Question about Toyota Avalon

1 Answer

I have a crimestopper alarm. Out of the blues, the alarm stopped working with the car. The remote battery was changed but still no good. Is there anyway to fix it? Thanks in advance, Jimmy

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

You need to check the fuse to the alarm as well if that fails look through the phone book to find a place that install your kind of alarm and they maybe able to help you if you have a booklet to your it maybe a 800-number in there wish you the best of luck Michigan Man.

Posted on Sep 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alarm goes off 5 seconds after arming. why, how to stop it?


They say when your remote needs a new battery it'll do that you might want to change the battery inside your remote on your key chain wallgreen sell them cheap good luck

Oct 03, 2015 | Cars & Trucks

1 Answer

Where is the fuse box on my '99 Durango SLT 5.2?


. most likely you need to change the remote battery. It's responcable for many things working correctly. my daughters car locked on her and the alarm sounded and had to disconnect battery in her car to get alarm to stop. when a theft is in process the vehicle takes over and don't allow it to crank and the radio also stops working along with other things. so try battery first in remote.

May 02, 2014 | 1999 Dodge Durango

2 Answers

Took the battery out to replace the fron left headlight. Once we put the batter back the car would not start and all lights inside and out started flashing. Started the car downhill in 1st gear and drove...


does this car have an aftermarket alarm system? it sounds like it does, as i dont ever recall seeing a blue flashing light in one of these cars. do you have an alarm / auto start remote control? try locking / unlocking the car several times with the remote, if it has a remote start try starting it with the remote a few times. try locking / unlocking the car with the key. good luck!

Jan 25, 2010 | 2005 Nissan Sentra

1 Answer

2001 Jeep Grand Cherokee Laredo. Alarm sets off when unlocking doors with remote and will not shut off with remote, or by pressing the reset button behind blinking alarm light under dash,or by using key in...


I found a solution on another site showing if i turn the ignition on and hold the reset button on behind the alarm light untill it turns to solid blue light then turn off the ignition , it will disable the alarm.

Dec 12, 2009 | 2001 Jeep Grand Cherokee

1 Answer

My alarm went off after I jumped my car


The below Installation Caution(s) & Warning(s) was taken from my CS-2000 Series III CrimeStopper Alarm System manual:

" WE RECOMMEND that the MAIN SYSTEM FUSE be REMOVED before jump starting, using a battery charger, or changing the battery. A voltage surge or high boost condition could damage alarm circuits."

There you go. You will probably need a new Alarm System. If possible,get the same model so that it will save you time to install, just swap the two main alarm modules.

Nov 24, 2009 | 2010 Honda Insight

2 Answers

I installed a sp-200 crimestopper alarm on my toyota camry 1999 i got the unlok button to unlok the locks but iam stuck with the lock button i dont know how to make it lock the doors


power lock: blue in 12 pin connector in drivers kick panel

power unlock: blue/black in 12 pin connector in drivers kick panel

child safety locks: green in 12 pin connector in drives kick panel

hope this helps you out. good luck

Nov 19, 2009 | 1999 Toyota Camry

1 Answer

Remote key lock stopped working after wal mart put new battery in and now my head lights stopped workin!!!


check fuse for low beam, then possibly both low beam globes. they could have blown.
the key remote may need reprograming into system try put key in ignition in on position then press remote buttons a couple of times then try if no good need to go to dealer to be programed into system again or it needs repairing/replacing.

May 31, 2009 | 1996 Chevrolet Camaro

1 Answer

Does any body know how to reset the ML350 alarm??....The remote control doesn't work after i replaced a new battery to the remote control. I couldn't even use the remote to lock/unlock the car. I was


SOME OF THE REMOTES REQUIRE THAT THE KEY BE IN THE IGNITION, IN THE ON POSITION. TAKE THE BATTERY OUT AND WAIT 10 MINUTES. THEN PUT THE KEY IN THE IGNITION AND INSTALL THE BATTERY WHILE THE KEY IS TURNED TO THE ON POSITION. HOPE THIS HELPS YOU. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

May 18, 2009 | 2007 Mercedes-Benz ML350

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...