Question about Chevrolet Camaro
Not, this work with the transmission, generally this is mounted in the trans. Broke cable is the common failed.
Posted on Sep 15, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 91 speedometer and miles
It has an electrical speed sensor on the transmission. It should have three wires and be on the top of the tranny. There are two different ones. One for a manual trans and one for a automatic. They usually go bad.
Posted on Jan 13, 2009
If the speedo isn't working properly, the first thing to check is the output speed sensor wires on the rear right side (near the bar code) of the tranny case. Follow the wires and make sure it hasn't been cut, pinched or shorted.
If all is well there, take the output speed sensor off. Watch out cause you'll get wet with tranny fluid (Dexron 6). (Be ready to plug it up.) If there are no metal chips or debris on the magnet inside, check it with an ohmeter on the two pins to see what the reading is. It should be around 6 to 10 ohms. If it's not steady, get a new one. Make sure the pins are clean on the connectors.
Apply some white or build grease around the shaft and "O" ring and re-install. Don't overtighten. The bolt is a "tap-tite" and should need only about 5 or 6 ft/lbs torque. (Run it in and give the bolt a quarter turn.)
Posted on Apr 15, 2009
It's your speed sensor at the transfercase on the drivers side i believe. Check the wire and clip to the sensor for any break or loose contacts.
Easy fix and is about a 30 min job to do with simple tools. Un-clip the wire conntection, remove the retainer bolt and slide and sensor out. To install just do everything in reverse and add transmisson oil if needed.
Most of the time, it's going to be the sensor. Keep in mind that there are two sensor's so make sure it's the one on the output shaft at the transfercase. The other one is closer to the front of the transmission on the same side with is the input Volosity speed sensor.
If it was your ABS sensor, you ABS light would come on in your dash.
Good luck and hope this helps
Posted on Apr 23, 2009
It's probably your speedo head, the gauge itself. I put several used ones in our car to no avail. When I finally went to the dealer they needed to know my cars serial numbers then sold me a gauge that matched my car. Sounds goofy but it worked! I didled with this problem for over a year on and off before that.
Posted on Feb 19, 2010
Tips for a great answer:
Apr 02, 2014 | 2001 Ford Windstar
Apr 04, 2013 | 2006 Dodge Magnum
May 17, 2012 | 2002 Jeep Liberty
Jan 04, 2012 | 1995 Mercedes-Benz C-Class
Jul 07, 2011 | 2000 Honda Civic
Jan 21, 2010 | 1996 Volkswagen Passat
Apr 28, 2009 | 2002 Kia Sedona
Jan 12, 2009 | 1991 Honda Accord
60 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: