Question about 2002 Jeep Grand Cherokee

1 Answer

2002 jeep grand ck 4.7lt code po161 what sensor will i replaced

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 8,273 Answers

I have circled the sensor in the picture. It is the bank 2 downstream O2 sensor.

2002 jeep grand ck 4.7lt code po161 what sensor - 9ed5f18.gif

Posted on Sep 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 jeep grand cherokee diagnostic trouble code P 0320? how do i repair?


No Crank Reference Signal at PCM No reference signal (crank-shaft position sensor) detected during engine cranking. Use this youtube step-by-step to fix it. How to diagnose P0320 crankshaft position sensor circuit failure

May 01, 2014 | 2002 Jeep Grand Cherokee

1 Answer

Car drags upon slow down and **** upon movement


CODE PO161 IS REGARDING OXYGEN SENSOR BANK2 SENSOR2 WHICH IT IS LOCATED IN THE BOTTOM RIGHT SIDE OF THE CAT ON THE OUTPUT OF THE CAT.REGARDING CODE P1135 IS FOR AIR FUEL RATIO OXYGEN SENSOR MALFUNCTION BANK1 SENSOR 1. MY OPINION CHANGE THE SENSOR BANK 2 AND RESET THE FAULT USING A SCANNER AND DRIVE IT. I BELIEVE WILL SOLVE THE PROBLEM.

Aug 31, 2012 | 2002 Toyota RAV4

2 Answers

I have a 2002 Jeep Grand Cherokee. I am getting a bad crank shaft sensor/misfire error code. I have replaced the crank shaft sensor, spark plugs and coil but the problem stiil remains. What else could...


Your engine will also have a Camshaft position sensor too (P0340). This can sometimes make the Crankshaft sensor code come on (P0335). Your misfire could be down to a low oil level or faulty knock sensor. You have ruled out the possibility of it being a spark related issue. Hope this helps...

Mar 10, 2011 | 2002 Jeep Grand Cherokee

1 Answer

I have a 2002 jeep liberty with engine light on. Took it to autozone for a diagnosis and code PO161 came up. I know its an O2 sensor, It says to check circuit fuse. Where do I find the circuit fuse and how...


P0161 is 02 heater Circuit ( Bank 2 Sensor 2 ). There is no mention of any Fuse and there should not be .Circuit refers to the two wires extending from the jeeps computer dirrectly to the 02 sensor in question which would be in this case Bank 2 sensor 2. So the computer is transmitting a signal to the 02 sensor and not receiving a sgnal back it automatically thinks the circuit is at fault, when it is not.It is not receiving any Data back from the 02 sensor because the sensor is defective and needs to be replaced. If you replace one sensor you should replace all 4 of them. If you only replace one then it will be transmitting Data back to the computer at a much faster rate than the other 3 old ones and this could cause more problems and more codes to be set by the computer.Remember to have all the codes cleared from the computer after all repairs are compleated, This will turn off the check engine light. Good Luck and have a good XMASS.

Dec 16, 2010 | 2002 Jeep Liberty

1 Answer

$250 oxygen sensor parts only 2002 Jeep GC too much? needed?


YEP A BAD OXYGEN SENSOR WILL CAUSE ENGINE TO RUN RICH.CAUSING UNBURN FUEL TO GO TO THE CATALYTIC CONVERTER AND BURN IT OUT.

Aug 23, 2009 | 2002 Jeep Grand Cherokee

2 Answers

Diagnostics "P1762 Manufac. Contrl. Transmission"


Had the same code on my 2002 Jeep Grand Cherokee. Started having shifting problems as well. Code is for governor pressure sensor on trans. Cost me about $800 for dealer to fix. No problems after part changed out.

May 22, 2009 | 2002 Jeep Grand Cherokee

2 Answers

2002 jeep grand cherokee with 4.0 engine will die but restart


I do not know what the error codes mean but know that When I has the sme problem with my jeep it was the fuel pump. What happens is when it heats up it es less and less fuel and chokes the engine. When cold it runs better. remember gas in the tank helps cool the pump but sounds like your pump needs replacing as it is starting to give out.

May 13, 2009 | 2002 Jeep Grand Cherokee

2 Answers

2002 Jeep Grand Cherokee Lardo misfiring


You say you changed the cam sensor. A1391 code is a crank sensor on the top of the trans. bell housing.

Feb 22, 2009 | 2002 Jeep Grand Cherokee

1 Answer

REJECTION STICKER OBD PO158


OBD Code P0158 02 Sensor Circuit High Voltage (Bank 2 Sensor 2). Hope this gives you some direction. Thanks for Using FixYa!

Sincerely,

JC

Nov 28, 2008 | 2002 Jeep Grand Cherokee

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

1,198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...