Question about 2000 Kia Sportage

Open Question

Where can I get a pcv valve grommet for a 2000 Kia Sportage car. Thanks!

Posted by on

  • yadayada
    yadayada Sep 14, 2010

    from the dealer only

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: 2000 Kia Sportage

yes it is very easy just remove the air intake duct located on the radiator (2 10mm bolts) this exsposes the thermostat housing it has 3 10mm bolt remove those and the top of the housing the the thermostat. clean off old gasket material, then replace the thermostat and gasket and reassemble the housing and air intake duct.

Posted on Dec 18, 2008

Ad
localwonder
  • 6784 Answers

SOURCE: the Abs light came on and will not go out after i

This is just a consequential event. the ABS sensor module was probably going out and decide the trigger the alarm at the same time you initiated the hard brake during travel. replacing or resetting this sensor module Will fix this issue. the light will go off as well.


Please rate and god bless.

Posted on Mar 17, 2009

  • 1 Answer

SOURCE: 2000 kia sportage ex, 4 cyl.

For that many codes I would refer you to a bulletin covering the 123 and 124 connectors. This bulletin has instructions on how to upgrade these 2 connectors which connect the engine to the ECM. The connectors are located under the intake manifold towards the firewall. You need to remove the battery, pull the connectors apart, give the male side a slight twist, then you add Stabulent 22 to the connectors and reconnect. The dealerships also add some clips to hold the connectors together better. This task is not an easy one due to the location of the connector. I have done it many times in the past and this helped many of my costomers. Anither thing to check is the continuity to ground at the MAF. This also can indicate bad connection throughout the engine harness. to upgrade this connection, clean the ground connections at the battery and under the battery tray. these simple uperations should have been made into normal maintenance for the 95 - 99 Sportages.

Posted on Mar 22, 2009

  • 10 Answers

SOURCE: 2000 kia sportage. no start no spark no injector pulse.

check both of your fuse panels for a blown fuse. there's 4-5 that control the fuel pump, engine sensors, fuel injectors and such. one of those may be blown and not letting the rest of the system function. one panel is located under hood, and one is under the dash on drivers side. when you take the covers off they have the fuses numbered and tell what they control.

Posted on May 19, 2009

c17hydro
  • 2984 Answers

SOURCE: the easiest way to pull the heater core from a kia sportage-2000

There is no real easy way to do it....not like the older cars..

  1. Disconnect the negative battery cable.

    CAUTION After disconnecting the negative battery cable, wait for at least 10 minutes for the air bag module to deplete its stored energy.

    1. Remove the driver’s side air bag and steering wheel by performing the following procedure:
    2. Position the front wheels in the straight-ahead position.
  2. Remove the 4 steering wheel-to-air bag module bolts.
  3. Carefully, lift the air bag module and disconnect the electrical connector.

    CAUTION Place the air bag module in a safe location with the front facing upward.

  4. Remove the steering wheel-to-steering column nut.

    NOTE If may be necessary to mark the steering wheel to steering column alignment.

