Question about 1989 Toyota Pickup SR5

Open Question

Where's the fuel filter located on a 1989 toyota pickup sr5,3.0 v6

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76848 Answers

SOURCE: where is the fuel filter located on 93 sr5 v6 4wd

I did this last night and it took me about 3 hours. You will need some 12mm, 14mm, and 17mm wrenches and sockets, and a couple of long extensions for your socket. Disconnect your battery, remove the front passenger tire, and then disconnect your power cable on the starter (12mm nut). Remove the starter (one 14mm bolt on bottom, one 14mm nut on top). You'll probably have to use your extensions to get that top nut off. Then take the banjo nuts off the filter, let it drain a minute, and unbolt it from the engine. Put the new one in, tighten the banjo nuts with a torque wrench to 22lbs, and start reassembling everything. Assembly goes a lot faster than disassembly. Keep in mind that this thing is in the worst possible position, and there is no way for you to reach anything, fit your hand where it needs to go, and is a giant contortion act from beginning to end. I hope the sorry Japanese engineer that came up with this idiotic configuration reads this and commits seppeku, or at least gets some bad fugu

Posted on Aug 12, 2009

Ad
roniecon
  • 6927 Answers

SOURCE: 1989 toyota sr5 pickup what is the part that has

Fuel pump assembly.

Posted on Jun 21, 2010

Biggdex35
  • 333 Answers

SOURCE: location of a/c relay on a 1994 toyota sr5 v6

It should be in the owners manual. I was just wondering, will it not come on but you have enough pressure on freeon? Because if the pressure is low it won't let it come on. If you hooked up guage and have enough pressure it could be the low pressure switch. It is located on the canister right beside where you hook up the guage. Unplug it and cross the two wires out. Place a jumper wire in the end of the plug and see if it will come on then.

Posted on May 17, 2010

  • 65 Answers

SOURCE: I'm trying to change my fuel filter on a 1995

Try soaking it down with WD-40 and letting it sit for a bit. Usually you can heat up a sticky screw/bolt and get it to break, but since youre next to the gas tank, its not recommended.

Posted on Jan 05, 2011

vetteman3002
  • 2299 Answers

SOURCE: I have a 1989 Toyota

I would suggest the throttle positioning sensor.

Posted on Jan 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 1989 Toyota 3.0 v6 4x4 pickup it has spark and getting fuel but wont start.


Your firing order is out of sync......if your getting spark you are firing in the wrong cylinders to actually start the vehicle. Or your ignition module or stator is bad, you will need to prob your electrical to figure out the where the problem lies.....my first would be not firing cylinders correc

Jan 17, 2015 | Toyota Cars & Trucks

1 Answer

1989 camery v6 wont start


For fuel line diagram,check the link below:----

Toyota Fuel line diagram
http://technoanswers.blogspot.com/2012/12/toyota-fuel-line-diagram.html
--------
These will help.Thanks.

Dec 06, 2012 | 1993 Toyota Camry V6

1 Answer

Where is the fuel filter located on a 1989 toyota 4x4 v6 3.0vze extended cab pickup?


look under neath truck start from the gas tank follow fuel lines you gonna run into the filter looks like a small silver barrel good luck

Mar 22, 2011 | Toyota Pickup Cars & Trucks

1 Answer

1989 Toyota Pickup Truck V6 4x4 sending unit?


the gas gage sending unit is defective, it is located of course inside the fuel tank.

Oct 08, 2010 | 1989 Toyota Pickup SR5

1 Answer

Oil capacity for 1989 toyota v6 pickup


Capacity with filter change for V6 4x4 should be 4.8 qts. V6 2x4 should be 4.5 qts.

Jun 01, 2010 | 1989 Toyota Pickup SR5

1 Answer

Where is fuel filter located on 89 toyota pick up 4x4


Right side of the engine, you get at it through an access panel just above the right front wheel.

May 04, 2010 | 1989 Toyota Pickup SR5

1 Answer

Ware is the fuel filter on 1992 toyota 4x4 pickup


1992 toyota pickup 4wd V6 3.0L SOHC. The fuel filter is located on the right frame rail underneath the passenger compartment.

Mar 28, 2010 | 1992 Toyota Pickup

1 Answer

88 toyota pickup v6 wont stay running


Early Toyota fuel injection use a cold start injector, it only works when the engine is cold. It is located in the intake manifold. for the mean time you can turn up your idle by turning a flat head screw in your intake manifold counter clock wise . It could be a coolant temp switch for the injector that has gone bad also.

Mar 26, 2009 | 1985 Toyota Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

458 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8589 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...