Question about 1997 Honda Civic

1 Answer

Taillight lenses - 1997 Honda Civic

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Honda Master
  • 1,420 Answers

Welcome to
Thank you for using, Regards, Lee Davidian
How can i help you ? Taillights ?

Posted on Sep 16, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Rhigt tail light change how

1Check the fuse. A blown fuse usually causes both lights to go out. On newer cars, the tail lamps can be fused separately and/or each bulb or shared circuit can be fused. A fuse can be blown due to other problems, so you'll need to check more than just the fuse, but it's the right place to start. Look in your owner's manual to determine where the fuse box is located in your car.
2Look at the tail lamp wiring. These are the wires that lead to the tail lights, located inside the lid of the trunk. Open the trunk and take a look. You can see where the wires should connect in order for the electrical system to properly work. If a wire has come loose, reattach it.
3Check the taillight bulbs. If the fuse and wiring look right, the bulbs themselves might be the problem. To check them, unscrew the taillight lenses from the outside using a screwdriver.
4Check the taillight lenses. Whether or not you were able to fix the problem of your tail lights working correctly by examining the fuse, wiring and light bulb, it's important to check the lenses as well to make sure they're not cracked or broken.


Dec 14, 2015 | Jeep Liberty Cars & Trucks

1 Answer

How to replace right rear taillight assembly

Access to the tail light cluster should be through panels in the rear corners of the vehicle. Remove the panel and you can remove the tail light cluster to replace the bulbs. This is the position on most sedans, unless, like on pick-ups, the tail light lenses have screws which allow the lenses to be removed to change the bulbs.

Apr 01, 2011 | 2002 Lexus RX 300

1 Answer

How to install replacement taillight assembly

Hello: Open the rear door, you will find two screws on the inside on the side of the tail light, remove the screws pull back side forward to unhook the lenses assembly unplug it, remove board from lenses assembly. Re-install in reverse

Feb 10, 2011 | 2005 Chevrolet Trailblazer Ext

1 Answer

Water is getting into my taillight lense and leakin into my trunk

it sounds like a trunk seal is bad or the seal around the taillight is bad i hope this helps you

Apr 10, 2010 | 1992 Buick Park Avenue

1 Answer

Need to replace the driver side taillight

if you lower the tailgate those are the screws i think your talking about,yes remove them and swing the lense out pulling from the side the screws were on,it will unhinge its self on the outer side

Dec 10, 2009 | 1998 Dodge Ram 3500 2WD

1 Answer

I need to replace the taillight lens.

Open the trunk. Unscrew and remove the plastic T post where your cargo net mounts. Remove the long plastic piece that covers the latch mechanism to expose the (5 or 6) plastic nuts that hold the lense to the body. Once the are off, just pull the lense straight back and unscrew your bulbs....install in the reverse procedure.

Jun 08, 2009 | 2006 Chevrolet Impala

1 Answer

Taillight lense removal on 84 vette

If I remember you need to remove them from laying on the ground and going in from under the car behind the bumper. Some models did have 2 screws on the front the older ones had to be removed from behind the bumper.

May 24, 2009 | 1984 Chevrolet Corvette

1 Answer

Moister in taillight.

I had same problem with 98 malibu, I put weatherstripping between where light circuit board snaps onto lense which made it water and air tight. also make sure lense is not cracked anywhere

May 23, 2009 | 2002 Chevrolet Monte Carlo

2 Answers

Replace a taillight

how to replace rear right taillight bulb

May 15, 2008 | 2001 Volkswagen Beetle

Not finding what you are looking for?
1997 Honda Civic Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides