Question about 2004 BMW Z4

1 Answer

My car will not start it is a 5 speed and we tired pushing it off and it wouldn't start the battery is good all the lights will come on but the motor will not turn of the car will not do anything when the igination is turn on

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Contributor
  • 613 Answers

You check and see if you have a fuel pump reset switch on the car not sure about this car but sounds like the problem

Posted on Sep 13, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wont start with key


Do you have a bad starter? also check for loose or dirty battery cables on both ends of cables as the starter does take a lot of pull and a dirty or loose cable won't give it the power to start but will let the lights work.

Jun 28, 2014 | 1999 Jeep Cherokee

1 Answer

Engine wont turn


it seems like your starter may be going out. take it to Sears auto or Gateway tire to have them check it

Jul 17, 2013 | 2012 Chevrolet Chevrolet Cruze LS

1 Answer

I have a 2001 buick regal ls, the problem I'm


Have a look for a hole in the block where the oil is coming from. If you have one you have blown a motor.

May 26, 2013 | Cars & Trucks

1 Answer

Flashing dome light, broken horn, and slow windshield wipers... what can it be?


if your hearing a clicking sound when pushing the horn button then it sounds like you need to replace the horn the diaphram is probably no good.if it was a bad connection you wouldn`t hear a clicking noise.the slow wipers sounds like it could be a poor ground on the wiper motor.you can run a separate ground wire to the wiper body and if the wipers work at a normal speed then that is all you have to do.if not then the power wire needs to be checked for battery voltage if its good then the problem is likely the wiper motor itself.the flickering interior light may be the light switch maybe moving just enough to make contact to allow power to the light.make sure the switch is into the off position and see what happens.

Jan 10, 2012 | 2004 Pontiac Sunfire

1 Answer

I have a 2006 Dodge Charger. Went out yesterday, car started fine. Got home and stooped at my mailbox, when I went to start the car it wouldn't start. I did notice the lights on the dash would go dim...


I'd start with a battery first. Sounds like the battery has 1 or more dead cells in it. the battery may have all the volts you could want but if it doesn't have the proper amperage it won't crank the motor. You can have the battery load tested for free at Auto Zone or Advance Auto. A simple down and dirty test would be to disconnect the Positive cable and jump the vehicle by connecting directly to that and a good ground on the block. The motor should turn over as long as the vehicle you use as a jump has the proper amperage in it's battery. If the vehicle starts then it is the battery, if it doesn't then you need to look at the starter and other components.

Jun 26, 2011 | 2006 Dodge Charger

1 Answer

5 spd Pt will only push start after it was overheated. After push start it dies at idle. Timing? Will not battery jump start.


check to make sure your getting good gas up to the motor, take a screw driver and press the tip of it into the fuel pressure relief valve (it is one the side of the intake manifold, looks like a tire valve) gas should shoot out if it just drips out your not getting good gas up their and need to change the fuel filter and clean the injectors, also could be the engine coolant temp. sensor! If this don't work get back to me and I will tell you other things!

Jan 11, 2011 | 2004 Chrysler PT Cruiser

2 Answers

Service tire monitor light is on


is it just a dummy light on the dash or is it more specific like L.F tire low,ect? if its a dummy light then you need to go to a garage with a tire pressure monitor service to to check to see if the batteries in the monitors are still good or if you are just dealing with a leaking tire. If you Tahoe uses wheel speed sensors to monitor tires and pressure you may have a faulty wheel speed sensor or a heads up that your wheel bearing is wearing and the gap between the tone ring and sensor have increase or decreased good luck

Apr 07, 2010 | 2005 Chevrolet Tahoe

3 Answers

The check tire pressure light and ABS auto traction sensor light keep coming on. Tire pressure is good


The tire pressure monitor detects any changes in the tire inflation pressure. Therefore, it must initialize and store it in its memory if the tires or wheels have been replaced, re-inflated or the tires have been rotated. You should be able to re-initialize the system by following these steps:

1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

Aug 11, 2009 | 2004 Cadillac Deville

Not finding what you are looking for?
2004 BMW Z4 Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...