Question about 1991 Chevrolet S-10 Blazer

1 Answer

Starts but step on gas and it bougs out i changed fuel fillter plugs wires cap and rotor

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 235 Answers

Fuel injectors may be clogged. if you have a carburetor it may need rebuilt or replaced.or worst case you could be loosing compression.

Posted on Sep 13, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 toyota corolla has runing issue-changed the distributor, the rotor, the rotor cap and all plug wires


run the fault codes to find the faulty sensors as it may be injector problems or fuel pressure faults.

Jan 09, 2014 | Cars & Trucks

1 Answer

Will not start in cold weather


change plug wires fuel filter and cap and rotor if ur ccar has one

Mar 25, 2013 | Cars & Trucks

1 Answer

Replaced bad fuel pump, installed new relay and fuel filter, engine turns over but is not firing on..... positive the fuel pump is pumping gas and checked to see if gas was going thru fuel filter. Tried...


Hi, Ok you have confirmed that it's not a fuel problem. You need to check for spark. Pull the coil wire off of the coil(secondary lead-looks like a spark plug wire) Have some one crank it over and listen for a popping sound. IF yes, spark is at the coil, that means all ignition sensors are working. Next check for spark at ends of wires after cap. IF no replace cap and rotor. IF yes remove a couple spark plugs and check for fouling(wet, fuel etc...) IF yes replace or clean plugs and retest for starting. IF no spark is present at coil you need to scan computer and watch for rpm signal. IF no rpm signal, replace crankshaft sensor with OEM delco part. BIGGEST problem with these engines is Cap and Rotor burn out.

May 23, 2011 | 2002 Chevrolet Blazer

1 Answer

I have a 1993 4.3 6 cyl chevy S-10, it starts fine when you give it a little gas then when you start driving it 5 to 8 minutes later it is spitting and sputtering misfiring and backfiring give it a little...


5 years ago for cap & rotor???? It sounds like it's in dire need of a complete tune up - plugs. wires, cap, rotor, all fluids & filters ESPECIALLY fuel filter. I'd start there and run a good fuel system cleaner through it. Do your tune ups more frequently like every 30K - not wait 5 years!

Mar 22, 2011 | 1993 Chevrolet S-10

3 Answers

1975 Datsun (ie. mechanical fuel pump). Carburettor, electrics (inc. battery all good) fuel strainer all good. On cold start engine needs to be cranked several times. Warm start is invariably immediate. ...


Carburated vehicles ether have an automatic choke, or the very old ones, a hand choke. Yours has an automatic choke. The starting problem likely is a problem with the choke. The problem is almost certainly not the fuel pump.To set the automatic choke, push the accelerator to the floor, and RELEASE. Then start the engine just like you would a fuel injected vehicle. If this doesn't solve the problem, then the automatic choke needs to be repaired.

Oct 31, 2010 | Datsun Pulsar Cars & Trucks

1 Answer

Fuel filter & bouging down


U need a special tool to release then internal spring clip

Jun 19, 2009 | 1994 Ford Thunderbird

1 Answer

Ford 150 1985 model, feels like its bad gas?


is it a misfire or backfire? if misfire it needs a carb rebuild. if it is a backfire it is timeing problem. berrydalewolf

May 13, 2009 | 1985 Ford F150

1 Answer

1994 f150 no fire to coil or fuel pump


i got a 1994 f150 that starts but cuts right back off so i had no fuel psi so i put a new fuel pump and fillter then found out that it was not getting power to the pump the cut off is not triped and no brakes in the wires can anyone help??

Mar 13, 2009 | 1994 Ford F150 Styleside Supercab

Not finding what you are looking for?
1991 Chevrolet S-10 Blazer Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...