Question about 1995 Dodge Ram 2500

1 Answer

It wont start the engine rotates but wont start checked the plugs and wires to see if there was spark and there wasnt any put a coil pack from another truck that was good just dont know what to do now other then follow all the wires and make sure they are all good any suggestions are very welcome

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

CAM POSITION SENCOR ON TOP OF TRANSMISSION :)

Posted on Oct 19, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I changed spark plugs on my 01 jeep grand cherokee it was running but turned off on me now it wont start anymore.


which engine?
2001 WJ , jeep.
wrong spark plugs!
gapped wrong!
wrong wire order?
do tell engine you have there.
do tell park plug brand and numbers.
do tell if engine has coil packs, how many, and how you wired them back..
now answering for USA cars, (not exports. or those jeeps made in Europe. )

the 4.0L engine with the 3 coil rack pack? with 6 spark wire sets?
the 4.7liter has 6 coil packs coil over plug COPS.
that can not be wired wrong but could be unplugged in primary side.

my guess, wrong parts, wrong gap
or not reconnected right.
if spark is lost, scan the PCM cranking, look for DTCs/

Dec 24, 2015 | Jeep Cars & Trucks

1 Answer

Pontiac 3400 misfire problem one new coil pack new plugs and wires on still running bad have too press gas too start now bad fuel mileage unburnt fuel smoke when engine starts for a few seconds then stops...


some of the cylinder wont get spark, faulty spark plug, wire or coil. To check pull all spark plugs out, plug them to the wires and put on the engine top and then cranck the engine to see which spark plug not giving a spark

Apr 16, 2014 | Cars & Trucks

1 Answer

Please help 1996 chrysler town and country misfire


i have a1996 t&c had same problm,replaced,coil,cam sensor,crank sensor,wasnt it,put pcm in,saloved the problem,probly,pcm

Mar 31, 2012 | 1996 Chrysler Town & Country

1 Answer

It was running fine and then all of a suddun its running rough, it wont shift over and the engine light is blinking.. its a custom 2001 buik century. we need to fix the car so we can get back and forfth to...


flashing engine light means engine misfire. let car idle and mist the plug wires down with water, rev the engine up and down and look for little sparks jumping from the wires. and arcing wires can cause problems. before changing any bad wires check the coil packs where the wires plug in the three small boxes on the top back of motor. they are three packs with two wires each. one pack at a time take the two wires off to reveal the coil towers. have an assistant start the motor and make sure the spark goes from tower to tower. repeat on remaining two packs. if the spark goes straight down the tower the coil needs replaced. if there is no spark, the coil needs replaced.

Sep 01, 2010 | Buick Century Cars & Trucks

1 Answer

1998 Pontiac transport van wont start:


Well you hit all the major ones, could be crank position sensor, ignition module, a bad coil pack (it should have 3), you need to check that you have spark to each plug while the engine is turning over (!!!be careful as this will hurt if you get shocked!!!), this will rule out coil packs. if you have no spark to any plug your looking at a bad ingnition module (which is what the coil packs bolt to). Hope this gets you on the right track!

Feb 08, 2010 | 1998 Pontiac Trans

1 Answer

Would crank but would not start in extremely cold weather. Now it won't start at all but fires on and off.


Do a tune-up, Plugs, rotor button and distributor cap. Not sure if your model has a cap or coil pack. When you say fires off and on do you mean it starts off and on or you get ignition spark off and on. If you have a cap, the rotor button can get worn down and not make good contact with the contacts inside the cap. When engine rotates the rotor button rotates inside the cap which produces spark through your plugs wires. If you have a coil pack, it could be going bad. If coil packs get moisture within it and diffuses the spark from going into the plug wires. Moisture and wetness causes a lot of problems with the ignition system, so it's best to apply Di-Electric Grease to the coil pack, wire boots on both ends. The grease stops moisture from getting into the components and sparks from jumping to the moisture.

Jan 17, 2010 | 1994 Honda Accord

1 Answer

Engine wont start. Acts like it is hitting on two cylinders. Need advice on how to check the coil packs.


Start engine, used spark plug piler so you don't get shock, remove one wire at a time if you dot' have spark replace that coil pack, there is three coil pack on top of ignition module you don't have to replace all, just bad one.hope this help.

Nov 28, 2009 | 1995 Pontiac Bonneville

1 Answer

CAR WONT CRANKS BUT WONT START


There is an easy way to determine wether your getting spark or not. Take a plug wire off a spark plug and put it next to a solid piece of metal like a bracket (somewhere you can see the end of the wire sparking) hold the wire behind the connection point, and crank the engine (have someone help). If you see a spark, you are getting spark to the plugs, but may still have a problem with the coil pack. There is only one way to find out. Take the coil pack off, and look at it. There are two types of coil packs - 1 piece and three piece (others may be possible) on a three piece, you will need to have each one tested to determine whether it's bad or not. On a one piece, pull it off and look at the glue like material underneath it, that part is called the modular (the coil pack(s) will screw down to it. The modular may be bad, and may be able to test it as well.

Apr 01, 2009 | 2000 Mitsubishi Eclipse

1 Answer

After washing engine bay with water car wont start has no spark


The water leaks down into the spark plug holes. Remove the coil packs and spark plug wires, and sop up all the water in the spark plug hole. Leave the plugs in so water does not get into the engine. dry out the wires with an air gun, or just let dry. when everything is totally dry, put everything together and start.

Jul 24, 2008 | 2000 Kia Sephia

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...