Question about 1993 Mazda 626

1 Answer

My 1993 mazda 626 6 cillender will not starte it turns over but will not start it worked just fine and it ran out of gas and i put more in it and now it wont start

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 149 Answers

My gave caused the fuel pump to go out. have the fuel presure or maybe a relay. it may just need to primed to get it going.

Posted on Sep 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to find out whats wrong with my 1993 mazda 626 it ran then quit and wont start it turns over but wont fire


You start by having the Mazda "MECS" (Mazda Electronic Control System) system scanned for fault codes, checking the timing belt for failure and seeing is the engine is getting fuel pressure.

Aug 28, 2013 | Cars & Trucks

1 Answer

1993 mazda 626 auto, starts fine when cold, but not when I've driven it for a while.


I would start with a good tune up, including the intake gasket. Changes in temperature could cause gaskets to stop sealing properly letting unmeasured air inside the engine. Also check for fuel filter.

Mar 26, 2013 | 1993 Mazda 626

1 Answer

2002 mazda 626 acts like not getting gas and will not start, engine turns over but not starting.


SOUNDS LIKE UR TIMING BELT MAY OF SNAPPED,BEING IT
DIED WHILE DRIVING.

Sep 12, 2012 | 2002 Mazda 626

1 Answer

Car ran out of gas, now it will not start


sometimes when you run out of gas your fuel pump is dry ,you need to put lots of gas in then turn your key to the on position with out turning over the engine ,you should be able to hear your fuel pump cycle if it still wont start ,pump the accelerator pedal a couple of times then try and start it

May 14, 2010 | 1999 Mazda 626

1 Answer

Charge light, abs light, and rear light. Mazda 626 1993 2.5L


It can be as simple as the funny belt tensioner on the alternator!

I hope you got a simple volt meter to check the voltage.


12.8-13.6V is a health battery.

Get someone to help you to put tension on alt. belt.

If it does not look good then change it.

Double check all belts.

The should not give over 1/2" I like to keep them 1/3" of less.

Tighten all connections.

Pull spark plug cap one at at time to check for corrosion.

The coil can cause a lot of problem.

Spend time to grounding and secure all coil boot.


Good luck

Jul 15, 2009 | 1993 Mazda 626

1 Answer

1993 mazda 626: could not get trans out of park!


Ignition lock is activated: You over rode it but still have original problem. Alarm system might be confused. SO....

1 disconnect battery negative (-) cable(make you have radio code if any) to reactivate radio, which works anyway if code was never set.

2 press brake peddle for 5 seconds

3 reconnect negative cable to battery.

use key and twist diver door lock to OPEN (this resets alarm which might have caused ignition lock module to activate.

You should be able to turn on the ignition, start the engine and shift out of park. Hope this helps.

Jun 10, 2009 | 1993 Mazda 626

1 Answer

My new 94 mazda 626 2.0 is very hard starting


tap on the gas a couple of times then try to start it.

Apr 28, 2009 | 1994 Mazda 626

2 Answers

My sons 1990 626 ran great. I change the oil and reconnected the speedometer cable that had vibrated loose. took it for a drive to make sure I didn't have any oil leaks. It ran for about 5 minutes and just...


we'll assume fuel is good..leaving spark and air..and management of systems(computer /sensors)...so the speedo cable was disconnected? try taking it loose again , test drive and report back please

Nov 20, 2008 | Mazda 626 Cars & Trucks

1 Answer

Mazda 626, 1995 won't start


FUEL PUMP MIGHT NOT WORK. CHECK TO SEE IF IT HAS SPARK.

Oct 28, 2008 | 1995 Mazda 626

Not finding what you are looking for?
1993 Mazda 626 Logo

Related Topics:

233 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...