Question about 2001 Daewoo Nubira

1 Answer

I HAVE A 2001 DAEWOO NUBIRA THAT RUNS FINE MOST THE TIME BUT OTHER TIMES IT LOSES POWER AND STALLS.SOMETIMES IT WILL CRANK RIGHT BACK AND STALL WHEN I PUT IN GEAR AND START TO GO.OTHER TIMES YOU HAVE TO LET IT SET FOR WHILE BUT THEN IT WILL CRANK AND RUN FINE. SOMETIMES THIS HAPPENS WHEN I FIRST START THE CAR AND OTHER TIMES AFTER IVE DRIVEN A LONG DISTANCE. WHAT CAN CAUSE THIS FOR VERY TIRED OF SETTING ON SIDE OFF THE ROAD THANKS AND GOD BLESS

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,565 Answers

If I recall correctly there was a recall on the camshaft position sensor. In some cases it would melt.
MAKE: DAEWOO MODEL: NUBIRA YEAR: 2001 DEFECT SUMMARY:
ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.
CONSEQUENCE SUMMARY:
THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.
CORRECTIVE SUMMARY:
DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE. THE RECALL BEGAN ON SEPTEMBER 7, 2004. OWNERS SHOULD CONTACT DAEWOO AT 1-877-362-1234, OPTION 6, OR FIND A LOCAL DEALER THROUGH THEIR WEBSITE AT WWW.DAEWOOUS.COM.

Posted on Sep 15, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 daewoo nubira is hesitating and jolting and it also loses power when pushing on the gas some times.


P0446 - Evaporative Emission Control System Vent Control Circuit Malfunction

This fault will not cause any driveability related symtoms, it just turns on the check engine light. But that is not saying it is impossible. She a trained technician and have further dianostics run on the code.

Jan 22, 2014 | 2000 Daewoo Nubira

1 Answer

What are the torque specifications and tightening sequence for cam journal and cylinder head for 2001 daewoo nubira 2.0 :(


  1. The torque settings for the cylinder head bolts on a daewoo ...

    www.answers.com > ... > Categories > Cars & Vehicles > Asian Car i need how much pression (torque) for head daewoo nubira 2001 2.0 ... What is the cylinder head torque specs for a 2001 daewoo nubira 2.0 litre engine and ...

Apr 15, 2011 | 2001 Daewoo Nubira

1 Answer

My 2991 Daewoo Nubira is overheating. I drive about 10 miles to work. Sometimes I can go days without it overheating. I put water in it before I leave for work and again before comibg home. When the...


Check for the cooling fans working or not,also the thermostat,it can be stuck,and the coolant level maybe dropping and getting air in the system.

Jun 06, 2010 | 2001 Daewoo Nubira

1 Answer

Engine loses power and stalls


try adjusting the throttle position switch very hard to adjust right car will hesitate , not idle properly and hesitate when accellerating if not adjusted properly.

Jan 23, 2010 | 1991 Volvo 740

1 Answer

How do i reset the fuel pump on a 2002 daewoo nubira


how do you mean reset the fuel pump?

if you mean reset the ECU do the following:

1. Disconnect - (minus) battery lead for at least 30 secs.
2. reconnect it
3. turn ignition on and of three times for 5 seconds each.
4. start engine after third time.

ECU reset is complete

Jan 17, 2010 | 2001 Daewoo Nubira

1 Answer

Won't start until switch cycled on and off for


either the fuel is draining back into the tank after you shut it off,or the pump is not putting out enough pressure,it should be at least 50psi to fire the car

Dec 26, 2009 | 2002 Daewoo Nubira

1 Answer

Car runs funny


sound like a blow head gasket :( check to see if there is water/coolant in the oil, look on dip stick.
see if there is oil floating on top of coolant in radiator. does it smoke a lot when it starts ?

Sep 14, 2009 | 1999 Daewoo Nubira

2 Answers

Car suddenly stops in drive,when in idle it runs very ruff


Scan it first. I suspect you might be having fuel related problem.

Sep 02, 2009 | 2001 Daewoo Nubira

1 Answer

2001 golf manual. Is fussy starting but only sometimes and stalls


SOUNDS LIKE CRANK SENSOR OR CLOGGED FUEL INJECTORS

Jul 06, 2009 | 2001 Volkswagen Golf

1 Answer

Timing sincronization crank and cram shafe


Hi. Here are thi information that you need.

I hope this solve your problem,

c638dc9.jpg
This figure is for the crankshaft. look the mark at lower of the cover.

0333190.jpg OK. this figure is for the camshaft . look the marks at uppur of the back cover and on the sprockets.

OK> If this information is good for you Just RATE it.

Thank you for use fixya.

Jul 12, 2008 | 2001 Daewoo Nubira

Not finding what you are looking for?
2001 Daewoo Nubira Logo

394 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...