Question about Plymouth Sundance

1 Answer

93 plymouth sundance.....what is the easiest way to know if my engine seized? it just stalled and no longer tries to turn over but doesn't start...the heater line had been leaking for a while and leaking oil. It had continually run until it overheated. I would add water every 20 miles or so.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,382 Answers

Hi, you have to first of all take your car to the nearest Auto zone around you to make the car scanned for any code. If the car produces any code, the code will be interpreted to detect the cause of the problem which will eventually lead to a solution.
Or else we will only be doing a trial and guess job in trying to resolve the problem which may further complicate the problem....

Posted on Sep 12, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do you change dimmer switch on 93 plymouth sundance duster

Follow wires from headlight back to a small dimmer relay switch. should be on one of the engine side of the front wheel well.

Mar 31, 2015 | 1993 Plymouth Sundance

1 Answer

1991 plymouth stalled and oil light on

The oil pressure light can/will keep power from reaching the fuel pump. So you would need to check oil pressure first.
Then once the oil pressure light problem is resolved checking the fuel pressure might be next.

Feb 03, 2014 | 1991 Plymouth Sundance

1 Answer


chrysler does not use a MAF sensor on any of there engines. They use a MAP sensor (mass air pressure). What engine to you have?

I’m happy to assist further over the phone at

Jul 26, 2012 | 1993 Plymouth Sundance

1 Answer

How to relieve gas pressure off fuel filter of 1994 2.2 liter plymouth sundance

disconnect power supply to fuel pump, then start engine when engine stalls fuel pressure released

Jun 02, 2012 | 1994 Plymouth Sundance

2 Answers

Where is te starter on a 1991 plymouth sundance what is it hooked

The starter is located on the bottom of the engine, where the engine and transmission meet. It is on the side of the engine closest to the front of the car. The easiest way to find it is to follow the positive battery cable, as it goes directly from the battery to the starter solenoid.

Jan 22, 2010 | 1991 Plymouth Sundance

2 Answers

87 Plymouth Sundance keeps stalling!

If you take the air intake hose off at the throttle body inlet, and when it won't start, try spraying WD-40 into the front of throttle body, with plate open, and then try again. If it starts for a second or 2, it's fuel related problem. Try that and let me know the results, and get back to me. Use the WD-40 same as you would quick start spray. What engine is in that , 6 cyl, or 4 cyl. ?

Nov 12, 2009 | 1987 Plymouth Sundance

1 Answer

1993 Plymouth sundance will not start

Check battery terminals are clean and tight.Then check ground from battery to engine making sure they are clean and tight.

Jun 11, 2009 | 1993 Plymouth Sundance

1 Answer

Stall as soon as oil light came on..92 sundance

I don't think a 92 sundance will shut the fuel pump down when the oil pressure is low, but it might. Can you get it to run on carb cleaner. If it is oil pressure, the car should start then run a few seconds and die. Have you checked the timing belt? If it broke the distributor will stop turning which would stop the oil pump.

Jun 05, 2009 | 1992 Plymouth Sundance

1 Answer

'89 plymouth sundance

You need a timing belt

Aug 09, 2008 | 1989 Plymouth Sundance

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides