Question about 2000 Ford Explorer

1 Answer

Rear window latch does not release - 2000 Ford Explorer

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Try pushing in on it as u open it and if it dos open spray some wd-40 on the latch

Posted on Sep 15, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When opening the top, it all works until it is time for the truck to close and then it doesn't.


What make ,model an year vehicle ? Could be a sensor or a control module . Some of these convertibles are very complex , could set DTC'S diagnostic trouble codes .
?€¢
The hydraulic lines and the cylinders


?€¢
GMLAN communication to the Body Control Module (BCM)


?€¢
Open/Close request circuit to the driver and passenger window motors


?€¢
Power and Grounds


-
Folding Top Main Power Fuse 30A


-
Folding Top Logic Power Fuse 20A


-
Ground G301 for the FTC module and G305


?€¢
Folding Top Open/Close Switch (S15 and S16)


?€¢
Rear Compartment Limit Switches


-
Rear Compartment Lid Release Switch (S3 and S4)


-
Rear Compartment Lid Release Switch-Front Hinge-Left (S11 and S12)


-
Rear Compartment Lid Release Switch-Front Hinge-Right (S9 and S10)


-
Folding Top Front Location Pin Guide-Left (S17 and S18)


-
Rear Compartment Lid Release Switch-Left (S19A)


-
Rear Compartment Lid Release Switch-Right (S19B)


-
Rear Compartment Partition Position Switch (S20)


-
Folding Top Front Location Pin Position Switch (S13)


-
Folding Top Front Latch Actuator Position Switch (S14)


?€¢
Hall Effect Sensors


-
Folding Top Header Latch Cylinder Sensor (S1)


-
Rear Compartment Cylinder Extended Sensor (S2)


DTC B367F 58: Roof Stowed Ready to Latch Sensor Circuit incorrect reaction after event

DTC B367F 59: Roof Stowed Ready to Latch Sensor Circuit circuit/component protection time out
DTC B367B 58: Deck Lid Anti-Rotation Latched Sensor Circuit incorrect reaction after event

DTC B367B 59: Deck Lid Anti-Rotation Latched Sensor Circuit circuit/component protection time out
Your best bet is probably to take your vehicle to a qualified repair shop.

May 23, 2016 | Cars & Trucks

2 Answers

Back window is stuck


First be sure the auto-lock is not on and that the entire liftgate can be opened.

Look for the small rubber button above and on the right side of the license plate. Try pushing that button to see if the rear window hatch pops.

If these efforts don't work, check the fuse associated with the "luggage compartment lid release switch"... it's a 20 amp fuse possibly located in slot 22.

A last resort would be removing the interior panel of the liftgate and locating the latch release for the hatch. You can find a schematic of the rear liftgate in an Internet search. Good luck!

May 03, 2015 | 2002 Ford Explorer

1 Answer

How does a manual top work on a 1998 BMW 323 I??


I believe you do this in this order. Roll windows down, release the latch at the top of the windshield, raise the front of the top, release rear cover by pulling the latch near the rear seat, Pull up the back of the top and then pull up on the rear cover. The back of the top should now fit into the opening under the rear cover. Continue to fold the top into this space. Push down on the rear cover to lock (won't be able to open trunk if not engaged.) To raise it, release rear latch cover, open rear cover and pull top out of opening. Raise rear of top so you are able to now close the rear cover, set rear of top down on cover and then pull fron of top down and engage the fraont latch. Hoe that helps.

Jan 23, 2013 | 1997 BMW 318

1 Answer

2000 Jimmy- 3 problems- 1. Heater just blows cold air 2. Can't get the hood latch to release even when pulled all the way with vigor 3. Rear window wiper stuck in upright position and won't respond to...


The no heat problem could be a stuck open thermostat, plugged heater core, the air mix/mode actuator, or the control module. You might be able to have someone push down on the hood while pulling the hood release to get the hood open, the latches often stick, or the release cable maybe stretched and not operating the latch enough to release it. The rear wiper motor is probably bad.

