Question about 2006 Jeep Liberty

Open Question

MaHow do I reset the computer on my 2006 Jeep Liberty

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
keemo68
  • 1263 Answers

SOURCE: 2006 jeep liberty

the drain plug is located on the back of oil pan in the center. if you have a rock guard you have to remove this first. the pcv valve(positive crankcase vent is located on either the left valve cover in front or on theif it's a v6 or 8 or it is located on the valve cover in the back in a straight six it will have a hose that goes to your air filter breather box or the breather hose. please rate this...........thanks

Posted on Aug 30, 2008

Ad
  • 137 Answers

SOURCE: Inoperable Power Window 2006 Jeep Liberty

the window regulator needs to be replaced

Posted on Jan 19, 2009

Mikey108
  • 475 Answers

SOURCE: i have a 2006 jeep liberty and three lights are staying lit and

You need to take the jeep to a dealer or a good mechanic who can retreive the codes out of the computer. You may have a module problem but I will not guess without knowing the codes.

Posted on Feb 11, 2009

  • 110 Answers

SOURCE: 2006 jeep liberty cigarette lighter problem

its probably not the lighter itself, it's probably lost power. check the fuse for the cig lighter and see if blown. if it is, replace. if it blows immediately you have a dead short. if not, pay attention to when it stops working. could be a problem with whatever you are plugging in, or something else on the circuit

Posted on Feb 18, 2010

  • 6982 Answers

SOURCE: 2006 Liberty: My 2006 jeep liberty dies while driving and won't ...

Most common causes of that kind of problem are the fuel pump and the crank sensor. Crank sensor should set a code, pump won't. Less frequent but worth mentioning is the ignition switch. Do some testing using a haynes or chilton manual as a guide,. All you need for that is a digital multi-meter.
Before testing anything, check that all the ground points under the hood are clean and secure. there are more than just the battery to the block...check all the smaller ones as well.

Posted on May 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the position of radiator fan relay on jeep liberty 2006


no idea to be honest earlier jeeps had then at the front of the wing down below as i remember ?? newer one would i imagine be in the electrical box under the bonnet near the battery

Dec 02, 2016 | Jeep Cars & Trucks

1 Answer

Reset computer liberty 2006


double posted , with no symptom, so can guess what you are doing.

Mar 14, 2014 | 2006 Jeep Liberty

1 Answer

2006 jeep liberty rear lift glass won;t close


Mine did this too....the latch kept getting stuck. If you put the key in the ignition and unlock the power doors, pull on the gate door (don't open it, just enough to release the latch), and it should come out so the hatch will latch.

Feb 18, 2013 | 2006 Jeep Liberty

1 Answer

My 2006 jeep liberty abs bas light as well as car with sqiggly lines come on dash


I suggest scanned the computer in order to know what is the specific fault code stored there; note it and send us for other details.

Dec 05, 2012 | 2006 Jeep Liberty

1 Answer

My 2006 jeep liberty won't supply fuel


check the fuel pump,fuel filter or the fuel fuse

Oct 13, 2012 | 2006 Jeep Liberty

2 Answers

Need to reset perform service light after oil change.


Press the step button until miles to service comes up, then press and hold the reset button.

May 09, 2009 | 2004 Jeep Liberty

1 Answer

I have a 2006 jeep liberty and three lights are staying lit and


You need to take the jeep to a dealer or a good mechanic who can retreive the codes out of the computer. You may have a module problem but I will not guess without knowing the codes.

Feb 11, 2009 | 2006 Jeep Liberty

1 Answer

Inoperable Power Window 2006 Jeep Liberty


the window regulator needs to be replaced

Nov 17, 2008 | 2006 Jeep Liberty

Not finding what you are looking for?
2006 Jeep Liberty Logo

Related Topics:

378 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...