Question about 1997 Chevrolet Cavalier

1 Answer

Need to remove dash on 97 cavalier. The heat and airconditioner selector does not work

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

There is a how to with detailed instruction on use the search function.

Posted on Sep 13, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Car chevrolet cavalier 2004

Sometimes on Cavaliers and Sunfires giving the area right above the dash a good WACK brings the dash back on line.If this does not bring it back,a good used dash would be the next thing to try.An easy change.

Mar 01, 2018 | Chevrolet Cars & Trucks

1 Answer

97 cavalier heater control only comes out vents

check the vacuum line going into the firewall near the blower motor for the blend door. line may have dislodged or possibly broke from vacuum source.

Feb 02, 2013 | Chevrolet Cavalier Cars & Trucks

1 Answer

Why my 97 ford ranger with a 2.3 wont switch from cold to heat

if the heater hoses are hot, its usually a sign of a faulty temp selector or one of the blend doors under the dash. The blend doors direct air flow thru the heater core and the vents.

Oct 07, 2012 | Ford Cars & Trucks

1 Answer

How to change out the airconditioner blower motor on a 97 ford mustang

Blower motor normaly under passenger dash. May have to remove plastic cover from under dash. Normally only held in by 3 or 4 screws

Jul 02, 2012 | Ford Cars & Trucks

2 Answers

Looking for information on dash light symbols

Here can find this information: GM Owner Center

I hope helped with this (remember rated this help) Good luck.

Dec 09, 2009 | 1997 Chevrolet Cavalier

1 Answer

My 1988 toyota camry: airconditioner/heat doesn't work

The heater may not work because of a bad thermostat, low coolant, or a bad sensor at the engine. It can also be a bad resistor valve under the dash. The resistor valve is connected to a wire plug on the blower motor under the dashboard. It needs to be replaced. Th AC may need to be refilled with refrigerant or the compressor may be bad.

Nov 18, 2009 | 1998 Toyota Camry

1 Answer

97 Silverado K1500 350 VTEC 5.7 Stuck in 4 Wheel Drive

If it has the push button 4wd selector on the dash, it is most likely the transfer case encoder motor. Not to bad to replace but you will have to remove the front driveshaft.

Aug 19, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

91 cavalier manual trans....stuck in reverse

You need to remove top off gearbox and with a pry bar or screw driver pull the selector back into neutral Your gearlever has popped out of selector Gearbox does not need to be removed

Jul 09, 2009 | 1991 Chevrolet Cavalier

1 Answer

97 cavalier 2.2

If the car goes in to park and fully engages then it selector needs alignment. Thats very common.

Jan 19, 2009 | 1992 Ford Explorer

1 Answer

Removal of factory stereo from 97 cavalier

First remove the vent from the middle of dash up by windshield. It has one philips head screw, then has a clip on each side.

Then you need a 7mm. First there are two screws under were the vent you just took out was. One is longer than the other.

Next take the side covers off each side of the dash, these are the sides of the dash were the door panel meets the dash. I believe there was either one or two screws on each side after the cover is popped out.

Next open the glovebox, there are two gold screws up through a hole in the top of the glovebox, they hold the airbag in. Then there are like four more along the edge of the glovebox were the top of the door would meet the dash.

After all those screws are out then you can take the top dash cover out, but your not done yet.

After the top cover is out you will have like four more screws they go straight down right behind the face of the dash. After they are out the rest is clips and unplug the wires for the lights and lighter. After its free remove it,

Now you can take the two or three screws holding the radio out and pull it out. Now just reverse the whole thing and pray for no extra screws or broken tabs.

It takes more time than it is hard, just don't try and rush it or you'll be calling salvage yards for parts. Hope this helps.

Dec 27, 2008 | 1997 GMC Sierra K2500

Not finding what you are looking for?
1997 Chevrolet Cavalier Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides