Question about 1998 Plymouth Breeze

1 Answer

98 breeze Just bought it and on the way home it started staling out there was a clicking noise and the rpm gauge jumped around all the way into the red line without the engine reving at all then it died. when looking at it on the side of the road from under there seemed to be a large oil leak from the engine and the dip stick barly touched oil way below the add line even though it was good when I left the dealership.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 40 Answers

No think about this for a min. noise coming from eng. large oil leak, eng. dies. do yourself a favor Breeze it back to the dealer. you might have blown you motor

Posted on Sep 12, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why did this happen all of a sudden, Overheating (maybe) and RPM Sensor Pointing down?


If the noise was coming from the cooling system, first try to replace the radiator or expansion bottle pressure cap. The RPM needle probably is unrelate to the cooling system problem.

May 06, 2014 | 2005 Chevrolet Impala LS

1 Answer

2000 plymouth breeze 2.4 jumped timing and now leaking antifreeze.


that would'nt make any difference to water pressure! may be possible that your vehicle was overheating! overheating caused excessive pressure in the system, which popped(The noise you heard) one of the hoses, or a connection!

Car stalled from over heating!

Apr 27, 2012 | 2000 Plymouth Breeze

1 Answer

1998 Olds Cutlass- My gauges were moving around very quickly when I turned the ignition. It won't start now and sounds like the battery is dead, but it's not. My gas gauge has spun around and sits under...


HiYour battery is not fully charged, jump start vehicle and take it to and AutoZone or similar auto parts store to have your charging/starting system checked for free.
On the gauges issue, you have to remove the instrument cluster and manually turn/reset the gas gauge. I have a 98 Olds Intrigue and happened a few times. I pull the gauge needle out and set it where it would be if the key where OFF, then plug the electrical connector on the cluster and turn the key to ON to verify gauge positions, on my case, I had to reset the temp. gauge too.
Good Luck! Don't forget to rate this post!!

Sep 22, 2010 | 1998 Oldsmobile Cutlass

1 Answer

My fuel gauge has spun all the way around and is stuck underneath the pin


This is not a solution..I just want to see if you had these symptoms..Mine did the same thing tonight(9-22-10, '98 Olds Cutlass) I went to the gas station..got back in the car to start it, and it sounded like the battery was dead (clicking when turning the ignition) and then all my gauges started moving around very quickly. The gas gauge went all the way around and is also stuck under then pin. I tried to jump it, but no luck. Did this happen to you and did you figure out how to fix it? Thanks.

Aug 23, 2010 | 1998 Oldsmobile Cutlass

1 Answer

2004 explorer dash gauges acting crazy


check and make sure all the fuses are in good but it sounds like a bad ground wire

Jan 16, 2009 | 2004 Ford Explorer

1 Answer

Speedometer pinned all the way around


i HAD THE SAME PROBLEM, TRY PUTING THE DEAD BATTERY BACK ON AND TRY TURNING IT OVER THE GAUGES MIGHT FLIP BACK AROUND

Jul 27, 2008 | 2002 Dodge Neon

1 Answer

I have a 2001 GMC Yukon. It was running fine until two days ago. I went to start it on Saturday and it would only make a clicking noise. I was able to start it with jumper cables. I drove for an hour...


i had the same exact problem with my chevy s-10, but once i replaced the battery it ran fine no problem, u may have fried some circuits and relays while jumping the car, and alot of times that clicking noise is your relay burning out, did your car start doing weird things too? like ejecting cd's, flashing lights really fast and weird noises?

Jul 21, 2008 | 2002 GMC Denali

1 Answer

2002 vw jetta tdi - problem with rpm gauge?


Hi, Did you notice the motor actually reving higher when the tachometer was reading a higher rpm.. If it was it could be your transmission slipping.. Set your cruise control and listen to your motor while the tachometer starts moving erratically.. Good Luck

Jun 30, 2008 | 2002 Volkswagen Jetta TDI

Not finding what you are looking for?
1998 Plymouth Breeze Logo

Related Topics:

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...