Question about 1999 Dodge Ram

1 Answer

I have a 98 dodge mini van and the abs light, the check engine light and none of the gauges work.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Two places you need to look. 1-behind the instrument panel there are two plugs that the cluster slides into, you have to remove the knee panel- three screws, get a flashlight, and look up while laying on your back on the floor, the get an 11 year old or some one with tiny hands to push the plugs back on, or you can take the dash apart, but this takes a long time and risks breaking plastic all over the place.
2. The fuse boxes, one inside the car and one under the hood, both are clearly labeled as are the fuses.
Hope that helps.

Posted on Sep 19, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My van would have issues with starting for months. I would have to try starting it up about 5-8 times before it would start up. Battery is new and has been tested twice within the last few months and it...


HI youtube12 - IT sounds like your starter deed not disengage from the flywheel and
by you driving it caused the starter over heat and short out .
You need to have the electrical sys checked out before replacing starter. OK

good luck ziggyone

Sep 16, 2011 | Dodge Grand Caravan Cars & Trucks

1 Answer

I have an 04 dodge ram that when i start it up none of the gauges work, check engine light comes own as well as the abs, service four wheel drive, an e brake light, also the wind shield wipers dont work,...


You could have some major electrical problems or it could be some thing simple. You need to have the codes read and repost. then we can help you. Getting the codes is the most important thing that you can do to let us know where to start.

Feb 07, 2011 | 2004 Dodge Ram 1500

1 Answer

I went to start my van today and the check engine light and abs light came on and none of my gauges or odometer work. what may be the cause?


The "check engine" warning light advises that the vehicle is in "fail safe" mode. This means only some of the car's capabilities are operational, just enough to get you to the nearest service point. You probably should not drive. Have your service man download and analize the fault codes from the ECM which will indicate what the problem is.

Apr 18, 2010 | 1997 Dodge Caravan

1 Answer

2001 Dodge Ram 2500 - gauges don't work


check the engine to body ground strap. located rear top of engine screwed to firewall Remove,clean, and resecure.

Nov 12, 2009 | Dodge Ram Pickup 2500 Cars & Trucks

3 Answers

All instrument gauges stopped working. 2000 Dodge


try removing the + positive cable for a few minutes and then reconnect it allowing the computer to reset itself

Oct 15, 2009 | 2000 Dodge Ram 1500 Truck

1 Answer

None of the gauges will work on my 98 plymouth


This is because it is one of your main relay is bad. It is also part of the circuit that your starter is on.
This fuse panel is under the hood just to the left of the battery.

Sep 18, 2009 | 1998 Plymouth Voyager

1 Answer

Speedomter ,check engine,abs light


there is a defective ABS wheel sensor .
you need to scan it by diagnostic tool to know which one of these sensor

Sep 15, 2009 | 1998 Ford Windstar

1 Answer

Check engine&abs light on, speedo and gauges go to 0


there would either be a shorted wire or the computer is malfunctioning. The only way to fix this problem is to have a mechanic put a scanner on your car and test it. AUTOZONE DOES IT FREE other wise it's about $40

Apr 03, 2009 | 1996 Dodge Caravan

2 Answers

Abs light stays on & A/C stopped blowing cold air


The BCM (body control module) is the problem, have it replaced, this is a common issue on your van.

Aug 12, 2008 | 2000 Dodge Caravan

2 Answers

SPEEDOMETER-TACHOMETER-AIR CONDITIONER ALL WENT OUT AT SAME TIME


2000 dodge ram 2500 truck 4wd the abs light and air bag light were on then the check engine light went on then all of a sudden all the gauges and warning lights went dead and off including the tach and other gauges. But now all the gauges are working and the check engine light went off with all the others and the tach and other gauges are working. what is the problem with this truck ? The only code it read was p1687 from the dtc. Is the problem the pcm or something else.

Jul 31, 2008 | 2000 Dodge Ram 3500

Not finding what you are looking for?
1999 Dodge Ram Logo

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...