Question about 1991 Jeep Wrangler

Open Question

1991 jeep wrangler fuse layout, what fuse covers the dash lights

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: Jeep wrangler Fuse box

i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck

Posted on Jun 30, 2008

Ad
  • 3 Answers

SOURCE: 1995 jeep wrangler dashboard lights don't work. it's not the fuse

are all dash lights out???

Posted on Jan 14, 2009

emissionwiz
  • 76846 Answers

SOURCE: 1991 jeep wrangler clutch

U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.



1abd4ec.jpg

Posted on May 13, 2009

  • 12 Answers

SOURCE: Removing doors from Jeep Wrangler - Dome Light Stays On

I have a 97, and my fuse for that is behind the glovebox. Open the box, slide the end of the strap to disconnect it, then remove the box. The fuse is marked. Something like "Dome lt. elim." I think it's located one up from the bottom right. This can actually be done without removing the glove box. For a more permanent fix, quadratec.com has a switch that plugs into the fuse location and mounts under the dash, so you can just flip the switch. Hope this helps.

Posted on Jul 14, 2009

  • 5 Answers

SOURCE: my 1990 jeep cherokee dash lights fuse blows

it might not be that. check your headlamp relay. i know sounds weird but just do it. when i bought mine it had already been replaced with the wrong one so it kept blowing it and the radio. replaced with stock part and just like that no more problems. hope it helps

Posted on Aug 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is reverse light fuse on1991 jeep wrangler?


It is in the main fuse panel ?? are you sure it is a fuse problem not the reverse switch itself ? or one of the bulbs out ?

Sep 26, 2014 | 1991 Jeep Wrangler

1 Answer

Diagram of 92 wrangler fuse box


alldata.com

or
93 yj
might work?

http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

or get the operators guide, missing from glove box.
it covers fuses.
and Rev back fuse is marked on cover
as is TAIL (park and dash.)

Aug 12, 2014 | 1992 Jeep Wrangler

1 Answer

The lights under the dash (by your feet) stay on (2001 Jeep Wrangler). What fuse is that or what to do?


join a wrangler forum find it by googleing wrangler forums or try 2001 jeep wrangler fuse layout

Feb 06, 2013 | 2001 Jeep Wrangler

1 Answer

How do you check the clutch fluid on 1991 Jeep Wrangler?


There should be a small master cylinder for the clutch right next to the brake master cylinder, mounted more towards the fender. Remove the top cover and look inside. Regular brake fluid is used in the clutch system. If it's low, likely you have a leak so check where the rod goes through the firewall under the dash, the line itself and the slave cylinder (some are outside the bellhousing, others are inside and fluid will leak from the bottom of it.

Jun 15, 2010 | 1991 Jeep Wrangler

1 Answer

I Need to see the fuse box diagram for a 1991 jeep wrangler


I'm assuming you mean the box under your dash

if this isn't what you want let me know
88cf226.gif

Apr 05, 2010 | 1991 Jeep Wrangler

1 Answer

2003 jeep wrangler: all exterior lights went out except for headlights and fog lights. Dash lights also out.


Have you checked the fuses?

Headlights are usually on a fused link or fused differently than the rest of the lights. Fog lights are an option, so they would have separate wiring. All other exterior lights sounds like a fuse.

Aug 29, 2009 | 2003 Jeep Wrangler

1 Answer

"maintenance required" light is stuck on in 1991 Jeep Wrangler


On the dim dashlights, there is usually a rotory switch that you can turn to increase the power to the dash lights. In earlier vehicles it was part of the headlight switch and you just turned it one way or the other to adjust the brightness. In newer vehicles it is a switch like a knob sticking out of the dash on its side that you push up or down to change the brightness of the lamps.

The Maintenance Required light is probable on because the vehicle has hit the 50,000 mile mark and it comes on automatically so that you take the vehicle in for maint. of the emission system. If this is the case there is usually a way to reset it untill another 50,000 miles go by. I would read the owners manual, or better yet pickup a Chilton manual for the vehicle and see if it says how to reset the light. You also may want to have the vehicle checked to see if any trouble codes have been signaled. Good Luck, RAC

Apr 19, 2009 | 1991 Jeep Wrangler

1 Answer

1991 jeep 4wd fuse


Check transfer case wiring, possible loose wiring/open circuit. If your other lights in dashboard work such brake light, seat belt lights, engine light than it is not a fuse. raise all for tires from the ground and engage the four wheel drive remember to have in neutral and put in gear either 4L or 4H and see if the wheels in front move.

Apr 04, 2009 | 1991 Jeep Wrangler

1 Answer

No lights work on instrutment panel


Check 2 fuses. Instument lights / panel and also the brake light fuse. Sometimes the brake light fuse blows and you have no dash lights.

Apr 03, 2009 | 1991 Jeep Wrangler

Not finding what you are looking for?
1991 Jeep Wrangler Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...