Question about 2000 Volkswagen Beetle

Open Question

How to replace seat release handle on 2000 VW Beetle

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
WhyAge
  • 6 Answers

SOURCE: VW NEW BEETLE HEADLIGHT REPLACE

Try this:

  1. Before you try removing the headlight housings, check for a blown fuse first, since the headlight circuits on these cars are fused. The fuse is located on the regular fuse panel inside the car, on the left side of the dashboard behind the removable cover.
    Well, since there are no visible screws anywhere around, how do I get the headlight out? It’s not that hard at all.
  2. Open the hood. Locate the seam between the nosepiece and the front fender (either side). Go up between the first two fender mounting bolts and look down a few inches. See a small knob sticking out at you? That is a release lever for the headlight assembly. Push in on it slightly and pull all the way up as far as the lever will go.
  3. Now push on the headlight from behind with one hand and be prepared to catch the assembly with the free hand from the front. It may take a bit of a push because there is some gooey adhesive between the headlight and the fender.
  4. Once you have the headlight out, pull the connector off the back of the housing and take the headlight somewhere where it is easy to work on. Put it on a pillow or something soft so you don’t risk scratching the lens.
  5. There is a black plastic cover on the back of the housing. See a tab on it? Push on this tab and pull the cover down to expose the bulbs.
  6. There is a metal spring clip that holds these bulbs in place. Undo this and the bulb will fall out. Take out the new bulb and compare it with the one you are replacing. Make sure the wattage is correct, since they are both H1 bulbs. Never touch the glass part of the bulb itself with your fingers.
  7. Use the soft cloth to handle the bulb if needed. Line up the tabs of the bulb base with the slots in the reflector housing and drop the bulb in. Put the spring clip back on and make sure the ends of the clip are in securely. Put the bulb cover back on. Now is the time to clean up the mess around the fender where the headlight mounts. Remember seeing that nasty-looking goo seep out from around the rubber seal on your headlights? That’s the adhesive I was talking about earlier.
  8. Take the adhesive remover on the paper towels and remove this stuff from the fender before putting the headlight back in. Don’t remove all of it from behind the headlight itself, as it is there to keep excess amounts of water from getting behind the headlight. Just remove enough to where it won’t make a mess anymore. A little wax around the mounting area on the fender will detail things out nicely.
  9. Position the headlight up to the fender. Push on the wire connector. Line up the tabs on the headlight assembly to the slots in the headlight housing in the fender and push the whole thing in. Sometimes things won’t line up on the first try, but keep trying. The headlight should go up against the fender fairly easily.
  10. Once you get it to this point, grab the release lever, push all the way down, and lock the headlight assembly into place.

Posted on May 18, 2008

Ad
samson-1
  • 153 Answers

SOURCE: VW Beetle Airbag Light

The main thing to remember when messing around with the air bags is that it doesn't take much to set them off. I ave seen them inflate just by unplugging and pluging them back in. I suggest the dealer as your safest bet.

Posted on Oct 05, 2008

  • 102 Answers

SOURCE: 2000 VW Beetle airbag light on

has to be done with vagcom or vcds software

Posted on Mar 23, 2009

  • 11 Answers

SOURCE: emergency latch for gas cap 2000 VW Beetle, where is it?

From the manual:

  • Open the rear lid.
  • Open the cover on the backside of the luggage compartment. To open the cover, turn the two "quick-releases" and fold the cover down.
  • Reach through the opening by the fuel filler flap. Grab the cable with th plastic covering and pull down. The filler flap will open by itself.
Best of luck!

Posted on Apr 10, 2009

  • 299 Answers

SOURCE: something draining battery on 2000 VW Beetle Turbo

If you are sure you have a key off battery drain, what you need to do is connect an ammeter to the negative side of the battery(disconnect the negative battery cable and connect one side of the ammeter to the battery terminal and one side to the and one side to the battery cable) note the reading and start pulling fuses one at a time making sure to put them back in their proper slot when the reading an the ammeter goes down to normal the short will be on the circuit of the fuse you have pulled if any part of these instructions is too difficult have the problem checked by a dealer

Posted on Oct 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the inside trunk release on a 2000 vw beetle. Trunk lid will not open with key, fob, or door release.


Trunk won open even with manual release http://newbeetle.org/forums/new-beetle-convertible/54170-trunk-wont-open-even-manual-release.html there is good info here C24OF

Dec 21, 2016 | 2000 Volkswagen Beetle

1 Answer

2006 VW New Beetle passenger seat


Check the spring which puts tension on the lever to hold it in the lock position this may have dislodged itself or be broken or possibly bent.

Jun 06, 2013 | Cars & Trucks

2 Answers

1998 VW Beetle inside hood release handle broken


Their is a cable in the control access the cable and pull on it with a pair of pliers then replace the part

Aug 27, 2012 | 1998 Volkswagen Beetle

2 Answers

2000 VW Beetle drivers side seat adjusment cable broken?


Under the seat there is a spring that conects the 'handle'to the Latch, tha tholds the seat in place....you will have to look under the seat to see if the spring is broke

Nov 07, 2011 | Cars & Trucks

1 Answer

99 VW Beetle Hood Release Cable plastic tab broke


the only way to purchase is a whole cable

Jul 01, 2009 | 1998 Volkswagen Beetle

1 Answer

2000 VW Beetle airbag light on


has to be done with vagcom or vcds software

Mar 19, 2009 | 2000 Volkswagen Beetle

2 Answers

Drivers front seat latch doesn't work 2001 beetle


its the cable from the handle to the seat mechanism that locks the seat in place. an easy fix with new cable from vw .i think its a dealer only part !

Nov 29, 2008 | 2001 Volkswagen Beetle

2 Answers

Vw beetle 1.8t 2000


remove the radio and get some new glasses

Oct 22, 2008 | 2000 Volkswagen Beetle

1 Answer

Code Reader


The diagnostic port is usually beneath the dash on the driver's side of the car, near the hood release handle. If you get down under the dash, you should see the connector there (it'll the be only one mounted there).

Aug 31, 2008 | 2000 Volkswagen Beetle

1 Answer

2000 VW beetle fan belt replacment


you need a 15mm wrench use the open end of the wrench and put it on the nipple on the top of the tensioner pulley assembly then push it back it will release the tension enough to slip it off the altenator

Jul 19, 2008 | 2000 Volkswagen Beetle

Not finding what you are looking for?
2000 Volkswagen Beetle Logo

Related Topics:

284 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

yadayada
yadayada

Level 3 Expert

77169 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8729 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...