Question about 1998 GMC Jimmy

Open Question

Lost my key for 1998 gmc jimmy where can i get another one

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 125 Answers

SOURCE: TPS in a 1998 GMC Jimmy

the tps is ususally at the side of the throttle body opposite where the throttle cable / tv cable mount.
sometimes it won't start, run, or run erratically. there are ways of testing this unit (by output voltage) before you commit to buying a new one. to test it you will need a dvom (digital volt ohm meter).

just a note: straight from the book... "a broken or loose tps can cause intermitten burst of fuel from the injector and an unstable idle because the ecm thinks the throttle is moving."

Posted on Sep 22, 2008

  • 293 Answers

SOURCE: 1998 GMC Jimmy Vortec V6 4.3L 4WD
hope this helps

Posted on Oct 17, 2008

  • 24 Answers

SOURCE: key stuck in the ignition of 1998 GMC Jimmy

Is the ignition switch turned off? Is it in ACC mode. It may be that the locking mechanism on the steering wheel is engaged. If that’s the problem, try working the steering wheel back and forth while also trying to remove the key. This may help you to remove the key itself, but does not fix the overall problem. I believe that the cutting of the key its self is the problem. Try just getting a knew key made. Hope this helps…. John…

Posted on Jan 19, 2009

  • 45 Answers

SOURCE: how do i bypass security on 98 gmc jimmy 4.3

Hi: Sounds to me like you tried to start the vehicle with something disconnected in the security system. If this is the case the solution is simple. Put key in ignition and turn to the on position, leave on for EXACTLY 30 minutes... then take key out, wait 5 minutes then start vehicle. Hope this helps... please rate suggestion... ty

Posted on May 21, 2009

  • 593 Answers

SOURCE: 1998 GMC Jimmy hood release cable broken

Remove the cable from the latch and any hold downs or clamps. Push the rubber gromet through the fire wall into the car. Remove the handel assy. and pull
the cable assy.out through the fire wall. Now, if the
gromet can be removed. You can decide if you wan't
to put it back from under the dash, or under the hood.
Whatever is easiest for you, but if it can't, it has to go
back from under the dash. Hope this helps.
Good luck.

Posted on Jan 26, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

No power to key ignition 1998 GMC Jimmy

Look for the inline fuse link in the red wire from the battery . It looks like something was spliced into the wire. It's the fuselink.

Jun 25, 2014 | 1998 GMC Jimmy

1 Answer

Removing lock cylinder gmc jimmy with no key

take vin number to dealer and get a key made .

Dec 27, 2012 | 1998 GMC Jimmy

1 Answer

1998 gmc jimmy fuel pump

did you change connector at fuel pump?

Dec 12, 2012 | 1998 GMC Jimmy

1 Answer

K1998 gmc jimmy 4 wheel drive truck cranks but getting fire,when it did run it smelled like gas strong

GMC Jimmy's have a record of corroded fuel lines at the fuel pump in the fuel tank. Cycle your key from "Off" to "Run" a couple times then look under the vehicle in the fuel tank area to see if there is gas dripping.

Dec 05, 2010 | 1998 GMC Jimmy

1 Answer

Lost original key where do i find key code

you have to go to a dealership so they can program it

Dec 01, 2010 | 1998 GMC Jimmy

2 Answers

How do I prime fuel system on my 1998 gmc jimmy

Turn the key on for 5 sec. Turn the key off for 20 sec. Repeat 3 times

Aug 09, 2009 | 1998 GMC Jimmy

1 Answer

My tail gate will not open on my 1998 GMC jimmy, not even with the key

the latch linkage rod has come off, remove the door panel and replace the rod clip r the rod itself.

Jun 22, 2009 | 1998 GMC Jimmy

1 Answer

I need to know the fuel pump normal pressure for a gmc jimmy 1998

you can pull the line off of the fuel filter and stick it into a bottle and have some one turn the key on and see if gas is coming out then if it is try it on the one on the block and see if fuel is reaching there

Jan 18, 2009 | 1998 GMC Jimmy

Not finding what you are looking for?
1998 GMC Jimmy Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides