Question about 1995 Pontiac Bonneville

1 Answer

Engine turns over definately have fuel but wont fire car has sat for 2 months

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

Check for spark. 3.8 engins work off the crank sensor. If you have no spark it is likely the crank positioning sensor.

Posted on Sep 15, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 concord, 2.7 engine v6 crank engine 1st time wont start. Turn key off and crank again and will start.. If warm engine and not sat long will fire first crank.


Test the fuel pressure regulator. It has a check valve in it to maintain fuel pressure when the engine is not running.

Dec 19, 2016 | 2003 Chrysler Concorde

1 Answer

Have 1999 vw jetta engine code c 2.ol 4cyl. just did a motor swap. same year same engine. turns over but wont start gets fuel to the rail and injectors but wont fire...if i hold a rag over it starts


if donor motor was a runner
should have worked and started no issues

if fuel and spark is there
something not connected
crank angled sensor

if engine light is on has fault codes






26342882-a1nesnqyiybqlbjizw04a1uj-4-0.jpg

Nov 06, 2016 | Cars & Trucks

1 Answer

Truck fires really well but wont start, seems like no fuel


Please define "fire power". Is this just the power from the battery swinging the engine, or did you check if there is a healthy spark on the plug wires? If an engine dies without warning, the chances are very good it is the crank angle sensor in which case there will not be any spark on the wires even though the starter will swing the engine quite lustily without starting.

Feb 16, 2015 | 1995 GMC Sierra

1 Answer

1989 TLC Gas engine...wont start


Check to ensure fuel pump fuse hasn't burned out. Try spraying starting fluid directly into the throttle body to see if it tries to catch.

Nov 16, 2013 | 1989 Toyota Land Cruiser

2 Answers

95 camry has spark and fuel but wont start


your engine could have jumped time,or you may want to have computer (ECM) checked.hope it gives you something to check

Jun 02, 2012 | 1995 Toyota Camry

1 Answer

Auto trans shifter shifts p-r-n-d-2-1 it wont shift out of 1st .. sat for 8 months i drove it 50 miles 5 days a week for 9 years serviced reg. never any troubles before i started it i changed oil filter...


There must have been a 'Check Engine' Light? When a 'check engine light' (MIL=Malfunction Indicator Lamp) is turned on, there is a DTC (Diagnostic Trouble Code) set/stored in the ECM/PCM (Engine Control Module/Powertrain Control Module). This code identifies which engine management system component/function experienced a malfunction. Once you pull/read this code, you may begin diagnosis. You'll need an OBDII (On-Board Diagnostics II) code reader. You should find a P07?? number stored (P07??... is a transmission code).

Aug 31, 2011 | 2000 Hyundai Elantra

1 Answer

Car will turn over but will not start the car sat for a month it did start at first then it stoped i toke all the distpitor wires off one at a time and replaced them and it would start but now it wont...


The engine is probably flooded (Way too much fuel) If the fans are running all the time, it is usually caused by a bad Engine Coolant Temperature Sensor. This will also cause the injectors to open all the way and flood the engine. Replace the Coolant Temp Sensor, then hold the throttle all the way to the floor while you crank the engine. This puts the computer in "Clear Flood Mode" and will shut the fuel off so the excess gas can get out of the cylinders. This should make it start.

Jan 31, 2011 | 1995 Mercury Sable

1 Answer

HAVE SPARK DUMP FUEL WONT START SAT OVER NIGHT TRK FIRED RAN A LITTLE AND WONT START AGAIN


REPLACE FUEL FILTER FIRST CRANK ENGINE.WHEN IT DIES AGAIN GET A FUEL PRESSURE READING WITH ENGINE OFF.IF FUEL PRESSURE REAL LOW OR ZERO FUEL RELAY FAULTY OR FUEL PUMP RELAY.FAULTY.

Aug 30, 2010 | 1991 Ford F150

1 Answer

1999 blazer wont start??


Your battery is either faulty or ther is a parasitic drain, have it checked out at parts house. With a good battery installed, spray some starter fluid into intake housing. If it starts, then dies, you have fuel pressure/delivery problems. Can you hear the fuel pump run when you turn on the key? Hope this helps.

Dec 18, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1995 Pontiac Bonneville Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...