Question about 1989 Cadillac Brougham
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
bang on the door hard and put the window up.if there is a dead spot in the motor from lack of use,the motor will start.
Posted on Jul 17, 2009
main thing befor you drill the mounting hole, make sure its in the middle and the right spot. i did many accurate mods on harleys for ppl because you need a good eye, which most deaalerships dont have. place tape on fender, measure, mark, measure again then drill small hole, check, if good drill full size, if of , drag hole then drill.
Posted on Aug 15, 2009
The turn signal flasher is located under the dash to the right of the
steering column on most models. The hazard flasher is under the dash,
to the left of the steering column. On 1980 and later models, both the
turn signal flasher and the hazard flasher are located at the lower
left hand and the upper right hand corners of the fuse block
respectively. There is an inline fuse for the underhood/spotlamp
circuit. The fuse box is marked to indicate fuse size and the
Fig. 1: Common fuse color coding
Fuse panel with mini-fuses-1980 and newer full size Cadillac shown
Hope helped with this (remember rated this help) Good luck.
Posted on Nov 10, 2009
No fuse.These seats are protected with relays and a seat module.The module is under the drivers seat.There are 3 connectors and it would be hard to check all these wires for power to the motors.First look under the seat and make sure none of the connectors came apart under the seat by something that might have been left or rolled under it.The 2 main ones you can check are the connector 2 terminal C and connector 3 terminal A.C is a black wire which is ground and A is a red wire which is the feed power wire.Connector 2 is green and 3 is black.If the ground and power wires are good then you could have a bad drivers seat module.What I would do is go to the salvage yard and find a used module to try.Good luck.
Posted on Dec 07, 2009
Testimonial: "Thanks for your assistance. Great information"
Tips for a great answer:
Sep 21, 2012 | 1989 Cadillac Brougham
Jun 17, 2012 | 2002 Cadillac Escalade
Jan 26, 2012 | Cadillac Brougham Cars & Trucks
Apr 09, 2009 | 1990 Cadillac Brougham
160 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: