Question about 2004 Dodge Intrepid
P 0700 is basically a "generic" code signifying that the Transmission Control Module has detected a fault somewhere within the transmission's electrical system (typically a shift solenoid malfunction). If you see P 0700, take your car to some place that can plug a scan tool into it and retrieve the other codes which are causing your car to display the P 0700 code.
Posted on Sep 13, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Remove the top hose, unbolt the thermostat housing, remove old themostat and install new unit with new gasket. Replace top hose and fill with coolant. Be sure to re-check the coolant level after start up, beore you drive it anywhere, to eliminate any air pockets in the coolant.
Posted on Mar 22, 2010
Testimonial: "Thanks for the information it did help"
SOURCE: OBD2 DTC P0700 &P0733
Transmission Control System Malfunction
Gear 3 Incorrect ratio
INFO FROM http://autorepair.about.com/cs/troubleshooting/l/bl_obd_7.htm
hope this helps.....good luck!
Posted on Dec 25, 2008
SOURCE: limp mode?
It may have a "loss of prime" code that usually follows a service of the fluid and filter. After you're sure the fluid is full at operating temperature, disconnect the battery for a few minutes and reconnect to see if the code resets. I hope this helps.
Posted on Apr 26, 2009
SOURCE: what do i need to
(DTC) CODE # P0700....Transmission Control System (MIL Request) Translation: Transmission Control Module (TCM) Malfunction or Failure. P0700 Information Code The Transaxle Control Module (TCM) monitors the malfunction of sensors and actuators relating to transaxle control. If any malfunction is detected, the TCM informs the PCM by sending a signal (P0700 code). P0700 means that a code has been set in the TCM. This code is for information ONLY. If this code is present, check for transaxle codes. So basically, the P0700 code is telling you to check the TCM for a transaxle DTC. The TCM can not turn on the check engine light so it has the PCM do it.
I hope this helps....let me know if I can assist further !!
Posted on Feb 21, 2011
Tips for a great answer:
Oct 29, 2015 | 2002 Dodge Intrepid
May 13, 2015 | 2001 Dodge Intrepid
May 27, 2012 | 2002 Dodge Intrepid
Oct 25, 2010 | 1997 Dodge Intrepid
Nov 20, 2009 | 1999 Dodge Intrepid
Oct 01, 2009 | 2003 Dodge Intrepid
May 22, 2008 | 1995 Dodge Intrepid
1,367 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: