Question about 2002 Ford SVT Focus
The code U1262 point out a communication fault between the vehicle modules and a scanner. It may be best to visit your local dealer to find if one of the vehicles control modules has failed. In some cases this can be as simple as a blown fuse, but there is always a reason for a fuse to blow
and a oil sending circuit fail. would need to be tested.
P1000 DTC code is a manufacturer specific trouble code. your code reader is not reading or communicating correctly you will need to check the fuses for all the modules and check the connections on the plugs and the units to check the modules to see if they have good contact. also check the main earth from the battery to the shell and make sure the contact is good.
Posted on Aug 04, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is a problem with the electronics on your vehicle. Your vehicle is sluggish because it has gone into limp mode. This allows the vehicle to run, but run poorly so you can get it somewhere to be fixed. I'm sorry but I don't have a code book for Fords. But, you can call a Ford dealership and ask for the service department and have them look up the code by number and they can tell you the definition of the code. But, it can relate to many different systems linked to your problem. Electronic parts are very expensive and if you just guess at them it could be costly.
Keep in mind if you buy a part that is electronic and it does not solve the problem they will not allow you to return it. Hope this gives you some guidance to your dilemma.
Posted on Feb 09, 2009
P1000 means that you or someone has disconnected the battery,and the car has not been driven far / long enough for the computer to relearn its stratagies.
Engine light could be the fault of the speed sensor, or wiring to the sensor.
Posted on Jul 27, 2009
SOURCE: no start and codes u1262,
The trans. control module is throwing this code. Shouldn't keep it from starting, but ya never know.
Try unhooking the ground on the battery for aprox 30min to clear the code. If it starts, drive a few miles and recheck codes....
Posted on Dec 18, 2009
Tips for a great answer:
Jan 21, 2016 | 2014 Ford Fiesta
Jul 27, 2015 | Ford Cars & Trucks
Aug 28, 2014 | 2010 Ford Fiesta 1.25
Aug 15, 2014 | 2006 Ford Fiesta 1.6
Aug 19, 2010 | 2001 Ford Focus
May 15, 2010 | 2000 Ford Focus
Sep 08, 2009 | 2007 Ford F
May 25, 2008 | 2001 Ford Focus
130 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: