Question about 2000 Honda CR-V
Welcome to FixYa.com
Thank you for using FixYa.com, Regards, Lee Davidian Remove upper radiator hose
Remove the two 8 mm bolts See diagram below
Welcome to FixYa.com
Posted on Sep 16, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
it should be located right outside the engine block. follow the black rubber hose going from the radiator to the engine. the peice it connects to on the engine should be where it is. if you buy a hanes repair manual from autozone for your car it will walk you through it
Posted on Mar 20, 2010
SOURCE: honda crv 2000 computer reset
1. ensure ignition off
2 . bridge the 2 pin connector, Put a piece of wire across both terminals
3.switch ignition on
4. SRS lamp should illuminate for 6 seconds
5.disconnect the bridge wire within 4 seconds of the warning lamp extinguishing
6.SRS lamp should illuminate 2 times, Codes erased
7.switch ignition off
8 Wait 10 seconds. switch ignition on and check SRS warning lamp operation.
hope this helps
Posted on Feb 19, 2009
You should just go to Honda and purchase it from them. You can go up to the parts counter and either give them your year/make/model or your vin and they will give you exactly what fluid(its the same on all A/T honda's) and the correct amount need. They made the car, they know best.
Posted on May 07, 2009
the check engine lamp is not affected by things like tyres, brakes etc. It shows that the vehicles engine management system had detected a fault with the engine or engine sensors. Check the engine for broken or disconnected wiring (maybe it was disconnected during the replacing of the hoses but not reconnected). If you fail to locate anything, check the manual for the correct fault code retrieval procedure or take the vehicle to a professional. Tyres may affect your ABS system or Airbag systems but they usually have their own warning lamp and are unrelated to the check engine lamp..
Posted on Dec 15, 2009
JUST POP SWITCH OUT AND BULB GOES INTO SWITCH USE SMALL SCREW DRIVER TO REMOVE YOU WILL HAVE TO TWIST IT COUNTERCLOCKWISE TO REMOVE, TWIST CLOCKWISE TO INSTALL.
Posted on Apr 21, 2010
Tips for a great answer:
Sep 10, 2014 | 2000 Honda CR-V
Dec 30, 2012 | 2000 Honda CR-V
Feb 22, 2012 | 1998 Honda CR-V
Feb 03, 2010 | 2000 Honda CR-V
Jan 28, 2010 | 1998 Honda CR-V
Oct 10, 2009 | 1997 Honda CR-V
Sep 05, 2009 | 2000 Honda CR-V
5,635 people viewed this question
Usually answered in minutes!