Question about 2008 Chevrolet Cobalt

1 Answer

I replaced my radiator and now my air conditioning wont work

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 17,130 Answers

Possible that durring the process you might have accidently released off the gas, cut off the lines to the AC compressor or loosened offf thebelt.
so check these one by one, check the gas pressure first.

Posted on Sep 14, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No heat


Air pocket is trap in the cooling system..

Put you car onto a pair of oil change ramp / or steep hill with radiator cap off (when cold).

Look for air bubbles to purge for the system.

Jan 13, 2014 | 1995 Ford Crown Victoria

1 Answer

2002 jeep sport. Overheating while at idle. Changed radiator, thermostat, water pump. Only runs cool when ac is on. What next?


relay that controls the speed of the radiator cooling fans must be checked
Air conditioning works when theAir conditioning works the relay is stuck ON for the fans cool two radiators (ac + main radiator)

Sep 15, 2013 | Cars & Trucks

1 Answer

How to remove a radiator form a 2000 jaguar


Removal
  1. Drain the cooling system.
  2. Reclaim the air conditioning refrigerant.
  3. Remove the motor and shroud.
  4. NOTE: Seal the line and the evaporator with plugs.


Detach the air conditioning line. Raise the vehicle.
  • Remove the lower radiator splash shield.
  • NOTE: The splash shield is equipped with hinges which should be treated with care on removal. Remove the radiator splash shield.
    Detach the securing clips.
    Remove the radiator splash shield.
    NOTE: Seal the line and the evaporator with plugs and Detach the air conditioning line.
    1. Detach the lower coolant hose.

    2. Remove the air conditioning condenser. Remove the securing screws.
    3. NOTE: Vehicles with manual transmission, cable tie the cooling radiator
    4. tach the automatic transmission/power steering cooler.
      Remove the securing screws.
      Detach the automatic transmission/power steering cooler.
      1. Lower the vehicle. Remove the radiator foam trim.
      Remove the radiator.

    Sep 25, 2012 | 2000 Jaguar S-Type

    1 Answer

    Radiator fan not working


    you have a defective sensor or the fan is no good . your ac has a leak and there is not enough feron in the system

    Jun 29, 2012 | 1995 Ford Escort

    1 Answer

    I need to bleed the radiator on my 2000 Jetta. We replaced the radiator but it is overheating.


    Did you replace the thermostat? If it is overheating then its possible it is bad. Also fastest way to bleed is to park front up on an incline with expansion tank cap of and air will work its way to the tank and out to air. You will just need to top off when system cools off. Wont do any good tho if thermostat is bad. Also make sure your electric fan is turning on, if not that may cause an overheat condition since when not moving its the only way air moves through the radiator.

    Good luck.

    Aug 02, 2011 | Volkswagen Jetta Cars & Trucks

    3 Answers

    2003 dodge durango started overheating and now wont start. changed the water pump and put new battery and still wont start. What could it be?


    ECT wont kill the engine. If it over heated and you kept driving it. You just might have blown the engine. Put a socket on the balancer bolt and see if you can turn the engine by hand. Clock wise.

    Jul 24, 2011 | 2003 Dodge Durango

    1 Answer

    I have a 2000 chrysler sebring limited edition


    what you have and are attempting to do is seperate the A/C condensor from the radiator. They are most usually bolted together. You need to keep looking to find where they have been joined, sometimes the bolt will almost be hidden.

    jetski

    Oct 04, 2008 | 2000 Chrysler Sebring

    2 Answers

    Mechanic said car nedds new condensor, is the condensor in the radiator ?


    The condenser is part of your air conditioning system. Hot high pressure freon gas from your air conditioning compressor will run through your condenser to dissipate heat and condense into a liquid.
    The condenser is not in the radiator but looks like a small version of your radiator mounted either in front of, or behind your main radiator.
    If your AC works properly and doesn't leak, then you don't need a condenser.

    Jul 23, 2008 | 2000 Kia Sportage

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    44 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    76682 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8531 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...