Question about 1994 Isuzu Trooper

Open Question

What is the function of the upshift relay for my 1994 isuzu trooper? my car is not getting any power and i replaced the 30, 50, and 80 amp fuses. i just dont get it.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

r_mcalhoun
  • 166 Answers

SOURCE: isuzu trooper

no on the free owner man. try junk yards and ebay

Posted on Mar 29, 2009

  • 1 Answer

SOURCE: Starter removal - 1994 Isuzu Trooper

pull the starter away from the bellhousing and turn the drive end upwards then it will come out from the engine compartment tight i know but i have just done mine so i know it will come

Posted on Mar 30, 2009

emissionwiz
  • 75117 Answers

SOURCE: need to know the firing order diagram for a 1994 isuzu trooper

go to link for your info.
http://autorepair.about.com/library/firing_orders/bl-fo-7349.htm

Posted on Jun 11, 2009

germcelchar
  • 389 Answers

SOURCE: change a cv boot on a 1996 isuzu trooper

First their are two different front axles in 1996 troopers. Isuzu changed the 4wd system from auto lock hubs to drive control axle.auto lock hube are on the older trooper's with the light and wiper switches on the dash. The same way to change both. Auto hub remove the six hex. screws slide off the hub remove the sirclip from the driveshaft. Newer hub has 6 alan-head screw's again remove them then the hubcap then the sirclip on the shaft and slide off the round spacer. Next 4 bolts from the lower balljoint and the brake's. Pull out the hub until it clear's the shaft remove the inner boot clips slide the inner boot out the shaft. Clean the grease from the end of the axle then with your fingernail feel along any of the 3 tracks in the axle and near the outer end of the track you will find a wirelike split ring slide a screwdriver under the ring and lever it off . Pull out the drive clean off the grease. You will see a sirclip on the end of the joint remove it and slide off the joint. You can replace either boot from that end. The outer joint is held on with a snap ring on the shaft inside the joint and is not easily removed need a hammer and drift to drive off the end and when removed its hard to get the snap ring on the shaft back into its place.You can change both boots from this end as well. Cheers

Posted on Sep 28, 2009

johnjohn2
  • 5763 Answers

SOURCE: Cam belt timing 1994 Isuzu trooper big horn

no timing, cam belt must be installed corectly inorder to have right timing.

Posted on Oct 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power windows, rear defogger and exterior mirror defogger quit working


IF you checked the fuses and relays, them it sound like it might be wiring or wiring connector might be loose.

Jan 05, 2013 | 1994 Isuzu Trooper

1 Answer

I have a 1994 Isuzu 3.2v6 Trooper or Bighorn which is called in Japan. The 7.5 amp fuse started to blow recently. Sometimes it'll work for a few days and sometimes it keeps blowing the fuse. The three...


whatever this fuse controls is drawing too much power, you need to know exactly what this fuse is for before you can find the problem,it may be the fuse for more than one thing.......hope this helps........cheers.

Sep 06, 2011 | Isuzu Trooper Cars & Trucks

1 Answer

My 88 isuzu trooper is not getting power to the fuel pump or the pump relay fuse but is getting power to the relay.What is the most likely cause?


rustking48,did you ever resolve your fuel pump power problem?
I am having the same problem. Are there 2 fuel pump relays?
kykdave@usa.net

Oct 18, 2010 | 1988 Isuzu Trooper 2 Door

1 Answer

Turn signal & emerg. flashers stop working


2000 Isuzu Truck Trooper 4WD 3.5L SFI DOHC 6cyl The Flasher is located: Front seating area, behind the left hand side of the instrument panel, behind the fuse panel.

Hope helps (remember rated this).

Jun 12, 2010 | 2000 Isuzu Trooper

1 Answer

Sets TC 37 torque management fail fault code.


i got same problem with this ..anybody settled??

May 17, 2010 | 1994 Isuzu Trooper

2 Answers

1993 rodeo not running no power to fuel pump


if there is no power to the fuel pump check relays and fuses....UNDERHOOD FUSE & RELAY PANEL IDENTIFICATION Fig. 2: Underhood Fuse & Relay Panel Identification Courtesy of ISUZU MOTOR CO. Fusible Link Identification ? A - 80 Amp (1991-92 3.1L) ? A - 60 Amp Main-1 ? B - 30 Amp Main-2 ? C - 30 Amp (1993-94) ECM (3.2L) ? D - 30 Amp Condenser Fan (A/T Models) Relay Identification ? 1 - Headlight Relay ? 2 - A/C - Heater Relay ? 3 - Starter Relay ? 4 - A/C Compressor Relay ? 5 - Charge Relay ? 6 - Fuel Pump Relay ? 7 - ECM Relay ? 8 - Wiper Relay Fuse & Circuit Breaker Identification ? 1 - 15 Amp (1991) ECM, Fuel Injection System ? 1 - 15 Amp (1992-94 2.6L) ECM, Fuel Injection System ? 1 - 10 Amp (1992-94 3.1 & 3.2L) Heated Oxygen Sensor, Fuel Injection System ? 2 - 20 Amp (1991-92) Fuel Pump ? 2 - 20 Amp (1993-94 2.6L) Fuel Pump ? 2 - 15 Amp (1993-94 3.2L) Fuel Pump ? 3 - 10 Amp (1991) ? 3 - 15 Amp (1992-94) Turn Signal Lights, Hazard Warning Flasher Lights ? 4 - 10 Amp Horn, Door Locks ? 5 - Not Used (1991 3.1L) ? 5 - 10 Amp Charging System, Charge Warning Light WARNING: Always disconnect battery ground cable before servicing "high- current fuses. It is recommended that "high-current" fuses be replaced by a qualified technician. Page 1 of 2 FUSES & CIRCUIT BREAKERS -1994 Isuzu Rodeo LS? 6 - Not Used (1991) (1992-93 2.6L) ? 6 - 10 Amp (1992-94 3.1L & 3.2L) A/T Interlock System ? 6 - 10 Amp (1994 2.6L) Heated Oxygen Sensor, Fuel Injection System ? 7 - 20 Amp Heater/Air Conditioning Blower Controls ? 8 - 10 Amp Air Conditioner Compressor Controls ? 9 - 10 Amp Right Headlight ? 10 - 10 Amp Left Headlight © 2008 Mitchell Repair Information Co., LLC.
62217_isuzfuse_1.jpg
Underhood fuse block swap out relay #7 thats the ECM relay.
Ground Circuits Using a DVOM, touch negative voltmeter lead to a good ground. Touch positive voltmeter lead to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If reading is greater than one volt, check for open, corrosion and loose connection on ground lead. See ECM GROUND LOCATION table for ECM ground location.
Page 1 of 1 SYSTEM/COMPONENT TESTS - 2.6L EFI -1994 Isuzu Rodeo

Mar 28, 2010 | 1993 Isuzu Rodeo

2 Answers

My 1995 isuzu trooper sunroof and interior light, clock stopped working.i have checked the fuses and they are all good. any help or guidance would be appreciated


Check under your hood for a second fuse box.This box should contain fuses and relays.Some times the box lid will tell you whats what ie.horn relay,fuel pump relay,ect.Look to see for a relay for your sunroof.Your sun roof takes a lot of power to run and should be on a relay.Your light and clock be on the same relay.Good luck.

Mar 09, 2010 | 1995 Isuzu Trooper

2 Answers

Blower circuit not working and fuses are good


time to start looking at the conection for the alternator and all wires in the general vacinity also you might want to look at the accessory fuse pannel under the hood as you might have blowen a master bus fuse in there

Dec 29, 2009 | 1994 Isuzu Trooper

1 Answer

1995 Isuzu Trooper--Power Windows wont roll down


Check the circuit breaker in the fuse panel on the driver side kick panel. It is a small brown push button directly above the replaceable fuses. My girlfriend has the same year trooper and this has happened to her in the past. I found the breaker and it took care of the issue.

Oct 17, 2008 | 1995 Isuzu Trooper

1 Answer

I need to replace the altenator in my 1994 Isuzu Trooper. Do I have to remove the Power Steering Pump to reach the part?


no just jack the vehicle and go through the passenger fenderwell, its there and you do not have to remove the p/s pump

Jul 25, 2008 | 1994 Isuzu Trooper

Not finding what you are looking for?
1994 Isuzu Trooper Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...