Question about Nissan Pickup

1 Answer

Will the MAF sensor cause my 1994 nissan pickup (4 cylinder to shut off when you stop? Truck is hard to start, you have to hold accelerator pedal all the way down to get it started. It runs fine at idle. I have replaced the fuel pump and filter, the distributor, wires and plugs.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 432 Answers

Good Evening, if your truck runs fine at idle it would make me wonder about the mass air flow sensor, however when you first start it your idle air control sensor should open up and let your vehicle to idle up to warm idle and then back to normal. So there are a few things to check.

Posted on Sep 15, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How can i fix a acceleratioproblem in a 08 nissan altima car

How does removing the MAF sensor "fix" the problem? MAF is THE most important sensor for the engine to run, while it may be your problem there should be an MIL on. Get the code for a clue to your problem

Sep 01, 2014 | 2008 Nissan Altima Hybrid

2 Answers

My brake lights will not engage when i press the brake pedal

fuse, relay, or bad connection.
check the rubber plug between the switch and mount, they fall out and can cause lights not to work.

Also check grey connection for rear lights under the bed of the truck. Sometimes gets loose or too dirty.

There have also been dealer recalls for this problem, so google TSB 1994 nissan pickup and look around.

hope this helps

Dec 10, 2012 | 1994 Nissan Pickup

2 Answers

My 2000 maxima gxe has started to die when I stop. It is hard to start sometimes too unless I pump the gas pedal. Can you help?

Check fuel pressure regulator, use a good fuel pressure gauge to check fuel pressure, when was the last time u changed your fuel filter

Jun 14, 2010 | 2000 Nissan Maxima

3 Answers

'97 Nissan pickup truck mass airflow sensor malfunction?

Always replace with a new or working used one. I have never heard of rebuilding a MAF sensor!!

Mar 15, 2010 | 1997 Nissan Pickup

1 Answer

85 Nissan stalling, popping noises.

mcdevito75 here, Sounds as though you have a worn or broken timeing belt, or problem with -in the ignition system of the engine. Have the shop check it out for you.

Feb 21, 2010 | 1992 Dodge Dakota

1 Answer

My 1994 nissan hardbody 2.4liter has a high idle problem

hi,the accelerator pedal can be blocked, which causes it to have a high idle.well what you have to do is to see for the cable for the accelerator, which come on the injector you will see the cable attach to a rack on the injector pump,this rack has a movement position ,when you press the accelerator pedal it moves to the accelerate what you have to do is to move the accelerator rack to the decelerate position,then after doing that start the engine,see the idle what it should be lower now,put some penetrate oil to the accelerator rack,for the move to be free.hope that help you

Aug 25, 2009 | 1994 Nissan Pickup

1 Answer

1984 Pickup

Your slave cylinder for the clutch is leaking. It's on the bottom of the transmission towards the engine (follow the fluid trail!). Though it's not too difficult to replace, it IS messy. And be careful with what you touch when you have that fluid everywhere, it eats paint. Usually a new slave will come with detailed instructions on how to properly install and bleed it.
Good luck!

Jan 04, 2009 | 1992 Nissan Pickup

1 Answer

Looses power and shuts off

I had a similar problem. I changed the distributor cap myself for less than $20 and it fixed the problem.

Nov 17, 2008 | 1997 Nissan Pickup

2 Answers

Strong fuel smell

You more than probably have a gas leak somewhere in the fuel system. If you can smell gasoline, it is leaking somewhere. The lines run along the frame to the engine. The leak might be hard to see or hidden (on top of the fuel tank).

The leak is robbing fuel pressure from the engine, causing it to idle rough, so is probably on the pressure side of the system.

(Most fuel systems, except for "returnless" systems with Pulse width modulated fuel pumps (not very common), have a pressure line and a return line to the tank.

Aug 19, 2008 | 1994 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

265 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides