Question about 1994 Toyota Land Cruiser

Open Question

How do I remove the starter motor in 1994 80 series Land cruiser

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
rockitman187
  • 2559 Answers

SOURCE: 2004 chrysler pt cruiser starter motor removal

You may sneak it out with small fingers with out pulling out the starter.

If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.


Please rate this a fixya

Posted on Feb 08, 2009

Ad
Technopro
  • 243 Answers

SOURCE: quantity of engine oil used in 1 HD engine toyota land cruiser

The Landcruiser 1HD engine uses 9.3 liters of oil with the filter. The oil is replaced every 5000Kms.

Posted on Nov 12, 2008

  • 101 Answers

SOURCE: Trying to remove and replace rear brake rotors

First, make sure your parking brake is off.
Remove the rear caliper and then the brake pad housing. In the center hub of the rotor the parking brake shoes are located. The may need to be loosen first. There is a hole between 2 of the studs you need to align at the bottom. Look in the hole with a flashlight and find the star wheel. Use a screw driver to turn the wheel up a few turns to loosen the parking brake shoes from the rotor hub.
After that there are 2 threaded holes in the rotor near the studs you put two 8mm bolts in and slowly tighten each and it will pull the rotor off the hub. They rust up pretty bad so use penetrating oil on them.

Posted on Apr 11, 2009

  • 1 Answer

SOURCE: i have a toyota landcrusier 80 series

i have a ignition probelm. i have a petrol and it wont start.checked every thing in the ignition system and its fine. but still wont fire

Posted on Apr 22, 2010

kapishtech
  • 2272 Answers

SOURCE: how do i remove my dash so i can install a genuine

The dash its fitted with few clips.Removing it is not very easy.But once the first clip is UN-clipped it will be easy.100-series dash is held on with press clips (three at the top, two each side and three at the bottom). Start from the top centre by squeezing a finger or two between the dash top and the radio trim, then ease your fingers to one side and ease the front panel off. After the first clip comes free, the others easily follow. The whole panel then swings downwards with all cables attached. The radio can be removed with just four screws.
-------------- There is basic dash removal guide for Toyota Land Cruiser.Its not exactly for Toyota Land Cruiser 100 series but for Toyota Land Cruiser.So check this guide also for more help. Click on this link directly:-- http://www.carstereoremoval.com/htm/stereoremovalToyotaLandCruiser03_07StrAU.htm ------------

Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

Posted on Sep 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the starter relay located on a 94 land cruiser


While I lack specific land cruiser knowledge, the starter relay is usually part of the solenoid that sits on top (usually) of the starter motor on modern cars. The job of this solenoid is to slide the starter bendix gear into engagement with the flywheel and apply power to the starter motor, turning the flywheel and starting the engine. The current requirements of the solenoid are modest, compared with the starter, and I doubt a relay is required to engage the solenoid. This solenoid is actually the starter relay, as well as bendix engager.

If you can trace the large power lead from the starter motor back to the battery and you find no relay inline, then you do not have one.

Mar 17, 2018 | 1994 Toyota Land Cruiser

1 Answer

Removing 100 series Toyota Landcruiser starter motor


If this is a V8 land cruiser the starter is located under the intake manifold, the manifold has to be removed to get the starter out.

Nov 22, 2017 | Toyota Cars & Trucks

3 Answers

Flywheel spins freely but engine does not turn over


not really possible unless you have a broken crank shaft at the rear main bearing or if automatic then the flex plate has broken off around the flywheel bolts . The torque converter will hold the flex plate in position and if manual then the pressure plate on the throw out bearing will maintain the flywheel in position. Unless you are saying that the motor spins freely but will not start which is different . If that is the case check that the cam shaft is turning(broken timing belt) and bent valves.

Jun 01, 2014 | 1998 Toyota Land Cruiser

1 Answer

Torque settings for exhaust manifold toyota land cruiser 1985 75 series?


I would tighten till hard then one more nip,should not need to be tight as because you have a gasket inbetween.

Jan 17, 2014 | 1985 Toyota Land Cruiser

1 Answer

I have a 100 series landcruiser that starts fine when its cold, but it sturggles and sometimes doesnt start when its warm. Please help as I am on a low income and cant afford to spend thousands on parts...


Usually, that indicates that the starter is going bad. If you remove the starter and take it to pretty much any parts store, you can have it tested for free.

May 02, 2011 | 1995 Toyota Land Cruiser

1 Answer

Hi, have latest 2010 LC79 Toyota Landcruiser V8 ute, where is the starter motor located , and how to remove..


The starter motor is buried in the V8 valley . It is about a days work to replace it . They are very expensive , have only a few service parts and don't like water .

May 22, 2010 | 2000 Toyota Land Cruiser

1 Answer

I need instructions on how to replace the starter on a 2000 Toyota Land Cruiser


[Get the Flash Player] function launchVid(flashVars) { var s1 = new SWFObject('http://www.delmarlearning.com/webservices/delmedia/JWPlayer/Default/player.swf','ply','400','300','9','blue'); s1.addParam('allowscriptaccess', 'always'); s1.addParam('allowfullscreen', 'true'); s1.addParam('flashvars', flashVars); s1.write('vidPlayer'); $.scrollTo('#vidPlayer', 1000); } On all engines except the 2UZ-FE, the starter is external, mounted in a conventional manner, alongside the engine block. One the 2UZ-FE, however, the starter is mounted in the 'V' of the engine, between the cylinder head banks. The entire intake manifold assembly must be removed to access the starter motor and solenoid. (Toyota calls the solenoid a "magnetic switch.")
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Drain the cooling system.
  3. Relieve the fuel system pressure.
  4. Remove or disconnect the following:
    • Negative battery cable
    • Engine appearance cover
    • Air intake tube
    • Intake manifold
    • Starter motor mounting bolts
    • Starter wiring connectors
    • Starter motor
To install:
  1. Install or connect the following:
    • Starter motor
    • Starter wiring connectors. Tighten the cable nut to 86 inch lbs. (10 Nm).
    • Starter motor mounting bolts. Tighten the bolts to 29 ft. lbs. (39 Nm).
    • Intake manifold
    • Air intake tube
    • Engine appearance cover
    • Negative battery cable
  2. Fill the cooling system.
  3. Start the engine and check for leaks.

EMAIL ME AT bomber6509@yahoo.com for the diagram....it is too large to post here...there is no charge.

Oct 11, 2009 | 2000 Toyota Land Cruiser

1 Answer

80 SERIES OVER HEATING UNDER LOAD


put electric fans bigger radiator .tranny cooler kit.this might help some you might need bigger engine more horse power.

Apr 10, 2009 | 1994 Toyota Land Cruiser

2 Answers

Toyota land cruiser 1997 80 series electrical wiring diagram


what are the colour of the wires for the unlock / lock for the central locking for a toyota landcruiser 1990 modle ?

Nov 08, 2008 | 1997 Toyota Land Cruiser

Not finding what you are looking for?
1994 Toyota Land Cruiser Logo

Related Topics:

362 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...