Question about 2000 Chrysler Sebring

2 Answers

My 2000 Chrysler Sebring JXI cuts off while i am driving, or stopped, have replaced the fuel pump, fuel relay, fuel filter care still cuts out...please help !!

Posted by on

  • paul4bs
    paul4bs Aug 10, 2012

    Hey, there!! Same prob with mine. Did some research on the Internet, and found that it is the IDLE CONTROL VALVE, located right under the throttle body. Costs about $20 on-line. Took me 40 minutes to R&R. Problem solved!! What happens is it gets gummed up with soot from the intake, and doesn't open and close properly. Same with my Sister's car. Same model and model year. SOLVED. Try this. Am sure you'll be pleasantly surprised. Paul

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi,
Since it sounds where this is intermittent, I would be looking to replace the camshaft or shaft speed sensor. I had a similar problem and could not find anything wrong with the car when it ran... So I told my mechanic to replace that, since it is an electrical senor, it is something that can work fine and cut out for no reason. Disabling the car for awhile. Almost as if it gets to a certain temperature that it will not read the speed and the car shuts down as it is programed to do.

Posted on Dec 10, 2011

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

WE HAVE THE SOLUTION.

WE ALSO HAVE A 2000 SEBRING CONVERTIBLE JXI

REPLACE THE IAC AND EGR VALVE, REPLACE ALL SPARK PLUGS AND WIRES; THREE SPARK PLUG ARE HIDDEN UNDER THE MANIFOLD.

CAR NOW RUNS PERFECT!!!!!!

Posted on Oct 03, 2010

  • AMATUER TEC1 Oct 03, 2010

    THE REASON I SAY REPLACE ALL SPARK PLUGS IS BECAUSE MOST AUTO REPAIR SHOPS REPLACE ONLY THREE BECAUSE THEY DONT WANT TO DO THE EXTRA WORK AND REMOVE THE MANIFOLD TO RPLACE THE HIDDED THRE!!!!!.



    OUR CHRYSLER SEBRING CONVERTIBLE IS THE FIRST CAR I HAVE SEEN WHERE A MECHANIC DOES NOT HAVE IMMEDATE ACCESS TO ALL SPARK PLUGS. SERIOUS DESIGN PROBLEM!!!!!! OUR MECHANIC TOLD US THAT AUTO REPAIR SHOPS WILL ONLY REPLACE THREE AND NOT SIX SPARK PLUGS!!!! AND TELL YOU THAT ALL SPARK PLUGS WERE REPLACED.



    YOU KNOW SOMETHING IS WRONG WHEN THE DEALER QUOTES YOU 300 TO CHANGE THE SPARK PLUGS. ALSO MAKE SURE THAT ALL SPARK PLUG WIRE ARE REPLACED, INCLUDING THE HIDDEN THREE.!!!



    THE TWO MAJOR COMPONENTS THAT WILL RESOLVE IDLE AND CUT OFF ISSUES ARE THE IAC AND THE ERG VALVE. INSTEAD OF TAKING THEM OFF AND CLEANING THEM JUST REPLACE THEM. THEY COST APPROX. 40.00 A PIECE. DO NOT BUT THEM FROM THE DEALER. YOU WILL BE RIPPED OFF.


×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Obd2 scanner nolink response for 2000 chrysler sebring jxi limited convertible what can I check for?


Check pin 16 of the OBD2 connector it should have 12 volts key on. Pin 16 is the lower pin on the far right of the bottom row of connectors.

Dec 16, 2016 | 2000 Chrysler Sebring JXi

1 Answer

Where is the fuel filter on a 1996 chrysler sebring convertable jxi


Inside of the fuel tank. Everything is together as a unit...your fuel pump, fuel pressure regulator, and fuel filter.

Feb 11, 2016 | 1996 Chrysler Sebring

2 Answers

My 1998 chrysler sebring convertable wont start I replaced the fuel filter and fuel pump new battery the car will turn over just wont start


Verify you have spark, those are known to have issues with the camshaft sensor in the distributor. I have put 2 distributors in my daughter's 97 sebring jxi, did the same thing.

Jul 22, 2014 | 1998 Chrysler Sebring

1 Answer

Ok here we go i have a 2000 chrysler sebring that i for the life of me cant find the fuel pump relay (yes i have checked both of the fuse panels and nothing is labled for the fuel pump) there is a block on...


Of the 3 relays, one is the Fuel Pump Relay . wires are White/Red, Black/white, Red/black, Black/blue. Black/white and Red/black should have power with key on. Black/blue powers the fuel pump. The computer grounds the White/red to turn the relay on.

Aug 31, 2011 | 2000 Chrysler Sebring

1 Answer

I cannot find my emergency fuel pump shut off switch for my 1999 chrysler sebring jxi


Hi

Fuse # 8 in the power distibution center, under the hood should be checked since it powers the fuel pump relay and the engine startet motor relay.

Good Luck

Rodney

Jun 13, 2011 | 1999 Chrysler Sebring

1 Answer

1999 chrysler sebring convertible jxi code p1495 intermittant shut off while driving. Replaced fuel pump and filter, distributor, spark plugs and wire. Was advised by ZJLimited to remove connector from the...


replacing the fuel pump relay is one thing but what about the (ASD auto-shut down) relay

additionally...
  • what engine size?
  • what transmission?
  • any codes?
  • does the pump run KOEO?
  • Do you have spark?
  • What is the cranking speed?

you may find faster service by subscribing to a "live chat" since there are so many questions and variables in your concern

Jun 03, 2010 | 1999 Chrysler Sebring

1 Answer

Where is the fuel filter located on a 2004 Chrysler Sebring sedan?


Some of the Sebrings have two filters(one is called a sock).The sock(which all sebrings have) is located in the fuel tank itself on the pump module.If this model is the JXI then the external filter is located on the belly of the car between the tank and drivers rear seat. I hope I could help!!!

Apr 29, 2010 | 2004 Chrysler Sebring

1 Answer

Car shut off while driving has has and added oil will not start?


This happens when fuel supply is cut off. Most likely, your fuel pump (located inside the fuel tank) is bad. Check the wiring system and trace the fuse suppling the fuel pump, if blown, you likely have a faulty fuel pump. Might consider changing fuel filter and relay too.

Apr 26, 2009 | 2004 Chrysler Sebring

Not finding what you are looking for?
2000 Chrysler Sebring Logo

1,305 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...