Question about 1988 Jaguar XJ6

1 Answer

How do I reset the computer on 1988 xj6 jaguar

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jaguar Master
  • 14,036 Answers

TO RESET ECM ON A 1988 XJ6 JAGUAR.YOU DISCONNECT NEGATIVE BATTERY CABLE FOR 30 SECONDS TO CLEAR CODE.THIS WONT DO ANY GOOD IF YOU HAVE A ECM TROUBLE CODE DONT FIX PROBLEM.CHECK ENGINE LIGHT WILL STAY ON, UNTIL YOU FIX FAULTY COMPONENT OR SENSOR.

Posted on Sep 14, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 11 Answers

SOURCE: 1988 Jaguar xj6 No forward in the automatic trans rev works fine

the linkage is just a slight bit off, it parks between gears when you shift into the slots. Disassemble the shifter from the center console, and slowly move just the cable its self between the positions and see if you have forword gears. When you find and sync the gears, then tighten the cable to the shifter so the positions match the notches in the shifter.

Posted on Sep 04, 2009

  • 1 Answer

SOURCE: 1996 Jaguar xj6

my 1995 xj6 jaguar windshield wiper don't work, cannot locate the fuse for the wiper, as i do not have the owner manual to see which is the fuse for the wiper in the fuse box

Posted on Nov 05, 2008

alicantecoli
  • 22156 Answers

SOURCE: reset fault code on 1996 jaguar x300

dealer only sorry

Posted on Dec 10, 2008

johnthejag
  • 286 Answers

SOURCE: 1988 jaguar xj6 engine turns

Hi
Sounds like fuel.
Check fuel inertia cut off switch is pushed down for on.?
Check for fuel pressure to the engine.
Sure your fuel is not water contaminated ?
Possibly the flow meter is faulty, or has an air leaks on the hose going to the inlet manifold.
I see you posted this on the 14th Dec O8 so perhaps you have it running OK by now ?
Good Luck !
John.

Posted on Jan 15, 2009

  • 11 Answers

SOURCE: i have a 1988 jaguar xj6 and the outside door

If you havent' already broken the door handles tugging on them, inside the door you will find a linkage with a tensioner adjustment. You need to tighten that linkage adjuster. You will find if you take off the inside door panel and pull the linkage manually the door retanier will actuate. The job is a PIA, and requires a couple of very long, very small box wrenches. Dont attempt to adjust the linkage without loosening the retaining nut, the linkage will shear right off, thus making the outer door handles permanently locked Good luck.

Posted on Sep 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What type trans, fluid do i use? 1988 jaguar xj6


DexCool coolant. Comes in 50/50 mix already. But if you get the concentrated, mix it with distilled water. Not tap water.

Jan 12, 2011 | 1988 Jaguar XJ6

1 Answer

I can't open the fuel cover on my 1988 Jaguar XJ6


there is a release lever in the trunk beneath the gas cover you can push to release

Sep 01, 2010 | 1988 Jaguar XJ6

1 Answer

Will a 1988 jaguar xj6 stall if a catalytic converter is stopped up.


yes! run the car just as long as u can to get it warmed up.. preferably do this at night.. the cat will glow red if it is clogged

Feb 23, 2010 | 1988 Jaguar XJ6

1 Answer

I have a 1988 jaguar xj6. The car will not go into a drive gear, but it will go into reverse. Why? Please advise


first thoughts are check your auto transmission fluid level (with engine running with car on level ground) and linkage to gearbox.

Nov 12, 2009 | 1988 Jaguar XJ6

1 Answer

No heat jaguar 88 xj6 fan wont turn on cool air out the defrost vent


I have the similar problem with both my Jaguars, one is a 1988 Jaguar XJS, the other is a 1987 Jaguar XJ6, both blow COLD air out some vents while it blows warm air for heat. I heard it had something to do with the cold air blowing as a dehumidifier, I don't know if this is true, but it is really annoying to have both cold and warm air blowing when I need heat in these cold Canadian winters. If you find out please drop this website a note and let us know how you solved it. thanks.

Nov 12, 2009 | 1988 Jaguar XJ6

2 Answers

LOW BREAK PRASSURE HARD PEDAL


master cylinder needs to be rebuilt or replaced

Jun 25, 2009 | 1988 Jaguar XJ6

1 Answer

My 1988 jaguar just died, i think it isnt getting a spark to the distributer cap. please help


check the crankshaft position sensor. it's a common problem with these guys. I just had the same problem and that's what fixed my XJ6

Mar 21, 2009 | 1988 Jaguar XJ6

Not finding what you are looking for?
Cars & Trucks Logo

726 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...