Question about 2007 GMC Yukon Denali

1 Answer

Keyless entry not working on a 2007 GMC Yukon. Two remote do not work. I tried changing batteries. Also, check the keyless entry fuse and it was good. Any other things to check.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

My remote start ont work but door locks work 2007 buick

Posted on Jan 23, 2012

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2007 gmc yukon denali wont unlock w/ keyfob

Check the buttons.. I have an 06 Grand Prix with the Remote starter on the top and it seems that the conductor on the buttons worn out.. Take the keyfob apart, pull the rubber buttons off the chip, lick your finger and touch the place where the unlock (right side of the fob) would be. That should unlock your doors. I just did it with mine. I would just buy another fob on ebay and change the buttons out.. Hope this works

Posted on May 24, 2010

  • 1 Answer

SOURCE: 2007 GMC YUKON. Keyless Entry problem. The remote ...

Disconnect the battery to the car for five mins. Thay should reset the keyless module. I had the same problem

Posted on Feb 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Once my keyless remote is programmed to my 2007 Yukon, after a few hours it will no loger work...Battery replaced and tried all three remotes...same thing on all, what can i check next


Most likely the remote is falling out of sync with the car due to repeated accidental button presses in your pocket. You can try moving to the car and holding the button down for 30 sec. Works on some.

Oct 22, 2014 | 2007 GMC Yukon

1 Answer

Keyless remotes not working


Try reprogramming the remotes. Here are the instructions for the procedure. Hope it helps. Cobra!
Programming NOTE: All keyless entry remote transmitters (15K601) must be programmed at the same time.
NOTE: To program (or reprogram) the keyless entry remote transmitters into the RAP module, perform the following steps:
  1. Make sure that the anti-theft system is not armed or triggered.
  1. Turn the ignition switch (11572) from OFF to RUN eight times within ten seconds, ending in RUN. If the RAP module has successfully entered program mode, it will lock and then unlock all doors.
  1. Within 20 seconds, press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed. Repeat this step for each transmitter.
  1. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to Inspection and Verification.
  1. Turn the ignition switch to the OFF position, or wait up to 20 seconds after step 2, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the RAP module will lock and unlock all doors one last time to confirm.

Jun 06, 2010 | 1998 Ford F150 Regular Cab

1 Answer

2007 gmc yukon. Keyless Entry problem. The remote quit working but the gmc place said its not the battery. Help


Disconnect the battery to the car for five mins. Thay should reset the keyless module. I had the same problem

May 20, 2010 | Cars & Trucks

1 Answer

2007 gmc yukon denali wont unlock w/ keyfob


Check the buttons.. I have an 06 Grand Prix with the Remote starter on the top and it seems that the conductor on the buttons worn out.. Take the keyfob apart, pull the rubber buttons off the chip, lick your finger and touch the place where the unlock (right side of the fob) would be. That should unlock your doors. I just did it with mine. I would just buy another fob on ebay and change the buttons out.. Hope this works

Apr 23, 2010 | 2007 GMC Yukon Denali

1 Answer

My toyota 2007 yaris 4dr sedan keyless entry not working


they may need to recode your pad see dealer

Dec 30, 2009 | 2007 Toyota Yaris

2 Answers

Keyless entry for my 07 Chevy Impala works on and Off


my 2006 impala keyless remote dont work i change the battery still the same problem the spare remote same problem how to solve this problem

Jul 21, 2009 | 2007 Chevrolet Impala LS Sedan New Cars

2 Answers

Purchased used. have remote for keyless remote.


That you need to take it to a car stereo dealer that install NEW keyless entry's...Sorry, thats the easiest way to fix this issue.

Jun 14, 2009 | 1999 GMC Jimmy

1 Answer

Keyless remote entry does not function, panic button does.


This link will take you to very good instructions try it worked for me www.wikihow/program-a-keyless-entry-for-a-chevy-silverado this works on GMC models also.

Mar 30, 2009 | 1999 GMC Sierra

1 Answer

How can I fix my keyless entry --wont work (changed bettery)


my keyless entry does not work and i change my battery for both the remote is there another battery or fuse

Mar 23, 2009 | 2002 Chevrolet Suburban

Not finding what you are looking for?
2007 GMC Yukon Denali Logo

962 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...