  5. Using a steering wheel puller, press the steering wheel from the steering column.
  6. Drain the cooling system into a clean container for reuse.
  7. Discharge and recover the air conditioning system refrigerant.
    1. Remove the instrument panel by performing the following procedure:
    2. Remove both the rear and front consoles.
    3. Remove the knee bolster assembly.
    4. Remove the “T” bar section.
    5. Remove the relay bracket.
    6. Remove the turn signal assembly and the upper/lower steering column covers.
    7. Remove the hood release handle lockscrew, the hood release handle and the cable assembly nut.
    8. Remove the left side front pillar trim and the lower left side cover.
    9. Remove the 2 left side of the “T” bar-to-chassis bolts.
    10. At the left side of the instrument panel, remove the 3 instrument panel-to-chassis bolts.
    11. Remove the ashtray.
    12. Remove the center panel trim.
    13. Remove the ventilation control panel.
    14. At the center of the windshield next to the windshield, remove the cap and the mounting bolt.
    15. " Remove the right side front pillar trim and the lower right side cover.
    16. Remove the 2 right side of the “T” bar-to-chassis bolts.
    17. At the right side of the instrument panel, remove the 3 instrument panel-to-chassis bolts.
    18. Remove the steering column-to-instrument panel bolts and lower the steering column.
    19. Disconnect the instrument panel electrical connectors.
    20. Remove the instrument panel.
    1. Remove the blower/evaporator housing by performing the following procedure:
    2. Disconnect the air conditioning refrigerant lines from the evaporator core and discard the gaskets. Plug the openings to prevent contamination.
  8. Disconnect the fresh air control cable from the blower/evaporator housing inlet duct.
  9. Disconnect the 5 connectors from the bottom of the blower/evaporator housing.
  10. Move the carpeting from the bulkhead to gain access to the hole cover plate.
  11. Remove the 4 hole cover plate nuts and the plate.
  12. Remove the 2 upper blower/evaporator housing bolts.
  13. Remove the 2 lower blower/evaporator housing-to-bulkhead nuts.
  14. Remove the blower/evaporator housing.
  15. Disconnect the heater hoses from the heater core.
  16. Remove the temperature control cable from the heater housing.
  17. Remove the 2 lower heater housing nuts and the upper heater housing-to-bulkhead nut.
  18. Remove the heater housing.
    1. Disassemble the heater housing by performing the following procedure:
    2. Remove the seal from the heater core tube connections.
    • Remove the vent seal.
    • Remove the 2 wiring harness-to-heater servo screws.
    • Remove the 8 heater housing clips located on the servo side (left side).
    • Remove the left side of the heater housing.
    • Remove the 6 heater housing assembly clips.
    • Remove the 4 heater core tube mounting bracket screws and the bracket.
    • Remove the 8 remaining heater housing clips and disassemble the housings.
    • Remove the heater core from the housing.

  • f277857.gif
    Exploded view of the heater core and heater housing assembly—Kia Sportage


    THIS IS JUST TO REMOVE IT!

    Posted on Oct 18, 2009

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    2000 Kia Sportage, no power and wont rev past 4000 rpm, and the engine wont code, could this be the 4 wheel drive


    cad converter. take it off first and see if it works better. if not check injectors.

    Mar 28, 2014 | 2000 Kia Sportage

    1 Answer

    How to fix code P0505 code on 2000 kia sportage?


    P0505: Idle Air Control Valve System fault, Code P0505
    -Vacuum leak
    -Dirty throttle body
    -IAC motor defective
    -Poor electrical connection to the IAC valve, hope this helps and good-day !

    Mar 29, 2012 | 2000 Kia Sportage

    1 Answer

    Engine light on and when I had it read is said Catalitic problem, changed it and still said Cat. converter, what up


    I'm not a Kia expert. Some newer cars have two oxygen sensors. One before and one after the Catalytic converter. This tells the computer how efficient the cat is. If the O2 sensor fails then it could be lying to the computer. Or u could have a fuel/air mix problem or PCV valve blockage or ?? Emissions problems take a real expert to honestly find problem.

    Mar 03, 2010 | 2000 Kia Sportage

    1 Answer

    I am having trouble finding the pcv valve on a Kia sportage 1998


    it is the tube coming from valve cover ,left side, with sharp turn in it, warning this hose is very brittle and you can easily snap it off , so be carefull.

    Nov 08, 2009 | 1998 Kia Sportage

    2 Answers

    Pcv 2000 cadillac deville


    there really isn't one like the ones we know from other models on the front bank front part of the valve cover a tube goes into a grommet that is the valve.

    Jun 17, 2009 | 2000 Cadillac DeVille

    1 Answer

    How to release fuel pumps pressure properly before servicing


    do it at the schrader valve pressure test port on the engine, the valve is located in the fuel supply rail to the injectors, looks like a tire valve.

    Apr 28, 2009 | 2000 Kia Sportage

    1 Answer

    2000 Kia Sportage doesnt want to start.


    Did you have your car checked by a mechanic/dealer? Did they scanned it and found the fault being the Idle control valve? If this is the case then we'll just have to wait for the new part to be fitted to the vehicle. Cheers

    Mar 21, 2009 | 2000 Kia Sportage

    1 Answer

    2000 Jeep Wrangler TJ


    The tube that comes out of the top of the valve cover is your pcv.
    The grommet that it goes into gets blocked.

    Oct 14, 2008 | 2000 Jeep Wrangler

    Not finding what you are looking for?
    2000 Kia Sportage Logo

    Related Topics:

    59 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Kia Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    yadayada
    yadayada

    Level 3 Expert

    76164 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8273 Answers

    Are you a Kia Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...