Replace ECU for mitsubishi lancer ex 2009 - Lancer Mitsubishi Cars & Trucks

Question edited for a lot more clarity and correct spelling.

You spelled it 'Techno meter', so that means all your search results with be flawed.

This says you can get a Can Bus interface module.

https://www.google.com/search?q=2005+mitsubishi+lancer+tachometer+pulse+signal

and here is you non Evo ECU Pinout for a 2003, yours will be the same. Pins 58/43 is Tacho

https://www.evolutionm.net/forums/lancer-troubleshooting/572498-ecu-pinout-03-lancer-non-evo.html

Interesting workaround with a Transistor and a couple or resistors

https://www.the12volt.com/installbay/forum_posts.asp?tid=97121

....

Question edited for clarity.
Question moved to model category.

Head bolt torque specs and pattern

EvolutionM.net https://www.evolutionm.net > ... > Lancer Engine Tech

Jun 6, 2009 - Lancer Engine Tech - Head bolt torque specs and pattern - Hey all. Before anyone flames in case there is a post, I did use the search ...

2003 Mistubishi Lancer ES Head Torque Sequence, HELP!
Sep 15, 2011
Torque Specs for Head - EvolutionM - Mitsubishi Lancer and ...
Mar 5, 2007
Need some help..torque specs. - EvolutionM
Dec 16, 2009
what sequence do the head bolts need tightened - EvolutionM
May 28, 2011
More results from www.evolutionm.net

..

Don't worry I'm sure you will get the solution of your problem, just check the link I attached
Complete 2009 Mitsubishi Lancer Sportback Workshop Repair Service Manual

What is causing that irritating noise? ' DSMtuners

www.dsmtuners.com > ... > Articles: Miscellaneous
Jun 1, 2009 - 2 posts - ‎1 author Check the ECU power relay in the console, under the radio. ... You hear a loud clicking type noise from under the hood when you try to start the car. .... You hear a squealing, grinding, or rubbing noise in the lower timing belt .... The Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, Mitsubishi Galant VR-4, ... LOUD squeak when turning steering wheel (Video Inside)
22 posts
Mar 5, 2011
Why does my alternator belt squeal so much on initial ...
25 posts
May 14, 2010
More results from www.dsmtuners.com

Lancer Troubleshooting [Archive] - evolutionm.net

www.evolutionm.net/forums/mitsubishi-evolution-forums/f-203.html

NEED RADIO HELP! ... Help not start Lancer GT 2012 EngineOverheating STOP SAFELY warning on ... AC ISSUES 2011 Mitsubishi Lancer ES · 2008 Lancer GTS no start please ... 2011 lancer no sound · Driver/Passenger side floor squeaky? ... plastic piece of rear shelf rattles a lot · Very loud noise on Lancer ES 2008 ...

Mitsubishi Lancer 2007 2010 Service Repair Manual



SEE ABOVE LINK FOR DETAILS OF HOW TO OBTAIN SERVICE MANUAL. YOUR INFORMATION SHOULD BE FOUND WITHIN





http://www.hotmanuals.com/parts_1252/22153897/Mitsubishi+Lancer+2007-2010+Service+Repair+Manual

The 1.5L was never a power house, but the first checks should be
* check if the ECU is throwing an error code. If so this is a vital clue.
* verify the cam belt alignment. This can slip a few teeth and cause all sorts of problems
* verify the timing (assuming your 98 has a distributor or cam position sensor adjustment)
* Pull the injectors and soak them in injector cleaner.
* clean or replace the air filter.
* Check the coolant temp sensor (on the thermostat housing) does not have damaged wires. This sensor is vital for the ECU to decide what timing and mixture is needed.

honestly no idea ,you would need some dealer only information and doubt they will tell you but do a shrewdy and ask in the stores what the difference is ..

i think if u open it u p the chip is removable

problem is in the ignition module.