Question about 1998 Ford Taurus

1 Answer

How to relace power window motor - 1998 Ford Taurus

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 2,984 Answers

Motor

  1. Raise the window glass to the full-up position if possible. If the glass cannot be raised and is in a partially down or full-down position, it must be supported so that it will not fall into the door well when removing the window motor.
  2. Disconnect the negative battery cable.
  3. Remove the door trim panel and watershield.
  4. Detach the window motor harness connector.
WARNING

If the front door power window regulator counterbalance spring must be removed or replaced for any reason, make sure that the front door power window regulator arms are in a fixed position prior to removal to prevent possible injury during c-spring unwind.


WARNING

If the front door power window regulator counterbalance spring must be removed or replaced for any reason, make sure that the front door power window regulator arms are in a fixed position prior to removal to prevent possible injury during c-spring unwind.

// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 32; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]> var _strTreeScrollHidName = 'ctl00_hidTreeScrollPos';

  1. Remove the three window motor mounting screws.
  2. Remove the window motor.

To install:

  1. Position the window motor to the power window regulator. Install the three screws snugly but do not tighten all the way.
  2. Attach the window regulator electric drive wires at the connector and cycle the door window glass to make sure the motor gear engages. After the gears are engaged, tighten the three window motor retaining screws to 54-88 inch lbs.(6-10 Nm).
  3. Connect the negative battery cable.
  4. Check the power window for proper operation.
  5. Install the door trim panel and watershield.
// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 32; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]> var _strTreeScrollHidName = 'ctl00_hidTreeScrollPos';

Posted on Nov 13, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I'm not getting anything when i turn my heater on how do i relace my blower motor in my 2005 saturn ion?


Check fuses first. Then relays. Then try appling power to the fan directly to see if there are wiring problems. If the fan runs and the fuses and relays are fine look to the switch.
Good Luck!!!!!

Feb 24, 2015 | 2005 Saturn ION

2 Answers

Hummer h3 sunroof won't open or close


Check the fuse panel for blown fuse.

If you hear anything the fuse is OK and may be the motor

May 20, 2014 | Cars & Trucks

1 Answer

My divers side door lock will not unlock with the keyless entry


If the other doors lock then the power lock actuator is defective, remove the door apply power to the lock motor and see if it lights the 12 volt test light, if it does the actuator is defective, drill out the large rivets and relace it.

Aug 21, 2012 | 1999 Ford F150 Regular Cab

1 Answer

The heater blower stopped working tested the resister and it has power, how can I get to the switch that controls the different speeds for the blower. I'm thinking that's the problem


the issue is in the resistor check the poer and ground at the blower motor its self it should have power in all speeds.even if the motors not running..if thers power at the motor give the motor a tap..or check the under hood fuse..its not a resistor its an actual blower module...and extreamly common also check the resistor wires and connector they are known to melt inside the connector...if ok relace the resistor....

Apr 18, 2011 | 2004 Chevrolet TrailBlazer

1 Answer

Water pump relacement 2000 ford windstar


I have the information you require but I need to know what size motor is in your van. You can get back to me through the Reply box or window below .

Dec 16, 2010 | 2000 Ford Windstar

3 Answers

I have 1997 ford contour driver power window will not work at all but all the other window work fine...would it be a switch or fuse problem?


checking fuses is always a good way to start and the cheapest. the switch could be dirty for instance if someone had spilled a coke on it in the past. it could also be the drive motor for the window. since all the others are working this could be a possiblity.

Dec 07, 2010 | 1997 Ford Contour

1 Answer

1994 Toyota 4Runner just won't start?


If the battery is ok the problem is either the starter motor or your car security.

Aug 09, 2009 | 1994 Toyota 4Runner

1 Answer

2001 dodge dakota how do I relace the cabin fan


the blower motor resistor if i remember correctly is behind the glove box ,once u remove the glove box u should see it . make sure u check the wiring connector, i have ran into a few that has melted ..had to ret a replacement from chrysler that had a bigger supply wire. hope that helped you!!!

Jul 08, 2009 | 1998 Dodge Dakota

1 Answer

The power windows in the front doors do not work. Window on passanger side goes down several inches, but will not go up. Have relaced motors and switches in both. what's causing problem and how can it be...


Check the black rubber boot that protect the wires coming out of the driver door going in under the dash...move the boot around while trying to roll up the window and see if you get anything ..if so , you have a broken wire inside the boot..

Jul 30, 2008 | 1990 Buick Century

Not finding what you are looking for?
1998 Ford Taurus Logo

520 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...