Question about 2000 GMC Savana

Open Question

How do you remove the oil pan from a vortec 4.3 2000 gmc savana

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1596 Answers

SOURCE: Oil Pan Gasket Replacement - How to - GMC Yukon 2000








Removal Procedure

Important: The original oil pan gasket is retained and aligned to the oil pan by rivets. When installing a new gasket, it is not necessary to install new rivets.
DO NOT reuse the oil pan gasket. When installing the oil pan, install a NEW oil pan gasket.

Caution: Refer to Battery Disconnect Caution in Service Precautions.

  • Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
  • Remove the front differential if equipped with four wheel drive. Refer to Differential Carrier Assembly Replacement in Front Axle.
  • Remove the under body shield from the vehicle
  • Remove the oil pan underbody shield.
  • Remove the cross brace if equipped.
  • Drain the engine oil and remove the engine oil filter. Refer to Engine Oil and Oil Filter Change
  • Remove the lower transmission-to-oil pan bolts
  • Disconnect the oil level sensor electrical connector.
  • Remove two front wiring harness retainer bolts.


10. Remove the engine wiring harness retainer bolts from the engine oil pan.
11. Remove the engine oil cooler pipe to oil pan bolt.
12. Remove the transmission oil cooler pipe retainer and the bolt from the oil pan.
13. Remove the starter motor. Refer to Starter Motor Replacement.
14. Remove the left closeout cover and bolt.
15. Remove the engine oil pan. Refer to Oil Pan Removal.

Installation Procedure

Important: The alignment of the structural oil pan is critical. The rear bolt hole locations of the oil pan provide mounting points for the transmission bellhousing. To ensure the rigidity of the powertrain and correct transmission alignment, it is important that the rear of the block and the rear of the oil pan must NEVER protrude beyond the engine block and transmission bellhousing plane.

Will Send Remainder in another this place dont take kindly to larg files Your Email Address would realy be Better Then I could send Pictures Also up to YOU

Posted on Jan 27, 2009

whitehorse02
  • 11 Answers

SOURCE: oil pan

Have you tried getting a screw driver and prying at it?

Posted on Oct 21, 2008

  • 116 Answers

SOURCE: Need to remove the fan to replace the water pump

you need to get a fan clutch wrench to remove the fan you can get one at any local autozone or murphys parts stores

Posted on Dec 10, 2008

emissionwiz
  • 75807 Answers

SOURCE: cant find the location of this oil pressure switch on my 1999 gmc savana 1500 van with a 350 engine

very rear of engine center of block behind intake.

Posted on May 12, 2009

fixitriteman
  • 431 Answers

SOURCE: need to replace fuel pump on 2000 Gmc savana how

It is in the gas tank ,not hard depending on your experience ..But safety is a big concern . Don't use a incandescent light , or allow any one around smoking . Also have a fire extinguisher handy , and some help . Be careful not to cause any Sparks . if this helped please let us know .if i can be of any further assistance please ask, Thank You.

Posted on Mar 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1996 gmc serria 1500 4x4 v6 vortec manual I can't seem to find the oil plug for the trannie it seems to me it's part of the transfercase help


Most vehicles do not have an oil drain plug for the tranny...you have to drop the pan to change the oil. Make sure you install a new gasket when you put it back on.

Jul 17, 2013 | Cars & Trucks

1 Answer

What's is the torque specs for a 2002 se Pontic


90 inch pounds or 8 foot pounds. Good luck. Scott

Aug 29, 2011 | 2002 GMC Savana

2 Answers

Can you telkl me were the oil pump is located on a 2005 gmc savana 2500 6.0 v8 vortec engine i have very low to no oil pressure and lot of noise from engine but seem to stop when i put oil in the motor


most pumps are in oil pan. remove oil pan and it is attached to under side of engine. remove the boltson oil pump, and thars it. be sure to clean mateing surfaces up good.

Mar 25, 2011 | GMC Sierra 2500HD Cars & Trucks

1 Answer

Vortec 4.3 engine v6 oil leaking about one quart a week. could it only be the oil pan leaking?


There are alot of places where oil leaks out. The most common places on this engine are the front and rear crankshaft seals valve cover gaskets and yes, the oil pan.

Feb 07, 2011 | GMC Jimmy Cars & Trucks

4 Answers

I have a 2003 gmc sierra 5.3 liter vortec why does my truck leak oil only under pressure


because your oil pressure rises to around 40psi when running and will leak at the weakest place,check your oil sending unit first and seals.






Tim

Oct 20, 2010 | GMC Sierra 1500 Cars & Trucks

1 Answer

Whats needed to convert 1996 from 5.0L vortec to 5.7L vortec


hi all the exturnel parts are the same a 350 will go right in .the valve covers,intake oil pan all the same

Jul 20, 2009 | 1996 GMC Sierra

1 Answer

Need to remove the fan to replace the water pump


you need to get a fan clutch wrench to remove the fan you can get one at any local autozone or murphys parts stores

Dec 10, 2008 | 1997 GMC Savana

Not finding what you are looking for?
2000 GMC Savana Logo

Related Topics:

603 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...