Oct 23, 2010 | GMC Jimmy Cars & Trucks

1 Answer

Rear window will not latch


This is a little difficult to explain, but I'll try. So please take that into consideration in the rating. If you look at the latch, it is probably closed/latched. Take a screwdriver and put it in there the upper latch would be if it had closed properly. As a surrogate for the latch. Put outward pressure on the latch at the same time you operate the back window release as you usually would to get it back in the open position. Your latch thinks it's closed, so use the screwdriver to release it back into the open position.

Feb 26, 2010 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

2002 Explorer rear liftage latch replacement


Liftgate Latch Remote Control Removal and Installation
  1. Remove the liftgate trim panel. For additional information, refer to Section 501-05.
  1. Remove the watershield.
  1. Disconnect the actuator electrical connectors.
    a0023946.gif
  1. Disconnect the liftgate window glass latch release cable.
    1. Release the cable conduit.
    1. Disconnect the cable.
    a0023921.gif
  1. Disconnect the liftgate latch release cable.
    1. Remove the cable conduit.
    1. Disconnect the cable.
    a0023919.gif
  1. Release the exterior liftgate release handle actuating rod.
    1. Open the clip.
    1. Release the rod.
    a0023942.gif
  1. Remove the bolts and the liftgate latch remote control.
    a0023922.gif
  1. To install, reverse the removal procedure.
    • Transfer parts as necessary.

Jun 01, 2009 | 2002 Ford Explorer

1 Answer

2001 Ford Escape Rear Hatch won't unlock


The liftgate consists of the following components:
  • liftgate door lock actuator
  • liftgate lock cylinder (if equipped)
  • liftgate window glass
  • liftgate window latch/ajar switch
  • liftgate window glass release handle
  • liftgate latch remote control which consists of the following component:
    • liftgate release handle
  • liftgate latch, which consist of the following component:
    • liftgate latch door ajar switch
Liftgate Latch Actuator Removal and Installation
  1. Remove the liftgate latch remote control. For additional information, refer to Liftgate Latch Remote Control in this section.
SECTION 501-14: Handles, Locks, Latches and Entry Systems 2001 Escape Workshop Manual
REMOVAL AND INSTALLATION Liftgate Latch Removal and Installation
  1. Remove the liftgate trim panel.
  1. Disconnect the liftgate ajar switch electrical connector.
  1. Disconnect the liftgate latch actuating rod.
    1. Open the clip.
    1. Disconnect the actuating rod.
  1. Remove and discard the liftgate latch bolts.
  1. Remove the liftgate latch.
  1. NOTE: Make sure the liftgate latch release rod is not preloading the latch. It should be clipped in a relaxed state with no slack.
    NOTE: Position the liftgate latch release rod by pushing outboard to remove the slack.
  1. Remove the screws and the liftgate latch actuator
90f640f.gif

May 29, 2009 | 2001 Ford Escape

1 Answer

Can't open tailgate and rear window


if you take off interior panel.....push out the dent with a bar....then try button if no work go back inside and you should see bars going down from handle to latch area...pull up on it and should pop the trunk

Dec 02, 2008 | 1995 Isuzu Rodeo

2 Answers

96 jeep Grand Cherokee tailgate will not open


This is kind of tricky. OK let's start, you have to crawl into the rear hatch area from the inside of the car. You'll have to pull the rear panel off the hatch, a screwdriver between the panel and hatch near the window will work. There might be 2 screws on the panel you could take out. The trick is to pull the panel far away enough to stick your arm down towards the latch and release it by hand. We did this at the dealer all the time.

Nov 19, 2008 | 1996 Jeep Grand Cherokee

3 Answers

2002 Jeep Liberty, rear window latch is ''locked'' & window is open


i was having the same type of problem. we just put a couple of washers behind the latch and then adjusted the latch and it solved our problem.

Nov 16, 2008 | 2002 Jeep Liberty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...