower motor.
2. Check, or have checked the wires between the fan control switch and the fan blower motor.
3. Have the fan control switch checked.
4. Have the fan blower motor checked.

I hope this helps you.

Feb 03, 2011 | 2002 Buick Rendezvous

1 Answer

I have a 2004 Pacifica and the blower motor runs on high all the time, can't get it to work on slower speeds


The high blower works off a relay in the high speed only so the fan switch is at fault on your vehicle
Replace the fan blower control speed switch which is the one you adjust the lower fan speeds

Jun 15, 2010 | 2004 Chrysler Pacifica

1 Answer

My 2001 Voyager blower fan only runs on high.


This is 100% the Blower (Fan) Motor Resistor located near the Blower Motor.
This is a very common problem with Chyrsler, Dodge, Plymouth. The key symptom is the Fan only working on High.
This is very easy to access and replace.

Let me know if this helped....

May 11, 2010 | 1999 Chrysler Sebring

1 Answer

My blower fan only works on high


you will need to order a blower resister its easy to swap out

Dec 11, 2009 | 2000 GMC Sierra

3 Answers

BROKEN FAN


Change blower motor resistor.

Aug 08, 2009 | 2001 Chevrolet Impala

1 Answer

My fan/blower won't run on high setting. It works


Replace relay under blower motor, under hood.

Jun 25, 2009 | 1993 Buick LeSabre

2 Answers

1998 Astro Van Heater AC Blower only works on medium & Low


Yes, in high it bypasses the resistor and uses a high blower relay. But I think on 1998 Astro the High relay and the resistor are built together. It should be mounted in the blower box real close to the blower motor.

Mar 09, 2009 | 1998 Chevrolet Astro

Not finding what you are looking for?
1999 Plymouth Breeze Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8274 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...