Question about Chrysler LeBaron

1 Answer

We are having problems with our starter and a friend of ours a couple of weeks ago got underneath the car and hammered the starter and it worked for a couple of days. We can't seem to remember where it is located so we can tap it again. The car won't start and we now it's the starter. Can you help?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Master
  • 514 Answers

When you get to that point that you have to hit at the starter will be a time when not even that is going to work you need a new stater. ok for know it looks like this and is underneath on transmission side and it looks something like this.
We are having problems with - usstr-2011.jpg

Posted on Sep 12, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Have a 1997 Land Rover discovery, it was working fine before it just wouldn't turn on the next morning any ideas? -180,000 miles Bought it 3 weeks ago Had just passed smog if it matters

Diesel or petrol? Either way, does the starter crank? If so, you probably have a fuel delivery problem. If not, check the battery also the starter solenoid - give the latter a good bash wit h a hammer to loosen any rust - quite common.
Put a meter across the battery terminals - if less than 12.5 volts or so, get an auto electrical to do a load test on the battery before replacing it

Apr 05, 2015 | Land Rover Cars & Trucks

1 Answer

I have a 93 Geo never had a problem with it until about 2 weeks ago and now it won't start with the key but will push start real easy

Check the starter wire, mine gets loose and gives me problems. Also may have a dead starter coil, try giving it a good hit with a hammer (to shake with inside up a little). Or. Take it off and have auto zone test the starter.

Nov 04, 2014 | Cars & Trucks

1 Answer

I put put my key in the ignition and turn it and my car does not make a sound. My car was good like a week ago and i haven't drove it in a few weeks Can you tell me the problem?

It don't do a Click sound ? A bad connection or Starter problem, take an hammer or a pipe and tap it on the starter and try it, it should work, if you need to do that everytime, replace starter !

Aug 10, 2010 | 1997 Plymouth Breeze

1 Answer

2006 Torrent driven without any problem this AM. Left home again drive to store. come out of store approx. 3 minutes later, car not start, just clicking sound. Was able to get a battery boost. car drove...

Sounds like the starter.If you can locate it,tap on it with a hammer 3 or 4 times and try to restart.It may take several tries but should eventually start because starters don't quite fail 100%,they just kind of get stuck.If you can't find the starter,call a couple of parts stores or a dealer,someone is always willing to tell you for free to attract your business.It should work and you need a new starter.I put in a used one a couple of years ago and no problems yet,but the decision is yours.Good luck! Greg

Aug 08, 2010 | 2006 Pontiac Torrent

2 Answers

2005 Dodge Durango v8

replace the batteries in the remote,reset alarm system, then try.

Jul 13, 2010 | 1999 Dodge Durango

1 Answer

Wont turn over

The starter is most likely the problem,tap on the starter lightly with a hammer while trying to start the engine,dont get run over doing this it will take two people,if the engine starts,the starter needs replacing.

Apr 25, 2010 | 1998 Jeep Wrangler

1 Answer

I have a 2003 chevy tahoe with about 150,000 miles. The engine light has been on for couple of months now, but I have had no problem. This morning, it won't start. The lights and radio comces on.

Have you ever replaced the starter? If not you should have it tested, GM's have common starter problems and your vehicle is in the age bracket for starter to go bad.The easy fix is to have someone turn the key like they were going to start it while you get underneath the truck and hit the starter with a hammer a few times while they are trying to start the vehicle. If the vehicle starts then you know you have a starter problem, if not, back to the drawing board.

Mar 20, 2010 | 2003 Chevrolet Tahoe

1 Answer

A few weeks ago i started my 84 S10. It normally starts fine. After i turned it off i tried to turn it back on and it wont do anything. everything works like the radio and everything. When i turn the key...

This sounds like you may have a starter issue. Have someone in the vehicle to try cranking and hold it in this position. You go underneath and attempt to tap the starter with a small hammer to see if it frees it up. If it does, replace your starter. Let me know if you need anything further.

Mar 03, 2010 | 1984 Chevrolet S-10

1 Answer

I have a 1994 ford crown victoria I tried to start it the starter turned over a couple of time then stopped like someone turned off a switch I turned on the headlights and tried to start it but nothing...

reach underneath and hit the starter housing a few times with a hammer,if it now works either replace the brushes in the starter which cost about $20.00 ,or replace the starter which costs about $90.00.(parts only for both estimates)

Nov 23, 2009 | 1994 Ford Crown Victoria

2 Answers

Starter operates intermitanly. for the last week the starter motor has a job to engage,i have to keep turning the ignition switch on and off until it engages.

Had same problem. Have to lift the car so you can crawl under the engine. Just to the rear of the engine from underneath you will find the main lead connected to the starter, remove the rubber cover and undo the nut and clean the connector and terminal with some emery paper and replace then smear some grease on. This worked a treat on my sedona

Oct 08, 2009 | 2004 Kia Sedona

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides