Question about 2004 GMC Envoy

1 Answer

2004 Envoy xl 80,000 miles ABS light and service brake system lights and message on. I have pretty new brake pads on so what else could be the issue?

Posted by on

  • Anonymous Mar 12, 2014

    Airbag light 2004 XL envoy GM

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

ABS sensor or fuse.

Posted on Sep 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abs light stays on and abs system does the same


Try adding brake fluid to the reservoir that should put the light to rest if not when have you had the brakes serviced last, if you start to hear a metal rubbing noise waste no time to get the brakes serviced chances are you need pads or shoes.. Every 25,000 to 30,000 miles should have them inspected other wise you risk rotor or drum damage if the pads or shoes wear down too far.. hope this helps..

Dec 25, 2014 | 1999 Lexus Gs 400

1 Answer

I changed my abs and i still have a vibration when i push the break no lights come on and its only when i am pushing the break


Warped front rotors from over using the brakes, heat from hard braking.........replace the front rotors with new ones and re-try. Might as well do the pads too as you are right there.

Jul 14, 2014 | 2005 GMC Envoy Xl

1 Answer

I changed the brakes on my 2004 GMC Envoy. Everything is good accept the service brakes light is on and won't turn off. How can I turn it off?


Do you have a good brake pedal, does it hold when pushed? Is the ABS light on too?
There may be air in the brake lines, there may be dirt in the lines. Have you tried bleeding the system?

Sep 20, 2011 | 2004 GMC Envoy

1 Answer

I have a 2004 GMC Envoy XL and the high range 4x4 mode will not engage. The AWD system works just fine as well as the 4x4 mode in low gear. What is causing this?


Is the Service 4WD light coming on? Do the light on the 4x4 selector switch indicate the proper selection and are on steady after a few seconds? If there is no Service 4WD light on and the selector switch light are correct, the only place for the problem to be is the Transfer Case. Has the Transfer Case fluid been changed at 50K mile intervals? This is very important.

Feb 01, 2011 | 2004 GMC Envoy

1 Answer

Just changed brakes on gmc envoy, coming to a stop abs light comes on and brake pedal pulsates a b it


Did you replace the rotors or at least have them machine ground to true? Out of round or warped rotors will do this. It's a pain I know but rotors should be replaced or ground to true everytime new brake pads are installed.
I hope my suggestions helps and all the luck to you.
burdfrenzy
http://stores.ebay.com/Pittsburgh-Joes-Pants-Nat

Dec 23, 2010 | 2006 GMC Envoy Xl

1 Answer

I was driving my 2004 Yukon XL and the "Service


Wheel hub bearing . When the ABS see's a problem will disable traction control an ABS an will turn on RED brake light as well . Fluid level has nothing to do with it .
SERVICE STABILITY
Refer to ABS Description and Operation in Antilock Brake Systems

Mar 17, 2017 | 2004 GMC Yukon

3 Answers

What service should be performed at 90,000 miles on a 2003 GMC Envoy XL?


I would look into a tune-up as the spark plugs are a common cause of issues on this vehicle. I would at the very least remove the plugs and inspect them. If they are fine then it may be a clogged fuel filter.
Check the coolant and oil level

Nov 04, 2009 | 2003 GMC Envoy Xl

1 Answer

Changed brake pads and fluid. Brake light/ABS light still lit.


Go back around and check to make sure you didnt accidentally pinch or cut a brake pad sensor. Also the ABS modules on VAG cars are pretty crappy.

Sep 11, 2009 | 1999 Audi A4

1 Answer

Service Brake system flashed three seperate times over 24 hours


2 suggestions:

(1) I would suggest someone scan the ABS system for codes. I Have an '03 silverado 2500HD Crew cab, and it needs an EBCM (Electronic Brake Control Module) "ABS module". "Service Brake System" message on dash, ABS and Brake warning lamps lit as well. May be the R/F ABS wheel speed sensor, but what you described happen, shouldn't have caused damage to it.
(2) If the aftermarket rim and tire combo are larger than stock (larger overall diameter), then this may affect the way your PCM functions. You can reprogram the PCM to recognize larger diameter running gear so trans shift points and the speedometer and such can function properly.
I hope this helps.

Nov 14, 2008 | 2000 Chevrolet Silverado

Not finding what you are looking for?
2004 GMC Envoy Logo

650 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...