Question about 2001 Dodge Caravan

1 Answer

How many bolts hold the starter on a 01 caravan 3.3 and where ae=re they located

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 14,036 Answers

YOUR STARTER HAS 3 MOUNTING BOLTS GOING HORIZONTAL TOWARD TRANSMISSION.

Posted on Sep 16, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2003 hyundai elantra starter removal where are bolts located on the starter


It's bolted to the outer edge of your transmission. If it's a front wheel drive, it may be near the front of the motor, where the engine and motor connect. Should only have two bolts holding it on. Hope this helps!

Oct 02, 2017 | Hyundai Cars & Trucks

1 Answer

Need to know where started is located on 1998 Dodge Caravan


Starters are the round motors mounted on the engine block down low probably in the front with the thick wire leading to the positive terminal of your battery.

2 or 3 bolts hold it on.

Jul 05, 2010 | Cars & Trucks

1 Answer

HOW DO I REMOVE STARTER FROM 1999 DODGE CARAVAN SE 3.3


If the 95 is anything like the 90, the bolts are right on the flange type part of the starter, where the starter meets the transmisison. there is 3 bolts holding it in. they are most likely 13mm, 14mm, or 15mm bolts. but on some caravan models you have to remove the front transmission mount to get to it. this is probabally why you cant find em'. but you will have to remove the mount, then the starter bolts. then you have your starter out! but when you want to put the mount back in, you may need a floor jack to lift the engine/trans um into the right spot to put the bolt back through the rubber part. Tricky, but possible.

May 31, 2010 | 1995 Dodge Caravan

1 Answer

Where is starter located and how to remove it , for a dodge caravan 1998,3.3l


Starter - Removal & installing
  1. Disconnect the negative battery cable.
  2. Raise and safely support the front of the vehicle securely on jackstands.
  3. Disengage the solenoid wiring connector from the terminal. This connection may be held in place by a retaining nut, or it could be a push-in connector.
  4. Remove the B+ nut and wire from the starter motor terminal.
  5. Remove the starter motor-to-transaxle bellhousing mounting bolts.
  6. Remove the starter from the vehicle. If equipped, remove the starter motor spacer.
To install:
  1. If equipped, hold the starter motor spacer in position.
  2. Install the starter motor into position on the vehicle.
  3. Install the starter motor-to-transaxle bellhousing mounting bolts. Tighten the mounting bolts to 40 ft. lbs. (54 Nm).
  4. Engage the solenoid wiring connector onto the starter terminal.
  5. Connect the B+ wire and tighten the retaining nut to 90 inch lbs. (10 Nm).
  6. Lower the vehicle.
  7. Connect the negative battery cable.
  8. Verify starter motor operation.
020fef8.jpg

Disengage the solenoid wiring connector, then the battery positive (B+) nut and wire from the starter motor

98933b2.jpg

Remove the 3 starter motor-to-transaxle bellhousing mounting bolts

e2afde4.jpg

Remove the starter motor from the vehicle


The starter relay is located in the Power Distribution Center (PDC) in the engine compartment. Refer to the underside of the PDC cover for starter relay location.

Hope helped with this (remember rated this help) Good luck.

Nov 18, 2009 | 1998 Dodge Grand Caravan

1 Answer

Unidentified Bolt needs Replacement 01' caravan


could be upper control arm bolt but also could be body mount bolt where the body mounts to the chassis

Sep 17, 2009 | 2001 Dodge Caravan

1 Answer

Locate bolts to remove the strater of 1996 dodge caravan


Almost all starters have ears with holds in them that bolts go through to threaded holes in the bell housing. Find the starter and look around the end without the wires for the bolts.

May 07, 2009 | 1996 Dodge Caravan

1 Answer

Need install instruction for starter on 2002 Dodge Caravan


This is alittle tricky getting to some of the bolts but its not too hard to do otherwise. 2 bolts hold on the starter IIRC they are 13mm bolts. make sure your battery is dissconected by the black cable. then there will be 2 nuts holding on the starter wires. one will be 8mm and the other 13mm. remove them with care cause the wires may and can break. when you remove starter check wires for corrosion or if they look fraigle. repair them if damaged.
then to put it back in is the same way you took it out. should take about 1.5 hrs total if you have never done it before.

Overall i would say skill level 3/10 only cause its trickey getting to that top bolt sometimes.

good luck,
Michael

Apr 29, 2009 | Dodge Caravan Cars & Trucks

1 Answer

Starter replacement 1992 dodge caravan


The starter is located under the front on the car almost in the middle. Its shaped like a big cylinder with a smaller one attached to it. It has 3 big bolts that connect it to the undercarriage of the van itself and 2 smaller ones that connect it to the wires that run to the solenoid. One the bolts are removed it comes right off. I was surprised how easy it was. Its harder to put back on. Just reconnect the smaller bolts first.

Mar 14, 2009 | 1992 Dodge Caravan

2 Answers

Starter for dodge caravan 2000


DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.

May 17, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
2001 Dodge Caravan Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...