Question about 1999 Chrysler Cirrus

Open Question

My '99 Cirrus stalled 3 times in 2wks. usually when I made a lane change, slowed to make a turn, or turned into a parking spot. Southside in Red Deer had 3 stalls after a cold start, but after checking and cleaning and replacing a plug and gasket, still couldn't find anything that should have caused trouble. I will test drive it carefully for a week but am unnerved about driving on the highway in case it stalls again. I would not trade it and pass the problem to a new owner if the problem cannot be solved. Your service bulletin suggests installing a (very expensive) revised EGR valve. Has this proved to be succesful in other Cirrus owners' experiences?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ajkill
  • 2035 Answers

SOURCE: Please Help 97 Chrysler Cirrus Stalling out

Could be alot of things. If it runs good when cold and gets worse when warm, at low RPM, it may be the EGR valve. May just need cleaning. A plugged fuel filter won't cause the light to come on, but it will cause a lean condition, which will. Possibly a bad crank sensor, they have been known to have trouble at the connection, check it to make sure it's clean and tight. it's on the pass side, at the rear, were the motor & trans bolt up. first things to do are to make sure the battery connections are clean and tight. Then replace the filter..Please click on this link its the service manual ,,,

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800895f2



Good luck..

Posted on Sep 15, 2008

  • 1 Answer

SOURCE: 1992 Chrysler LeBaron 3.0 L.

the owner probably rerouted the fuel line because like my 92 chrysler lebaron v6 3.0 the fuel lines keep seeming to come off and the clamps always break. I have replaced the clamps 5 times in a month and replaced filters 2 times in 2 months. The only thing i could think of is that your fuel is being cut off possibly because there is no filter to clean all the junk out. Try putting a fuel filter on and see if that will work

Posted on Feb 09, 2009

billie17
  • 84 Answers

SOURCE: Town & Counrty stalls while driving

i am not shure...but i am guessing that there is a problem with the injector in that cylinder......

the tip of the sprayer is probably clogged!...

but i am not shure......

have you check the fuel filter...too?

or the fuel pump?

what about the oil pressure?

i hope this helps some...XD

Posted on Mar 24, 2009

  • 1 Answer

SOURCE: Engine misfires afterinstallion of Egr valve, distributor module,CPS

I HAVE A DODGE CARAVAN 2005 3.3L.IT MISFIRES AT 100KM/H THE SCA TELLS ME THAT THE GR VALVE IS FAULTY .NO2 CYLINDER MISFIRES. CAN IT BR TRUE

Posted on Aug 31, 2009

  • 37 Answers

SOURCE: The car starts OK. When driving, sometimes the engine stalls and suddenly starts again and starts accelerating at the same time.

Before you tear apart and replace the whole car like I did, you have THREE converters on that car. The front two are part of the y-pipe and one on center pipe. Vacuum check when hot or look under it in the dark after running about twenty minutes, any glowing red in converter. you need to clean or replace. vinegar and distilled water soaking, it can be done, will help clean the y-pipe one, the other is 75 bucks aftermarket and worth the change.

Posted on Sep 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why doe;s my 97 Ford expedition stall only when turning into a parking place or my drive way?


there is a sensor that will increase engine revs when turning at slow speed , i expect this is the issue, to check get the OBD codes read to confirm

Oct 23, 2014 | Ford Expedition Cars & Trucks

1 Answer

My 99 subaru legacy 2.5 feels like its going to stall when im turning at slow speeds like about to park.


if you are turning the wheel all the way until it stops then you are putting the steering pump in a bind cuasing the engine to slow down more causing the engine to stall ,,, recommend you turn the steering wheel all the way you are going until the wheel stops and then back the other way a little bit to stop this binding,, shoulsd stop your problem

Mar 28, 2010 | 1999 Subaru Legacy

2 Answers

99 Pontiac Grand Prix. When car slows down or


There are SO many things that could be to blame, such as a relay sticking in the Engine Management System, which controls fuel cut-off on deceleration, for example.

Have you changed the fuel filter yet?
If it's the original on a 99 model and a previous owner has run the tank dry, it will have sucked dirt into the filter.

Otherwise, the fuel pump may not be working efficiently.
Does the engine sound ok and maintain steady revs, around 850/900rpm when it's started up?

Nov 17, 2009 | 2000 Pontiac Grand Am GT

1 Answer

My 200 Tahoe stalled pulling into a parking spot


sounds like an Ignition control module,check for spark immediately after it dies.the spark should should be strong even up to a half of an inch gap

Oct 30, 2009 | 2000 Chevrolet Tahoe

1 Answer

I have a cirrus with a 2.4 engine that stalls. You have to stop and put the car in park turn key off wait for about thirty seconds and the car will restart. I f you do not turn key off and leave it in on...


> If you do not turn key off and leave it in on position when the car stalled it will not start.
I have three vehicles that all are built this way; that action is a safety feature. The problem you have is with the stalling, not the cycling of the ignition switch.
Have the computer scanned; check with any local chain auto parts store in your area to ensure that they offer the service free of charge but all I know do.
There are a number of reasons for the engine to stall:
- Fuel pump - A relay going intermittant - Ignition switch itself failing - Coil pack (ignition coil) failing
Some of these problems should show up as an error code in your car's computer.

Oct 16, 2009 | 2000 Chrysler Cirrus

1 Answer

Jaguar X type 2.2 diesel stuttering


Had difficulty pulling away from a car park, massive loss of power resulted in car stalling when applying throttle and huge greyish smoke. I now beleive that this is the problem the resulted in the abrupt car stalling on motorway thankfully on the slow lane. It just stopped dead. What caused this

Oct 07, 2009 | Jaguar X-Type Cars & Trucks

2 Answers

New clutch in Ford Escort wagon, new problems


Take it to a real mechanic. The last guy must have been a parts re-placer and messed up other components.

May 19, 2009 | 1994 Ford Escort

1 Answer

Stalling when turning into parking spots


take it to a dealer and have a new air flow control sensor ?? i think its this one but i could be wrong so get a dealer mechanic on it ,they should be able to do it with their eyes shut

May 17, 2009 | Ford F-150 Cars & Trucks

1 Answer

02 escalade, vehical stalls at low idle


if it has over 40,000 miles on it change the drive belt and have the alternator tested and also make sure all of the vaccum lines are on and in place

Mar 06, 2009 | 2002 Cadillac Escalade

Not finding what you are looking for?
1999 Chrysler Cirrus Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...