Question about Mitsubishi Lancer

1 Answer

I have a 1992 lancer ..where can i find the distributor cap..

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 313 Answers

At your local parts shop or if you mean the location in your car then that would a black circular object with lots of wires going from it to your spark plugs in the engine.

Posted on Sep 15, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why is there no spark to the plugs on a 2002 miata

When a car cranks normally but does not produce a spark, you back up the way and check for:
A bad crankcase positioning sensor
A bad ignition module
A bad ignition coil
A problem inside the distributor cap (if your car has a distributor cap)
A faulty ignition switch.

I hope that helps.

Aug 19, 2014 | 2002 Mitsubishi Lancer

1 Answer

I have a 1992 honda civic and we didnt have spark in any cylinders so we replaced the ignition coil and it started but not running good they put a code reader on and got an error code 9 they said to...

hondas of that era are notorius for bad distributors. they tend to fill with engine oil under distributor cap. i would check the distributor cap and rotor before replacment.

Nov 27, 2010 | 1992 Honda Accord

1 Answer

How to do a tuneup

Hi, disconnect the 3 harness attached and the distributor cap and/or spark plug wires. Remove 3- 12mm bolts. Pull disconnect the 3 harness attached and the distributor cap and/or spark plug wires. Remove 3- 12mm bolts. Pull on the distributor. When re-installing reiverse the process. Make sure that the distributor shaft is line up with the on the distributor. When re-installing reiverse the process. Make sure that the distributor shaft is line up with the notches on the cam. It only fits on way. If in one position dont fit. turn the shat 180 degree.
Take care

Aug 02, 2010 | 1992 Honda Accord

1 Answer

I have a 1992 Ford Aerostar 3.0 liter 6Cyl. Where is #1 on distri

Facing the engine from the front, with the cap on, the #1 slot is on the left hand side of the cap, the last one just before the clip, the distributor rotates clockwise. After #1 then 4,2,5,3,6, going clockwise.

Apr 11, 2010 | 1992 Ford Aerostar Extended

1 Answer

Code 17 on a mazda 626 1992 lx what does it mean

The OBD-1 two digits trouble codes listed 'code-17' as:
Oxygen sensor.

This means that the fuel and ignition systems performance are in need of attention.

1.Distributor Cap: remove the 3-bolts holding the distriboutr to its body.
2. Inspect the distributor cap for cracks, and the roror-button is not worn or broken.
3. Inspect the distributor-cap terminals are not corroded or charred. Replace if charred. Clean them out if corroded.
4. Check the distributor-rotor for cracks or corrosion on its tip, and lesser spring tension.
Replace as necessary.
5. Reverse steps 1-4 to re-install distributor cap. Be sure to remove and replace the plug wires from the old distributor-cap to the new distributor-cap one-by-one. If not, the engine would not run.

1. Undo the top clips holding the fuel-filter hose, and undo the lower clips also.
2. Take out the fuel-filter from its mount.
3. Replace the fuel filter as necessary.(please not the way it was mounted) Reverse removal for installation.

Dec 11, 2009 | 1992 Mazda 626

1 Answer

No spark in one coil pack on my 02 lancer

just replace the coil pack should cost around 25 dollars to replace then check the distributor cap to ensure good condition

Nov 04, 2009 | 2002 Mitsubishi Lancer

1 Answer

I cant see the wires goint to the spark plugs,

they come off the distributor cap to the plugs

Aug 21, 2009 | 2008 Mitsubishi Lancer

2 Answers

2002 lancer miss fires at low rpms

Check Plugs/ check compression.

Aug 15, 2009 | 2002 Mitsubishi Lancer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides