Question about 2006 Nissan Titan

1 Answer

Fan blower only blows high - 2006 Nissan Titan

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 149 Answers

Check for lose conection and if thats ok mybe the low side of fan motor relay.

Posted on Sep 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Weak blower motor


Check good voltage and ground for blower motor. Actuators under the dash may be restricting air flow? High speed doesn't usually use a resister.
Check for hvac trouble codes, in my part of the country, some of the national brand autostores will check codes for free, if there are any.
If you think problem with blower motor, itself, replace it. Sometimes, you can remove blower motor, use jumper wires for voltage and ground, using inline fuse, come off the battery, see if it blows like you think it should?

May 07, 2016 | 1999 Chevrolet Lumina

1 Answer

2008 navigator fan blows high as long as the car is started and won't turn off.


You will need to replace the blower motor speed control module/resistor, it is burned out. it is located next to the blower motor.

Feb 28, 2014 | Lincoln Cars & Trucks

1 Answer

Ac will not blow out vents


Hi, each fan or blower have switch to work on high and low blowing air. Check your blower switch first.

Jul 19, 2013 | Nissan Titan Cars & Trucks

1 Answer

2000 buick regal blows high fan fuse as soon as it is put in with car offf


I would disconnect your blower motor resistor then try fuse again, if it does'nt blow then it is either blower motor or resistor,these resistors are common for going bad/and or blower motor. Good luck let me know if you need more info or if this didn't fix it, I will research it more for you

Jan 03, 2012 | 2000 Buick Regal

2 Answers

A t600 kenworth 2000 model the blower motor only blows on high is it the resister


Yes - you diagnosed the problem yourself. The classic symptom of a heater that only blows on the "High" setting is a burned out/damaged or otherwise inoperative blower resistor.
Replacing the resistor should return the two missing blower fan speeds.

Dec 05, 2011 | Cars & Trucks

1 Answer

Why wont my a/c or heater fan come on?


When the blower works only on the high setting its usually a bad blower resistor which is right near the blower motor. now you say it would always blow high regardless of the fan speed setting that would indicate probably the climate control unit or a connector problem somewhere. finally it not working at all may be the climate control unit or connection went bad even further. it might have a blown fuse or a bad blower motor in addition to the climate control unit or connector problem .check for power and ground at the blower motor. the power is supplied from fuses and may have a relay also. the ground is supplied from the climate control unit and goes through the resistor to control the fan speed. good luck

Oct 30, 2011 | 1997 Lincoln Continental

1 Answer

A/c is cold but the fan is not working to blow it into the car stopped working on high first now will not blow at all


Check your blower motor resistor. It is commonly the part that the blower motor power connector plugs into. It sounds like the high speed element went first and you lost the high fan speed. If the remaining resistor element is broken, the fan will stop working. The resistor only have 2 elements; if they're both broken, it creates an open circuit to the blower.

Jun 24, 2011 | 1996 Mercury Mystique

1 Answer

Ac blower fan problems


change the blower resister module,if this doesnt work replace the control head

Jul 05, 2009 | 2000 Dodge Ram 3500

1 Answer

2001 Town and Country has only high speed fan both front and back fans. Connector to fan has 12v only on one of the 6 leads. Grounding the lead with the 12v on it turns fan on high speed. Where is...


if the blower only blows on high then it is you blower motor resistor that is located behind the glove box it has two screws that hold it in place

Jun 19, 2009 | 2001 Chrysler Town & Country

2 Answers

Does ac blower have a fan relay ? It doent blow ******* max


if it doesnt work on all speed its the blower motor resistor that broken thanks pierre

Jul 30, 2008 | 1979 Pontiac Firebird

Not finding what you are looking for?
2006 Nissan Titan Logo

Related Topics:

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...