Question about 2006 Dodge Dakota

Open Question

Oxygen sensor in a 2006 dodge dakota 4x4 where is it located

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 11 Answers

SOURCE: CAMSHAFT SENSOR

Look behind the distributor on the left, actually on the bell housing.

Posted on Oct 14, 2008

  • 1 Answer

SOURCE: location of dodge neon 2005 oxygen sensor

ask at the parts store where i bought the part

Posted on Jun 08, 2008

emissionwiz
  • 75822 Answers

SOURCE: Oxygen Sensor

Bank 1 is the side that has # 1 cylinder in it, the sensor is located in the exhaust head pipe before the Cat Converter, one note of caution: an O2 code does not always indicate an O2 sensor problem, it depends if the code is a lean code or a rich code, lean may may be a sensor, rich is never a sensor, lean codes can be caused by all kinds of issues, a bad MAF, a vacuum leak from hoses or a leaking intake gasket, an injector problem and so on. Good luck hope it is the sensor.

Posted on Aug 30, 2008

  • 11 Answers

SOURCE: oxygen sensors in a 2004 dodge ram 1500 4x4

im not for sue how many but u need to take it to autozone if u have one where u live they will tell u where it is the most comon one if u have straight eguast is the one right in front of the cats if its that one u should notice a stall out every time u fill up from below empty on ur gauge

Posted on Mar 18, 2009

Molson02536
  • 3854 Answers

SOURCE: location of oxygen sensor

I believe you may have three (3) O2 sensor, (2) of the sensor is on ether side of the exhaust down pipe and some times called up stream O2 sensor, the third O2 sensor know to some as the down stream O2 and is after the Catalytic converter.
The up stream O2 monitors the left and right side banks and sends signals to the ECM to make the adjustments to the injectors to keep the proper air/fuel ratio. 
The down stream O2 monitors the catalytic converter and sends signal to the ECM if the catalytic converter has gone bad.
Good luck and hope this helps. If you get it scanned at Auto Zone, they should be able to let you know which O2 has gone bad so as to not change all three. You could always check the wire harness to the down stream O2 for corrosion. Keep me posted

Posted on May 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 DODGE DAKOTA V6 4X4 : TAKE IT OUT ON THE INTERSTATE DOING 65-75 MPH. AFTER ABOUT 100 MILES IT WILL STARTJERKING AND THE SPEED DROPS ALL THE WAY DOWN TO 40 MPH WIDE OPEN THROTTLE. LET SIT FOR 5 M


If you think the fuel pressure is ok, it could be something electrical such as the coil breaking down when it gets hot.
Is the check engine light coming on when the problem happens ?

Apr 12, 2013 | 1995 Dodge Dakota

1 Answer

I had a P0138 code after a diagnostics test on my 2006 dodge ram 1500 4X4, what does this mean?


P0138 DODGE - O2 sensor 1/2 Circuit highxicon.jpghttp://engine-codes.com/p0138_dodge.htmlForum CodePossible causes- Rear Heated Oxygen Sensor Bank 1 harness is open or shorted
- Rear Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Faulty Rear Heated Oxygen Sensor Bank 1
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks Tech notes Replacing the rear O2 Sensor bank 1 usually takes care of the problem.

Jul 09, 2012 | 2006 Dodge Ram 1500

1 Answer

2005 Dodge Dakota V8 4.7L, 4X4, engine light on, code P0452 . Where is the fuel pressure sensor located?


  1. The Fuel Level Sending Unit, or Fuel Level Sensor, is located in your gas tank with the Fuel Pump Module. The fuel gauge sending unit (fuel level sensor) is attached to the side of the fuel pump module. The sending unit consists of a float, an arm, and a variable resistor track (card).
  2. The Fuel Pressure Regulator is located within fuel pump module. The fuel pressure regulator controls fuel system pressure. The PCM cannot detect a clogged fuel pump inlet filter, clogged in-line fuel filter, or a pinched fuel supply or return line. However, these could result in a rich or lean condition causing the PCM to store an oxygen sensor or fuel system diagnostic trouble code.
Both of these sensors are connected with the Fuel Pump Module. Here is a diagram:
pctech1_33.jpg

Mar 10, 2011 | Dodge Dakota Cars & Trucks

1 Answer

I have a dodge Dakota 2002 4.7 liter I have a fault code that reads p0155 do you know what that is? thanks Ron


O2 Sensor Heater Failure Oxygen sensor heater element malfunction solution replace the oxygen most likely the one located in the cat. converter make sure the replacement is original equipment(oe)

Sep 26, 2009 | 2002 Dodge Dakota Club Cab

1 Answer

Oxygen sensor


Hi bank 2 is reffering to the side of the engine that the #2 cylinder is on and sensor 1 will be the one up infront of the catylitic converter toward the engine!

Aug 08, 2009 | 2002 Dodge Dakota Club Cab

1 Answer

Location of oxygen sensor on 2004 dodge dakota


One of them is located on the driver's side of the motor and connects to the exaust manifold.

May 22, 2009 | 2004 Dodge Dakota

1 Answer

Oxygen Sensor


Bank 1 is the side that has # 1 cylinder in it, the sensor is located in the exhaust head pipe before the Cat Converter, one note of caution: an O2 code does not always indicate an O2 sensor problem, it depends if the code is a lean code or a rich code, lean may may be a sensor, rich is never a sensor, lean codes can be caused by all kinds of issues, a bad MAF, a vacuum leak from hoses or a leaking intake gasket, an injector problem and so on. Good luck hope it is the sensor.

Aug 30, 2008 | 1997 Dodge Dakota

Not finding what you are looking for?
2006 Dodge Dakota Logo

Related Topics:

986 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...