Question about 2001 Ford Windstar

Open Question

2001 ford windstar left front turn signal won't work, changed the bulb still won't work

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 507 Answers

SOURCE: change turn signal bulb 02 S60

I don't know much about Volvos, but on most vechiles there are two screws on the lens you unscrew to take off. Or, right behind the light, you see the wires going into the unit, grab the rubber piece that goes into the unit and see if you can turn it counter clockwise. If so, gently pull out and change your bulb. Not, this soultion dosn't work for headlights.

Posted on Sep 14, 2008

  • 3 Answers

SOURCE: how to change bulbs on front and rear turn signals

open the hatch there should be two screws that hold on the lense, twist the bulb holders and remove

Posted on Sep 18, 2008

  • 1 Answer

SOURCE: Left front turn signal bulb for 2001 Pontiac Montana

There is only one screw to remove that releases the mounting tab at the upper inner corner of the assembly. That screw has a plastic wingnut molded onto it so you can turn by hand. Once that is removed, the assembly can be pulled straight forward. At the inner bottom corner, a spring clip faces straight rearward. Pull with enough force to to release the clip from its slot. Only two "Fingers" hold the rear of the assembly in the sheet metal holes.

Posted on Nov 15, 2008

  • 5 Answers

SOURCE: Chevy Cavalier 2001 turn signal blinks fast

If new bulbs don't work, it is probably the harness that holds the bulb. I had to replace both on my car after fighting with the problem for over a year and not knowing.

Posted on Mar 19, 2009

  • 1 Answer

SOURCE: 2001 S60 Right Turn Signal Blinks Rapidly compared to Left Signal

Gregg -

I had the same problem. It was a defective lamp socket on the driver's left side, Volvo Part Number 8662985. Costs me $11.24 to replace the lamp socket, which included the bulb. If you've already replaced the bulbs yourself, you will find replacing the socket pretty easy, just use a thin flathead screwdriver to delicately pry off the metal retainer clip which holds the lamp socket in place, as you'll need to reinstall the existing metal retainer clip once you've replaced the lamp socket. Two minute job.

Posted on Apr 29, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My right front turn signal on my 2001 ford ranger doesnt work and my inside right turn signal light on dash doesnt work and flashes really fast. Buld on right side was replaced and works when lights

was the correct bulb used? this sounds like a single function bulb was used NOT the bulb that will light with the headlights and ALso produce turn singles

Dec 06, 2014 | 2001 Ford Ranger Regular Cab

1 Answer

Bulbs for turn signal are fine but not working on left side front and back 99 ford windstar

Shorted wire going to the left side. Had the problem with taillights on Mercury Grand Marquis. Turned out that the wiring had gotten crimped under the bold for the front seat. Shorted out.

Oct 03, 2013 | Cars & Trucks

1 Answer

Right turn signal does't work

check bulbs . also check connection of bulb socket (sometimes the socket can get corroded)
simple way to check to see if getting power to that side; take same gauge wire(on bulb wiring), from battery to just before bulb socket. if works then problem is more likely to be in turn signal switch.
try jiggling the turn signal switch when putting on right signals.
last option, check wire from switch to bulb.
ford has had a lot of problems with electrical stuff such as doorlocks,switches.

May 26, 2011 | 2001 Ford Windstar

4 Answers

Left rear turn signal does't work but blinker in car blinks rapidly, front left turn signal does work

Sounds like a burnt out bulb, that fast blink is to tell you a bulb needs replaced.

May 04, 2011 | Dodge Intrepid Cars & Trucks

1 Answer

Left turn signal comes on and flashes but not the right one

If the arrow stays on on the dash, you have a burnt bulb on the right side. If the front right bulb stays on and the right rear is out, the rear bulb is burnt. If the rear is on solid, the front is burnt. If both front and rear is on, either you have a bad connection at the sockets, bad turn signal relay, or a bad multifunction switch - which is usually the turn signal switch in the steering column.

Dec 19, 2010 | 1996 Ford Windstar

1 Answer

Brake light, reverse light and turn signal issues

Hello. The symptoms you are describing are likely due to a poor ground. Temporarily install a new ground wire by securing a piece of copper wire to the frame with a self tapping screw. Use this ground wire along with the hot wire to see if each of these lights works. If it does, trace the ground wire back to the frame, unscrew it and clean up the metal with emery cloth so you reestablish a good ground.

Jan 28, 2010 | 2003 Ford Windstar

1 Answer

How do i change the front turn signal bulb on my 2000 windstar lx

The screw that holds the lens must be unscrewed. Then,
you can replace the signal bulb. Put the lens back in place, and it's all done.

Jan 18, 2010 | 2000 Ford Windstar

1 Answer

The 2001 Windstar's left front turn signal and left rear back up light do not work. the bulbs are known to be good. any ideas?

Check for powers and grounds right at the sockets.This is a very easy to do with a cheap test light.

Jan 07, 2010 | 2001 Ford Windstar

1 Answer

Turn indicator light flashes quickly. bulbs fine

The quick flash is a fault detection for a burnt out bulb. If bulb is good, check bulb socket. Inspect for corrosion. If needed, replace bulb socket. Check bulb socket connector. Check if fuse. Check emergency flashers ( most cars have a separate circuit).

Jul 09, 2009 | 2000 Ford Windstar

Not finding what you are looking for?
2001 Ford Windstar Logo

Related Topics:

250 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides