Question about 1993 Ford Bronco
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You'll need to have a fuel line disconnect tool. This tool can be made of plastic or metal, but the utilization is the same. You can purchase these tools at most auto parts stores. The fuel lines have a "quick disconnect" end on them where the filter attaches. After you've relieved the pressure from the fuel line (line pressure's usually around 60psi so you should wear eye protection). Techniques vary you can remove the fuel pump relay, and start the engine till it shuts down, or (needs another special tool). Attach hose from tool to test port on fuel rail by injectors and drain fuel into suitable container. You can also remove the cap from the test port and with a rag covering the port to catch fuel, depress the schrader vale (like a tire valve). This isn't really the best way,because gasoline can get on you and will inevitably get on the engine. Not always a good situation if engines hot. (To be honest with you, at work I usually just slightly disconnect the line at the filter. Only enough to bleed the fuel pressure off and let it drain into a bucket.) To remove, you'll have to insert the tool into the line around the filter neck at one end. You'll then be able to separate it from the filter. Repeat on other end. You may have to wiggle and twist a bit, as the filter necks might be sticking to the o-ring seal in the connector. Don't force it, as you can damage the connection, and you'll then be purchasing new fuel lines. Most of these filters are retained in a bracket on the frame rail using a big hose clamp. Naturally you'll have to loosen that to pry out and remove the filter. Aside from the initial fuel spillage, and any fuel that might drain down through the lines, the fuel in the tank will remain in the tank. Typically the filter is mounted well above the tank where the pickup tube is located, so siphoning won't be an issue.
I hope this helps
Posted on Nov 14, 2008
The problem is most likly the sending unit in the fuel tank but check the float. drain tank, there are two bolt in the straps on the fuel tank lossen enuf to lower tank to get to top to unplug wires and fuel lines once tank is on the ground thee is a ring on the top of tank holding the pump and sending unit in tap ring around with a screw driver to lossen once you have that off just pull unit out of tank and follow directions that come with sending unit. reverse removal procedure. good luck.
Posted on Apr 07, 2009
ford runs entirely on vacuum so if you replaced all the above mentioned the issue most likely is vacuum dry-rotted lines etc... however if it is equipped with a fuel shut off locate it and pull it to reactivate the flow of fuel sounds most likely just that from having been an owner as well
Posted on Sep 07, 2009
Tips for a great answer:
Jun 03, 2012 | 1996 Ford Bronco
Jan 01, 2011 | 1993 Ford Bronco
Dec 21, 2010 | 1989 Ford Bronco
Oct 25, 2010 | 1993 Ford Bronco
Jun 28, 2010 | 1993 Ford Bronco
Nov 02, 2009 | 1993 Ford Bronco
Jul 12, 2009 | 1993 Ford Bronco
Jul 02, 2009 | 1990 Ford Bronco II
260 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: