Question about 2001 Dodge Ram 2500 Truck

2 Answers

I have a 2001 dodge diesel 2500 i had the lift pump and the injector pump replaced by a diesel shop now after you drive it and it warms up it whants to over crank and the fuel pump runs longer than it should but it does not do it when it is cold when i took it back to the shop they replaced the injector pump and the lift pump again and it still does the same thing they droped fuel tank said all looked good did the preasure test every thing came out good they said they didnt know what else to to do to it got to be something simple they replaced fuel filter thanks for your help

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 96 Answers

Im not to familiar with the cummins but, If you have a pdm box on it thats probably the culprit. If they have them it should be mounted by or on the intake somewhere. Its a little black box with a plug going to it. If this is the problem they are pretty expensive. Hope I was of some help.

Posted on Sep 13, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 387 Answers

Did you check it by diagnostic tools, what does it said, i i know, you have to change the fuel pressure control module, or check the FPCM wiring first

Posted on Sep 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 1999 dodge ram2500 diesel. been running fine. parked for about a week (have had temps in the low 20's). started and ran for about 5-10 sec (rough). now will only crank and not start. Replaced lift...


the best advice i can give you is bring it into a warm garage and let it heat up, then treat your fuel with anti gel solution run it through your injectors by running engine and this should not happen again, seems like your lines are gelled up and you don't have proper pressure.

Jan 18, 2010 | 1999 Dodge Ram 2500 4WD

1 Answer

2001 Dodge 2500 4wd, running down the road pulling my camper and truck began to gurgle like diesels do under heavy load. Lost some power after a few minuits it heated up about 10 degrees and continued to...


Sadly, I'm of the same opinion of whoever gave you the last suggestion. Maybe, just maybe, you have a couple of bad plugs, but I'd be looking at the lift pump and possibly injectors/rails.

Jul 13, 2009 | 1999 Dodge Ram 2500 4WD

2 Answers

99 ram diesel wont start


Did you check to see if there is power to the glow plugs if not then that may be the problem and if there is power when you cycle the key not to start but for the plugs to warm up you may have a bad glow plugs.

Apr 22, 2009 | 1999 Dodge Ram 2500 4WD

4 Answers

2004 dodge ram 2500 5.9 diesel hard to start


The lift pump is bad Check the fuel pressure with a test gauge.

Jan 04, 2009 | 2004 Dodge Ram 2500

1 Answer

Fuel presure dodge diesel ?


all i can tell you is that as long as you dont go below 4 psi you should not starve injection pump, this is a minimum psi though., 10-13 psi is average on my 2002 at service port.

Dec 27, 2008 | 2001 Dodge Ram 2500 Truck

1 Answer

Engine misses at a constant speed


i had the same problem happen to me. i had to change the injectors and the injector pump to solve the problem. i would check the lift pump first. when the engine is cold it hasnt had time to pressurize the line.does it restart and run fine when it is warm. if so i would change the lift pump. if not i would have a pressure test done on it. i hope this helps

Nov 13, 2008 | 2001 Dodge Ram 2500 Truck

3 Answers

Ran out of diesel on a 2002 dodge ram 2500 cummins...need to know how to bleed the system


just bump the ignition without starting it let sit for 20 seconds oruntill you hear lift pump shut off then shut off ignition and repeat do it 2 or 3 times should start then cummins is a self priming system has been for years even in semi trucks

Aug 10, 2008 | 2001 Dodge Ram 2500 Truck

Not finding what you are looking for?
Cars & Trucks Logo

599 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...