Question about 2001 Mazda Tribute

Open Question

Odometer reset itself to 0.0 and the check engine light is up

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can i reset oil change button?2003 model Toyota hillux extra cap


Turn the ignition key to 'ON' and press the odometer button until the display reads ODO (not Trip A or B).
Turn the ignition key to OFF.
Hold in the same button you used in step 1.
While holding the button in, turn the ignition key to ON.
The ODOMETER will change to:
5 dashes - - - - -
Then 4 dashes - - - -
Then 3 dashes - - -
Then 2 dashes - -
Then 1 dash -
THEN all zeros 0 0 0 0 0
Then back to the correct mileage.
Then the Maintenance Required light should blink and go out.

Aug 03, 2016 | Toyota Cars & Trucks

1 Answer

Maintenance required light is on


If you take your civic into a Honda dealer for regular maintenance they should reset it for you. Even most Lube shops do as well. But if you do your own vehicle services like oil changes (which is what that light is there for) then here's how you can reset it.

  1. put your key in the ignition but do NOT turn it.
  2. press and hold the Odometer/Trip button.
  3. while holding the Odometer/Trip button, turn the key to the ON position but do NOT start the engine.
  4. As you hold the Odometer/Trip button, after about 10-15 seconds the Maintenance required light should turn itself off.
  5. Once the Maintenance required light is off, turn the key into the off position then release the Odometer/Trip button.
That should do it. Hope this helps

Aug 20, 2014 | 2004 Honda Civic

1 Answer

2001 Rodeo 3.2 LS the odometer will not go past 999 miles, it somply resets itself to 0.


Are you sure its the odometer? Sounds like a Trip meter. Try pushing the reset button on the instrument panel and see if it changes to something else.

Aug 25, 2011 | 2001 Isuzu Rodeo

1 Answer

Engine service required message


If you want to reset the light/message:

Close all the doors, booth, hood etc. hatches,

1. Make sure you have Trip odometer 1 (T1) selected.
2. Turn the ignition key to 'I'-position.
3. Press the trip odometer reset - keep it down.
4. Turn the key to 'II'.
5. Wait till the service light blinks a few times or you hear a 'beep'.
6.Release the trip odometer reset.
7. Turn the key back to '0' - service light is reset.

If this doesn't work, try:
a) 2. before 3. then continue as above
b) 5. Wait until the previous mileage appears again to the trip odometer.
c) 7. before 6.

You can reset the service counter at any time. Do not forget to service your car!

Jun 06, 2010 | 2002 Volvo S60

1 Answer

Where is the butten to turn of the service light on dash


Put the ignition in OFF, press the odometer button, and keep pressing, then turn the ignition to the 2 position (just short of starting the engine). After 10 to 15 seconds of pressing the odometer button, the service light should go off, and reset itself.

May 20, 2010 | 2002 Honda Accord

3 Answers

The digital odometer reads "error" and the engine hrs.screen reset itself to zero. Can I reset the computer by diconnecting the battery?


Yes take your battery terminals off and hold them together for about 10 seconds that will reset your computer.

Sep 23, 2009 | 2005 Chevrolet Silverado 1500HD

1 Answer

2001 Focus: Speedometer at 0, blank odometer, rough shifting


needs a vehicle speed sensor, its on the trans. if the engine was just put in( within like 2 or 3 days, not weeks) then it may have been busted in the engine swap. hope this helps and good luck

Jun 08, 2009 | 2000 Ford Focus

1 Answer

Dash lights on and clock resets. 2003 Jetta


To fix the clock and the odometer I just had to make sure there was a fuse in both places 11 and 15. I have a standard trans and one place I thought was for auto trans instrument panel lights. But both must be there. The engine check light also went off but the airbag light is still on. I was wanting to avoid going to the dealer, but I might have to so they can reset that.

Apr 10, 2009 | 2003 Volkswagen Jetta TDI

4 Answers

2008 Scion TC Warning Light


This is already covered in the owner's manual, but here it is again as a quick reference.

Every 5,000 miles, a "Maintenance Required" light will blink for the first couple seconds after you start your car. It will continue to do so until it is reset. If it is not reset, than it will eventually turn on your "Check Engine" light. The purpose of the maintenance required light is to remind TC owners to change their oil. The factory recommended interval is 5,000 miles, but you can reduce the interval the light will come on to a mileage interval of your choice.

1. Before starting, make sure that the odometer is not on one of the trip mileage odometers but is displaying the standard odometer.

2. With the car off, press and hold down the odometer reset button. While still holding it, start the car.

3. The light should continue to blink for a couple seconds and than disappear. That will reset the light for another 5,000 miles.

4. The following are steps to change the interval in which the maintenance required light comes on. Right after you turn on the ignition while holding the reset button, you'll notice that the odometer display will show 5 bars. Each bar corresponds to a 1,000 miles. As each bar disappears, the interval will increase (0 bars = 5k, 1 bar = 4k). Release the reset button at the interval you desire.

Jan 23, 2009 | 2008 Scion Tc

Not finding what you are looking for?
2001 Mazda Tribute Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...